Double lens collimator solar feedback sensor and master slave configuration: Development of compact and low cost two axis solar tracking system for CPV applications

Solar Energy ◽  
2016 ◽  
Vol 137 ◽  
pp. 352-363 ◽  
Author(s):  
Muhammad Burhan ◽  
Seung Jin Oh ◽  
Kian Jon Ernest Chua ◽  
Kim Choon Ng
Keyword(s):  
Tracking System ◽  
Low Cost ◽  
Solar Tracking

scholarly journals Optimal design of the solar tracking system of parabolic trough concentrating collectors

2020 ◽  
Vol 15 (4) ◽  
pp. 613-619
Author(s):  
Li Kong ◽  
Yunpeng Zhang ◽  
Zhijian Lin ◽  
Zhongzhu Qiu ◽  
Chunying Li ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Solar Radiation ◽  
Tracking System ◽  
Low Cost ◽  
Parabolic Trough ◽  
The North ◽  
Tracking Mode ◽  
Solar Tracking ◽  
East West

Abstract The present work aimed to select the optimum solar tracking mode for parabolic trough concentrating collectors using numerical simulation. The current work involved: (1) the calculation of daily solar radiation on the Earth’s surface, (2) the comparison of annual direct solar radiation received under different tracking modes and (3) the determination of optimum tilt angle for the north-south tilt tracking mode. It was found that the order of solar radiation received in Shanghai under the available tracking modes was: dual-axis tracking > north-south Earth’s axis tracking > north-south tilt tracking (β = 15°) > north-south tilt tracking (β = 45) > north-south horizontal tracking > east-west horizontal tracking. Single-axis solar tracking modes feature simple structures and low cost. This study also found that the solar radiation received under the north-south tilt tracking mode was higher than that of the north-south Earth’s axis tracking mode in 7 out of 12 months. Therefore, the north-south tilt tracking mode was studied separately to determine the corresponding optimum tilt angles in Haikou, Lhasa, Shanghai, Beijing and Hohhot, respectively, which were shown as follows: 18.81°, 27.29°, 28.67°, 36.21° and 37.97°.

scholarly journals Efficient and Low-Cost Arduino based Solar Tracking System

2020 ◽  
Vol 745 ◽  
pp. 012016
Author(s):  
Sohaib R Awad ◽  
Mamoon A Al Jbaar ◽  
Mohammed A M Abdullah
Keyword(s):  
Tracking System ◽  
Low Cost ◽  
Solar Tracking

scholarly journals Desenvolvimento de um Protótipo Automatizado de Detecção e Focalização de Raios Solares com Hardware Livre

2020 ◽  
Author(s):  
Orlando Soares de Santana Filho ◽  
Carlos Henrique Mota Martins ◽  
Thiago Henrique Felix C. Ribeiro Conceição ◽  
Alex Vinicius dos Reis Freitas Silva ◽  
Adriano Honorato Braga ◽  
...  
Keyword(s):  
Solar Energy ◽  
Electromagnetic Radiation ◽  
Tracking System ◽  
Low Cost ◽  
Servo Motor ◽  
Solar Panels ◽  
Open Hardware ◽  
Solar Tracking ◽  
Arduino Uno ◽  
And Performance

Solar energy is a renewable and inexhaustible source, besidescausing damage to nature, being clean and sustainable.Transform the electromagnetic radiation emitted by the Sunelectrical energy are used solar panels. In order to improveefficiency and performance of this capture, a low-cost wasbuilt, a single-axis solar tracking system for photovoltaicpanels. The solution uses the automation Arduino UNO R3,open hardware, two photosensitive sensors LDR GL-5528, inaddition to a servo motor capable of moving the surface of aphotovoltaic plate according to the detection of the highestincidence of light. The circuit and its components wereprogrammed using the Arduino IDE software, version 1.8.11.As a result, it was possible to follow the movement of thesun, differing from a static panel, thus ensuring greater sunshineon the solar plate, as a result of this traceablecontrol prototype.

