Chemical kinetics of multi-component pyrotechnics and mechanistic deconvolution of variable activation energy

2019 ◽  
Vol 37 (3) ◽  
pp. 3193-3201 ◽  
Author(s):  
Anirudha Ambekar ◽  
Jack J. Yoh
Keyword(s):  
Activation Energy ◽  
Chemical Kinetics ◽  
Variable Activation Energy ◽  
Kinetics Of

Vulcanization of Elastomers. 23. The Chemical Kinetics of Vulcanization Reactions and The Physical Properties of The Vulcanizates. I

1960 ◽  
Vol 33 (2) ◽  
pp. 335-341
Author(s):  
Walter Scheele ◽  
Karl-Heinz Hillmer
Keyword(s):  
Activation Energy ◽  
Physical Properties ◽  
Chemical Kinetics ◽  
Kcal Mole ◽  
First Order ◽  
Equilibrium Swelling ◽  
Kinetics Of ◽  
Kinetics Of Vulcanization ◽  
Limiting Value ◽  
Good Agreement

Abstract As a complement to earlier investigations, and in order to examine more closely the connection between the chemical kinetics and the changes with vulcanization time of the physical properties in the case of vulcanization reactions, we used thiuram vulcanizations as an example, and concerned ourselves with the dependence of stress values (moduli) at different degrees of elongation and different vulcanization temperatures. We found: 1. Stress values attain a limiting value, dependent on the degree of elongation, but independent of the vulcanization temperature at constant elongation. 2. The rise in stress values with the vulcanization time is characterized by an initial delay, which, however, is practically nonexistent at higher temperatures. 3. The kinetics of the increase in stress values with vulcanization time are both qualitatively and quantitatively in accord with the dependence of the reciprocal equilibrium swelling on the vulcanization time; both processes, after a retardation, go according to the first order law and at the same rate. 4. From the temperature dependence of the rate constants of reciprocal equilibrium swelling, as well as of the increase in stress, an activation energy of 22 kcal/mole can be calculated, in good agreement with the activation energy of dithiocarbamate formation in thiuram vulcanizations.

THE CIS-TRANS ISOMERIZATION OF AZOBENZENE IN SOLUTION

1950 ◽  
Vol 28b (4) ◽  
pp. 140-155 ◽  
Author(s):  
C. A. Winkler ◽  
J. Halpern ◽  
G. W. Brady
Keyword(s):  
Activation Energy ◽  
Internal Pressure ◽  
Solvent Effect ◽  
Chemical Kinetics ◽  
Linear Relation ◽  
Mixed Solvents ◽  
Square Root ◽  
Polar Solvents ◽  
Trans Isomerization ◽  
Kinetics Of

Relations for the solvent effect on the rate of a unimolecular, nonionic reaction are derived, using existing theories of solutions and of chemical kinetics. The kinetics of the cis-trans isomerization of azobenzene were investigated in 16 pure solvents. A linear relation between the activation energy, E, and the square root of the internal pressure of the solvent, (P′S)1/2 was found, in agreement with the theory. Linear relations between log A and E, and between log k and (P′S)1/2 were also found, but the results for the reaction in highly polar solvents deviated significantly from these relations. The kinetics of the reaction in mixed solvents indicate that the azobenzene is preferentially surrounded by the component in which it is more readily soluble.

KINETICS OF THE CARBON NANOMATERIALS OXIDATION

2004 ◽  
Vol 03 (03) ◽  
pp. 355-369 ◽  
Author(s):  
D. N. BORISENKO ◽  
N. N. KOLESNIKOV ◽  
M. P. KULAKOV ◽  
V. V. KVEDER
Keyword(s):  
Activation Energy ◽  
Quantitative Analysis ◽  
Thermogravimetric Analysis ◽  
Chemical Kinetics ◽  
Carbon Nanomaterials ◽  
Synthetic Diamond ◽  
Atmospheric Oxygen ◽  
Chemical Activity ◽  
Heterogeneous Processes ◽  
Kinetics Of

The distinction of the chemical activity of carbon nanomaterials is examined on the basis of chemical kinetics of heterogeneous processes. The activation energy for the oxidation by atmospheric oxygen of MWCNT (190±2 kJ·mol-1), fullerene C 60 (162±2 kJ·mol-1), amorphous carbon (124±2 kJ·mol-1), and synthetic diamond (166±2 kJ·mol-1) is evaluated. The use of the thermogravimetric analysis as a method of composition quantitative analysis of carbon nanomaterials is discussed.

Effect of ionizing radiation on the kinetics of hydrogenation on the Ni-MgO mixed catalyst

1982 ◽  
Vol 47 (7) ◽  
pp. 1780-1786 ◽  
Author(s):  
Rostislav Kudláček ◽  
Jan Lokoč
Keyword(s):  
Experimental Data ◽  
Activation Energy ◽  
Liquid Phase ◽  
Ionizing Radiation ◽  
Oxide Catalyst ◽  
Absorbed Dose ◽  
Hydrogenation Rate ◽  
Solution Composition ◽  
Mixed Catalyst ◽  
Kinetics Of

The effect of gamma pre-irradiation of the mixed nickel-magnesium oxide catalyst on the kinetics of hydrogenation of maleic acid in the liquid phase has been studied. The changes of the hydrogenation rate are compared with the changes of the adsorbed amount of the acid and with the changes of the solution composition, activation energy, and absorbed dose of the ionizing radiation. From this comparison and from the interpretation of the experimental data it can be deduced that two types of centers can be distinguished on the surface of the catalyst under study, namely the sorption centres for the acid and hydrogen and the reaction centres.

