Direct numerical simulation of PRF70/air partially premixed combustion under IC engine conditions

2015 ◽  
Vol 35 (3) ◽  
pp. 2975-2982 ◽  
Author(s):  
F. Zhang ◽  
R. Yu ◽  
X.S. Bai
Keyword(s):  
Numerical Simulation ◽  
Direct Numerical Simulation ◽  
Premixed Combustion ◽  
Ic Engine ◽  
Partially Premixed Combustion ◽  
Partially Premixed

Numerical simulation of combustion and soot under partially premixed combustion of low-octane gasoline

Fuel ◽  
2018 ◽  
Vol 211 ◽  
pp. 420-431 ◽  
Author(s):  
Yanzhao An ◽  
Mohammed Jaasim ◽  
R. Vallinayagam ◽  
S. Vedharaj ◽  
Hong G. Im ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Premixed Combustion ◽  
Partially Premixed Combustion ◽  
Partially Premixed

Effects of porous media on partially premixed combustion and heat transfer in meso-scale burners fuelled with ethanol

Energy ◽  
2021 ◽  
pp. 120191
Author(s):  
Xinjian Chen ◽  
Junwei Li ◽  
Dan Zhao ◽  
Muhammad Tahir Rashid ◽  
Xinyuan Zhou ◽  
...  
Keyword(s):  
Heat Transfer ◽  
Porous Media ◽  
Premixed Combustion ◽  
Partially Premixed Combustion ◽  
Partially Premixed ◽  
Meso Scale

Effects of Different Type of Gasoline Fuels on Heavy Duty Partially Premixed Combustion

2009 ◽  
Vol 2 (2) ◽  
pp. 71-88 ◽  
Author(s):  
Vittorio Manente ◽  
Bengt Johansson ◽  
Per Tunestal ◽  
William Cannella
Keyword(s):  
Premixed Combustion ◽  
Heavy Duty ◽  
Partially Premixed Combustion ◽  
Partially Premixed

Characterization of Partially Premixed Combustion With Ethanol: EGR Sweeps, Low and Maximum Loads

2010 ◽  
Vol 132 (8) ◽  
Author(s):  
Vittorio Manente ◽  
Bengt Johansson ◽  
Pert Tunestal
Keyword(s):  
High Efficiency ◽  
Pressure Rise ◽  
Premixed Combustion ◽  
Maximum Pressure ◽  
Pressure Rise Rate ◽  
Start Of Injection ◽  
Partially Premixed Combustion ◽  
Rise Rate ◽  
Partially Premixed ◽  
Gas Recirculation

Exhaust gas recirculation (EGR) sweeps were performed on ethanol partially premixed combustion (PPC) to show different emission and efficiency trends as compared with diesel PPC. The sweeps showed that when the EGR rate is increased, the efficiency does not diminish, HC trace is flat, and CO is low even with 45% of EGR. NOx exponentially decreases by increasing EGR while soot levels are nearly zero throughout the sweep. The EGR sweeps underlined that at high EGR levels, the pressure rise rate is a concern. To overcome this problem and keep high efficiency and low emissions, a sweep in the timing of the pilot injection and pilot-main ratio was done at ∼16.5 bars gross IMEP. It was found that with a pilot-main ratio of 50:50, and by placing the pilot at −60 with 42% of EGR, NOx and soot are below EURO VI levels; the indicated efficiency is 47% and the maximum pressure rise rate is below 10 bar/CAD. Low load conditions were examined as well. It was found that by placing the start of injection at −35 top dead center, the efficiency is maximized, on the other hand, when the injection is at −25, the emissions are minimized, and the efficiency is only 1.64% lower than its optimum value. The idle test also showed that a certain amount of EGR is needed in order to minimize the pressure rise rate.

Sign in / Sign up

Export Citation Format

Share Document