Design and Implementation of a Low-Cost Mini Heliostat Solar Tracking System in West Africa

2021 ◽  
pp. 193-204
Author(s):  
Marie Pascaline Sarr ◽  
Ababacar Thiam ◽  
Biram Dieng ◽  
El Hadji Ibrahima Cisse
Keyword(s):  
West Africa ◽  
Tracking System ◽  
Low Cost ◽  
Design And Implementation ◽  
Solar Tracking

scholarly journals Design and implementation of an automatically aligned solar tracking system

2019 ◽  
Vol 10 (4) ◽  
pp. 2055
Author(s):  
Anees Abu Sneineh ◽  
Wael A. Salah
Keyword(s):  
Closed Loop ◽  
Tracking System ◽  
Low Cost ◽  
Electrical Energy ◽  
Clean Energy ◽  
Design And Implementation ◽  
Solar Tracking ◽  
Photo Sensor ◽  
Wide Availability ◽  
Solar Tracker

This paper presents the design and implementation of a closed-loop solar tracker system. The demand for clean energy sources has increased along with the rising demand for electrical energy and the increasing amount of environment pollution triggered by fuel consumption. Among these sources, solar energy is considered the most feasible given its wide availability and easy operation in different environments. The main purpose of this study is to maximize the generated photovoltaic power and reduce CO<sub>2</sub> emissions by designing an efficient and low-cost solar tracking system. An aligned closed-loop solar tracker is designed and constructed to achieve the best accuracy. The proposed system shows more freedom in its movement to overcome the problems associated with the tilt of the frame-holder. A PIC microcontroller based on the Flowcode programming language is used, the position feedback is detected by using a photo-sensor, and the H-Bridge driver is used to control two DC motors. According to the experimental results, the proposed system shows significant improvements in efficiency compared with stationary solar tracking systems.

scholarly journals Design and Performance Evaluation of a Dual-Axis Solar Tracking System for Rural Applications

2019 ◽  
Vol 3 (1) ◽  
Author(s):  
Hachimenum Nyebuchi Amadi ◽  
Sebastian Gutierrez
Keyword(s):  
Rural Communities ◽  
Rural Community ◽  
Tracking System ◽  
Low Cost ◽  
Cost Effective ◽  
Pv Panel ◽  
Dc Motors ◽  
Solar Tracking ◽  
And Performance ◽  
Rural Dwellers

Most rural dwellers in developing countries do not have access to adequate and regular supply of energy and most of these estimated two billion people are poor with no sustainable means of livelihood and therefore rely on wood fuel for their cooking and heating needs. And due to lack of energy, including electricity, socio-economic development is either absent or at abysmally low level. To foster rural development and improved living conditions among this populace, there is need for a reliable, low cost and environmentally risk-free source of energy. This work designed, implemented and evaluated the performance of a dual axis solar tracking system (DATS) using light dependent resistor (LDR) sensors, direct current (DC) motors and microcontroller to make it capable of uninterruptible electricity supply for rural applications. Results of the experiment show that the proposed system is more cost-effective and produces 31.4 % more energy than the single axis tracking system (SATS) and 67.9 % more than the fixed PV panel system (FPPS). Owing to the unique design of the proposed tracking system, solar energy can be tracked and stored continuously so that there is adequate electricity for the consuming population at all times. Though tested on a rural community in Abia State, Nigeria, the proposed system can be adapted to rural communities anywhere in the world.  

scholarly journals Design PV Tracking System According to Efficiency in Function of Orientation

2018 ◽  
Author(s):  
José Ruelas ◽  
Benjamin Pusch ◽  
Flavio Muños ◽  
Juan Delfin ◽  
Francisco Javier Ochoa Estrella
Keyword(s):  
Design Methodology ◽  
Collection Efficiency ◽  
Tracking System ◽  
Low Cost ◽  
High Availability ◽  
Solar Tracking ◽  
Starting Point ◽  
Solar Tracker ◽  
Available Technology ◽  
And Control

This article proposes a new photovoltaic (PV) solar tracker design based on the advantage that installation latitude offers according to efficiency in function of orientation (EFO) of PVs. First, is described a methodology to let incorporate a low-precision, low-cost and high-availability solar tracking mechanism and control system. The design methodology considers the installation location (latitude and azimuth) as a starting point for establishing an adequate angular range of EFO, simultaneity the aspects of available technology and the knowledge accords to developer. Finally, the design technique is experimentally validated by the implementation of a solar tracker at latitude of 28&deg; longitude of 109&deg; and evaluates the efficiency on a specific day. According to result the feasibility of this type of solar tracker for latitudes close to or greater than 30&deg; is highlighted, given that this tracking system costs 30% less than traditional commercial systems as slew drive with its incorporation of lower-resolution azimuth tracking mechanisms. It also increases collection efficiency by 26%, just as continuous or time-based dual-axis solar trackers do, without the more complex controls and mechanisms of these designs.

Sign in / Sign up

Export Citation Format

Share Document