On the use of Ozawa/Flynn/Wall method to determine aging activation energy for elastomers

2021 ◽  
pp. 009524432110203
Author(s):  
Sudhir Bafna
Keyword(s):  
Mechanical Properties ◽  
Activation Energy ◽  
Weight Loss ◽  
Oxygen Consumption ◽  
Dwell Time ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Degradation Mechanism ◽  
Kinetics Of ◽  
Wall Method

It is often necessary to assess the effect of aging at room temperature over years/decades for hardware containing elastomeric components such as oring seals or shock isolators. In order to determine this effect, accelerated oven aging at elevated temperatures is pursued. When doing so, it is vital that the degradation mechanism still be representative of that prevalent at room temperature. This places an upper limit on the elevated oven temperature, which in turn, increases the dwell time in the oven. As a result, the oven dwell time can run into months, if not years, something that is not realistically feasible due to resource/schedule constraints in industry. Measuring activation energy (Ea) of elastomer aging by test methods such as tensile strength or elongation, compression set, modulus, oxygen consumption, etc. is expensive and time consuming. Use of kinetics of weight loss by ThermoGravimetric Analysis (TGA) using the Ozawa/Flynn/Wall method per ASTM E1641 is an attractive option (especially due to the availability of commercial instrumentation with software to make the required measurements and calculations) and is widely used. There is no fundamental scientific reason why the kinetics of weight loss at elevated temperatures should correlate to the kinetics of loss of mechanical properties over years/decades at room temperature. Ea obtained by high temperature weight loss is almost always significantly higher than that obtained by measurements of mechanical properties or oxygen consumption over extended periods at much lower temperatures. In this paper, data on five different elastomer types (butyl, nitrile, EPDM, polychloroprene and fluorocarbon) are presented to prove that point. Thus, use of Ea determined by weight loss by TGA tends to give unrealistically high values, which in turn, will lead to incorrectly high predictions of storage life at room temperature.

scholarly journals Fluoride Leaching of Titanium from Ti-Bearing Electric Furnace Slag in [NH4+]-[F−] Solution

Metals ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 1176
Author(s):  
Fuqiang Zheng ◽  
Yufeng Guo ◽  
Feng Chen ◽  
Shuai Wang ◽  
Jinlai Zhang ◽  
...  
Keyword(s):  
Activation Energy ◽  
Electric Furnace ◽  
Kinetic Equations ◽  
Surface Chemical ◽  
Leaching Rate ◽  
Surface Chemical Reaction ◽  
Mechanism And Kinetics ◽  
Semi Empirical ◽  
Kinetics Of ◽  
Furnace Slag

The effects of F− concentration, leaching temperature, and time on the Ti leaching from Ti-bearing electric furnace slag (TEFS) by [NH4+]-[F−] solution leaching process was investigated to reveal the leaching mechanism and kinetics of titanium. The results indicated that the Ti leaching rate obviously increased with the increase of leaching temperature and F− concentration. The kinetic equation of Ti leaching was obtained, and the activation energy was 52.30 kJ/mol. The fitting results of kinetic equations and calculated values of activation energy both indicated that the leaching rate of TEFS was controlled by surface chemical reaction. The semi-empirical kinetics equation was consistent with the real experimental results, with a correlation coefficient (R2) of 0.996. The Ti leaching rate reached 92.83% after leaching at 90 °C for 20 min with F− concentration of 14 mol/L and [NH4+]/[F−] ratio of 0.4. The leaching rates of Si, Fe, V, Mn, and Cr were 94.03%, 7.24%, 5.36%, 4.54%, and 1.73%, respectively. The Ca, Mg, and Al elements were converted to (NH4)3AlF6 and CaMg2Al2F12 in the residue, which can transform into stable oxides and fluorides after pyro-hydrolyzing and calcinating.

scholarly journals A Study of the Impact of Graphite on the Kinetics of SPS in Nano- and Submicron WC-10%Co Powder Compositions

Ceramics ◽  
2021 ◽  
Vol 4 (2) ◽  
pp. 331-363
Author(s):  
Eugeniy Lantcev ◽  
Aleksey Nokhrin ◽  
Nataliya Malekhonova ◽  
Maksim Boldin ◽  
Vladimir Chuvil'deev ◽  
...  
Keyword(s):  
Activation Energy ◽  
Solid Phase ◽  
Continuous Heating ◽  
Diffusion Creep ◽  
Hard Alloys ◽  
Fine Grained ◽  
Plasma Sintering ◽  
Spark Plasma ◽  
The Impact ◽  
Kinetics Of

This study investigates the impact of carbon on the kinetics of the spark plasma sintering (SPS) of nano- and submicron powders WC-10wt.%Co. Carbon, in the form of graphite, was introduced into powders by mixing. The activation energy of solid-phase sintering was determined for the conditions of isothermal and continuous heating. It has been demonstrated that increasing the carbon content leads to a decrease in the fraction of η-phase particles and a shift of the shrinkage curve towards lower heating temperatures. It has been established that increasing the graphite content in nano- and submicron powders has no significant effect on the SPS activation energy for “mid-range” heating temperatures, QS(I). The value of QS(I) is close to the activation energy of grain-boundary diffusion in cobalt. It has been demonstrated that increasing the content of graphite leads to a significant decrease in the SPS activation energy, QS(II), for “higher-range” heating temperatures due to lower concentration of tungsten atoms in cobalt-based γ-phase. It has been established that the sintering kinetics of fine-grained WC-Co hard alloys is limited by the intensity of diffusion creep of cobalt (Coble creep).

Sign in / Sign up

Export Citation Format

Share Document