Volumetric receivers in Solar Thermal Power Plants with Central Receiver System technology: A review

Solar Energy ◽  
2011 ◽  
Vol 85 (5) ◽  
pp. 891-910 ◽  
Author(s):  
Antonio L. Ávila-Marín
Keyword(s):  
Power Plants ◽  
Thermal Power ◽  
Solar Thermal ◽  
Thermal Power Plants ◽  
System Technology ◽  
Solar Thermal Power ◽  
Central Receiver ◽  
Receiver System

Comparative System Performance Analysis of Direct Steam Generation Central Receiver Solar Thermal Power Plants in Megawatt Range

2014 ◽  
Vol 136 (1) ◽  
Author(s):  
Javier Sanz-Bermejo ◽  
Víctor Gallardo-Natividad ◽  
José Gonzalez-Aguilar ◽  
Manuel Romero
Keyword(s):  
Power Plants ◽  
Superheated Steam ◽  
Thermal Power ◽  
Solar Thermal ◽  
Saturated Steam ◽  
Thermal Power Plants ◽  
Steam Generation ◽  
Optical Efficiency ◽  
Solar Thermal Power ◽  
Central Receiver

This work proposes and analyses several integration schemes specially conceived for direct steam generation (DSG) in megawatt (MW) range central receiver solar thermal power plants. It is focused on the optical performance related to the heliostat field and the arrangement of receiver absorbers, and the management of steam within a Rankine cycle in the range between 40–160 bar and 400–550 °C at design point. The solar receiver is composed of one single element for saturated steam systems or two vertically aligned separated units, which correspond to the boiler and the superheater (dual-receiver concept), for superheated steam solar thermal power plants. From a fixed heliostat field obtained after layout optimization for the saturated steam solar plant the heliostat field is divided in two concentric circular trapezoids where each of them independently supplies the solar energy required by the boiler and the superheater for the different steam conditions. It has been observed that the arrangement locating the boiler above the superheater provides a slightly higher optical efficiency of the collector system, formed by the solar field and the receiver, compared with the reverse option with superheater above boiler. Besides, two-zone solar fields provide lower performances than the entire heliostat layout aiming at one absorber (saturation systems). Optical efficiency of two-zone solar fields decreases almost linearly with the increment of superheater heat demand. Concerning the whole solar collector, heliostat field plus receiver, the performance decreases with temperature and almost linearly with the steam pressure. For the intervals of steam pressure and temperature under analysis, solar collector of saturated steam plant achieves an optical efficiency 3.2% points higher than the superheated steam system at 40 bar and 400 °C, and the difference increases up to 9.3% points when compared with superheated system at 160 bar and 550 °C. On the other hand, superheated steam systems at 550 °C and pressure between 60 and 80 bar provide the highest overall efficiency, and it is 2.3% points higher than performance of a saturated steam solar plant at 69 bar. However, if saturated steam cycle integrates an intermediate reheat process, both would provide similar performances. Finally, it has been observed that central receiver systems (CRS) producing saturated steam and superheated steam at 500 °C operating at 40 bar provide similar performances.

scholarly journals Performance Analysis and Optimization of Central Receiver Solar Thermal Power Plants for Utility Scale Power Generation

2019 ◽  
Vol 12 (1) ◽  
pp. 127 ◽  
Author(s):  
Praveen R. P.
Keyword(s):  
Energy Storage ◽  
Performance Analysis ◽  
Thermal Energy ◽  
Power Plants ◽  
Thermal Power ◽  
Solar Thermal ◽  
Thermal Power Plants ◽  
Solar Thermal Power ◽  
Central Receiver ◽  
Plant Efficiency

The paper puts forth the design, performance analysis, and optimization of a 100 MWe central receiver solar thermal power plant with thermal energy storage capability, which can be utilized effectively to meet the renewable energy targets of the Kingdom of Saudi Arabia (KSA). In this paper, three representative sites in KSA are selected for analysis as these sites experience an annual average direct normal irradiance (DNI) of more than 5.5 kWh/m2/day. The optimization approach presented in this work aims to arrive at the best possible design parameters that suit a particular location in accordance with its DNI profile. From the analysis, an annual energy of 559.61 GWh can be generated in Yanbu with eight hours of thermal energy storage, 18.19% plant efficiency, and a capacity factor of 61.1%. The central receiver plant in Abha would be able to offer an annual energy of 536.31 GWh with the highest plant efficiency of 18.97% and a capacity factor of 60.7%. The performance of the proposed design in the two locations of Yanbu and Abha fares better when compared to the operational plant data of central receiver plant in Crescent Dunes. Based on the findings, the proposed 100 MWe central receiver Solar thermal power plants can be effectively implemented in KSA to meet the energy demands of the region.

Methodology for optimized operation strategies of solar thermal power plants with integrated heat storage

Solar Energy ◽  
2011 ◽  
Vol 85 (4) ◽  
pp. 653-659 ◽  
Author(s):  
Michael Wittmann ◽  
Markus Eck ◽  
Robert Pitz-Paal ◽  
Hans Müller-Steinhagen
Keyword(s):  
Power Plants ◽  
Heat Storage ◽  
Thermal Power ◽  
Solar Thermal ◽  
Thermal Power Plants ◽  
Solar Thermal Power
Sign in / Sign up

Export Citation Format

Share Document