The nature of species derived from [Pt(bipy)2]2+ in aqueous solution: X-ray structural, mass spectral, NMR, and computational studies

Polyhedron ◽  
2013 ◽  
Vol 64 ◽  
pp. 238-246 ◽  
Author(s):  
Germán Cavigliasso ◽  
Robert Stranger ◽  
Warrick K.C. Lo ◽  
James D. Crowley ◽  
Allan G. Blackman
Keyword(s):  
Aqueous Solution ◽  
Computational Studies ◽  
X Ray ◽  
Mass Spectral ◽  
Structural Mass

Structural Study of a new Compound Based on Acid 1,4-Cyclohexanedicarboxylic (1,4-CDC)

2010 ◽  
Vol 6 (1) ◽  
pp. 891-896
Author(s):  
Manel Halouani ◽  
M. Dammak ◽  
N. Audebrand ◽  
L. Ktari
Keyword(s):  
Aqueous Solution ◽  
Water Molecules ◽  
Carboxyl Group ◽  
X Ray Diffraction ◽  
Compound I ◽  
Unit Cell Parameters ◽  
Monoclinic System ◽  
X Ray ◽  
Cell Parameters ◽  
Cyclohexanedicarboxylic Acid

One nickel 1,4-cyclohexanedicarboxylate coordination polymers, Ni2 [(O10C6H4)(COO)2].2H2O  (I), was hydrothermally synthesized from an aqueous solution of Ni (NO3)2.6H2O, (1,4-CDC) (1,4-CDC = 1,4-cyclohexanedicarboxylic acid) and tetramethylammonium nitrate. Compound (I) crystallizes in the monoclinic system with the C2/m space group. The unit cell parameters are a = 20.1160 (16) Å, b = 9.9387 (10) Å, c = 6.3672 (6) Å, β = 97.007 (3) (°), V= 1263.5 (2) (Å3) and Dx= 1.751g/cm3. The refinement converged into R= 0.036 and RW = 0.092. The structure, determined by single crystal X-ray diffraction, consists of two nickel atoms Ni (1) and Ni (2). Lots of ways of which is surrounded by six oxygen atoms, a carboxyl group and two water molecules.

Heterogeneous Fenton Catalytic Removal of Organic Pollutant in Aqueous Solution by using Coal Gangue as a Catalyst

2019 ◽  
Vol 12 (4) ◽  
pp. 312-325
Author(s):  
Jiwei Zhang ◽  
Jingjing Xu ◽  
Shuaixia Liu ◽  
Baoxiang Gu ◽  
Feng Chen ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Hydrogen Peroxide ◽  
Hydroxyl Radical ◽  
Removal Rate ◽  
Organic Pollutant ◽  
Coal Gangue ◽  
Ion Leakage ◽  
Heterogeneous Fenton ◽  
Solution Ph ◽  
X Ray

Background: Coal gangue was used as a catalyst in heterogeneous Fenton process for the degradation of azo dye and phenol. The influencing factors, such as solution pH gangue concentration and hydrogen peroxide dosage were investigated, and the reaction mechanism between coal gangue and hydrogen peroxide was also discussed. Methods: Experimental results showed that coal gangue has the ability to activate hydrogen peroxide to degrade environmental pollutants in aqueous solution. Under optimal conditions, after 60 minutes of treatment, more than 90.57% of reactive red dye was removed, and the removal efficiency of Chemical Oxygen Demand (COD) up to 72.83%. Results: Both hydroxyl radical and superoxide radical anion participated in the degradation of organic pollutant but hydroxyl radical predominated. Stability tests for coal gangue were also carried out via the continuous degradation experiment and ion leakage analysis. After five times continuous degradation, dye removal rate decreased slightly and the leached Fe was still at very low level (2.24-3.02 mg L-1). The results of Scanning Electron Microscope (SEM), energy dispersive X-Ray Spectrometer (EDS) and X-Ray Powder Diffraction (XRD) indicated that coal gangue catalyst is stable after five times continuous reuse. Conclusion: The progress in this research suggested that coal gangue is a potential nature catalyst for the efficient degradation of organic pollutant in water and wastewater via the Fenton reaction.

Über den Mechanismus der Bildung von Polyanionen in wäßriger Lösung. Zum Bildungsmechanismus eines Polytetramolybdations [Mo4O144-]n / On the Mechanism of Formation of Polyanions in Aqueous Solution. Concerning the Mechanism of Formation of a Polytetramolybdate Ion [Mo4O144-]n

1976 ◽  
Vol 31 (6) ◽  
pp. 737-748 ◽  
Author(s):  
Karl-Heinz Tytko
Keyword(s):  
Aqueous Solution ◽  
Coordination Sphere ◽  
Analytical Formula ◽  
Reaction Pathways ◽  
Mechanism Of Formation ◽  
X Ray ◽  
Theoretical Considerations

Possible structures and the pertinent reaction pathways for the polymetalate ion present in a slightly soluble polymetalate having the analytical formula A2O · 2 MOs have been derived on the basis of theoretical considerations. Structure and kind of combination of the tetrameric units of one of the possibilities are in agreement with the results of X-ray structure analyses. First the previously proposed planar tetrametalate ion [M4O12(OH)4]4--is formed by stepwise aggregation according to an addition mechanism. This species undergoes a rearrangement of the coordination sphere of two of the M atoms and is then subject to a polycondensation resulting in a polytetrametalate chain, [M4O144-]n.

scholarly journals Removal of Phenol from Aqueous Solution Using Internal Microelectrolysis with Fe-Cu: Optimization and Application on Real Coking Wastewater

Processes ◽  
2021 ◽  
Vol 9 (4) ◽  
pp. 720
Author(s):  
Do Tra Huong ◽  
Nguyen Van Tu ◽  
Duong Thi Tu Anh ◽  
Nguyen Anh Tien ◽  
Tran Thi Kim Ngan ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Ph Value ◽  
Reaction Rate Constant ◽  
Phenol Concentration ◽  
Treated Wastewater ◽  
Coking Wastewater ◽  
X Ray ◽  
Chemical Plating ◽  
Internal Electrolysis ◽  
Phenol Decomposition

Fe-Cu materials were synthesized using the chemical plating method from Fe powder and CuSO4 5% solution and then characterized for surface morphology, composition and structure by scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS) and X-ray diffraction (XRD), respectively. The as-synthesized Fe-Cu material was used for removal of phenol from aqueous solution by internal microelectrolysis. The internal electrolysis-induced phenol decomposition was then studied with respect to various parameters such as pH, time, Fe-Cu material weight, phenol concentration and shaking speed. The optimal phenol decomposition (92.7%) was achieved under the conditions of (1) a pH value of phenol solution of 3, (2) 12 h of shaking at the speed of 200 rpm, (3) Fe-Cu material weight of 10 g/L, (4) initial phenol concentration of 100.98 mg/L and (5) at room temperature (25 ± 0.5 °C). The degradation of phenol using Fe-Cu materials obeyed the second-order apparent kinetics equation with a reaction rate constant of k of 0.009 h−1L mg−1. The optimal process was then tested against real coking wastewater samples, resulting in treated wastewater with favorable water indicators. Current findings justify the use of Fe-Cu materials in practical internal electrolysis processes.

scholarly journals Structural basis of the stereoselective formation of the spirooxindole ring in the biosynthesis of citrinadins

2021 ◽  
Vol 12 (1) ◽  
Author(s):  
Zhiwen Liu ◽  
Fanglong Zhao ◽  
Boyang Zhao ◽  
Jie Yang ◽  
Joseph Ferrara ◽  
...  
Keyword(s):  
High Resolution ◽  
Organic Synthesis ◽  
Indole Alkaloids ◽  
Site Directed Mutagenesis ◽  
Structural Basis ◽  
Directed Mutagenesis ◽  
Computational Studies ◽  
X Ray ◽  
Evolutionary Branch ◽  
Catalytic Mechanisms

AbstractPrenylated indole alkaloids featuring spirooxindole rings possess a 3R or 3S carbon stereocenter, which determines the bioactivities of these compounds. Despite the stereoselective advantages of spirooxindole biosynthesis compared with those of organic synthesis, the biocatalytic mechanism for controlling the 3R or 3S-spirooxindole formation has been elusive. Here, we report an oxygenase/semipinacolase CtdE that specifies the 3S-spirooxindole construction in the biosynthesis of 21R-citrinadin A. High-resolution X-ray crystal structures of CtdE with the substrate and cofactor, together with site-directed mutagenesis and computational studies, illustrate the catalytic mechanisms for the possible β-face epoxidation followed by a regioselective collapse of the epoxide intermediate, which triggers semipinacol rearrangement to form the 3S-spirooxindole. Comparing CtdE with PhqK, which catalyzes the formation of the 3R-spirooxindole, we reveal an evolutionary branch of CtdE in specific 3S spirocyclization. Our study provides deeper insights into the stereoselective catalytic machinery, which is important for the biocatalysis design to synthesize spirooxindole pharmaceuticals.

scholarly journals Leaching Titaniferous Magnetite Concentrate by Alkaline Aqueous Solution

2021 ◽  
Author(s):  
Ke Guo ◽  
Shaoyan Wang ◽  
Renfeng Song ◽  
Zhiqiang Zhang
Keyword(s):  
Aqueous Solution ◽  
Alkali Concentration ◽  
Water Usage ◽  
X Ray Diffraction ◽  
High Concentration ◽  
X Ray ◽  
Iron Concentrate ◽  
Titaniferous Magnetite ◽  
Magnetite Concentrate ◽  
Kinetics Of

AbstractLeaching titaniferous magnetite concentrate with alkali solution of high concentration under high temperature and high pressure was utilized to improve the grade of iron in iron concentrate and the grade of TiO2 in titanium tailings. The titaniferous magnetite concentrate in use contained 12.67% TiO2 and 54.01% Fe. The thermodynamics of the possible reactions and the kinetics of leaching process were analyzed. It was found that decomposing FeTiO3 with NaOH aqueous solution could be carried out spontaneously and the reaction rate was mainly controlled by internal diffusion. The effects of water usage, alkali concentration, reaction time, and temperature on the leaching procedure were inspected, and the products were characterized by X-ray diffraction, scanning electron microscope, and energy dispersive spectroscopy, respectively. After NaOH leaching and magnetic separation, the concentrate, with Fe purity of 65.98% and Fe recovery of 82.46%, and the tailings, with TiO2 purity of 32.09% and TiO2 recovery of 80.79%, were obtained, respectively.

Sign in / Sign up

Export Citation Format

Share Document