Turbulent mixing of clouds with the environment: Small scale two phase evaporating flow investigated in a laboratory by particle image velocimetry

2012 ◽  
Vol 241 (3) ◽  
pp. 288-296 ◽  
Author(s):  
Piotr M. Korczyk ◽  
Tomasz A. Kowalewski ◽  
Szymon P. Malinowski
Keyword(s):  
Particle Image Velocimetry ◽  
Turbulent Mixing ◽  
Particle Image ◽  
Small Scale ◽  
Two Phase ◽  
Image Velocimetry

Abstract 14952: Volumetric Echocardiographic Particle Image Velocimetry (V-Echo-PIV)

Circulation ◽  
2014 ◽  
Vol 130 (suppl_2) ◽  
Author(s):  
Ahmad Falahatpisheh ◽  
Arash Kheradvar
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Contrast Echocardiography ◽  
Ultrasound Contrast Agent ◽  
Three Dimensions ◽  
Small Scale ◽  
High Temporal Resolution ◽  
Two Dimensional ◽  
Particle Image Velocimetry Technique ◽  
Image Velocimetry

Introduction: The two-dimensional (2D) echocardiographic particle image velocimetry technique that was introduced in 2010 received much attention in clinical cardiology. Cardiac flow visualization based on contrast echocardiography results in images with high temporal resolution that are obtainable at relatively low cost. This makes it an ideal diagnostic and follow-up tool for routine clinical use. However, cardiac flow in a cardiac cycle is multidirectional with a tendency to spin in three dimensions rather than two-dimensional curl. Here, for the first time, we introduce a volumetric echocardiographic particle image velocimetry technique that robustly acquires the flow in three spatial dimensions and in time: Volumetric Echocardiographic Particle Image Velocimetry (V-Echo-PIV). Methods: V-Echo-PIV technique utilizes matrix array 3D ultrasound probes to capture the flow seeded with an ultrasound contrast agent (Definity). For this feasibility study, we used a pulse duplicator with a silicone ventricular sac along with bioprosthetic heart valves at the inlet and outlet. GE Vivid E9 system with an Active Matrix 4D Volume Phased Array probe at 30 Hz was used to capture the flow data (Figure 1). Results: The 3D particle field was obtained with excellent spatial resolution without significant noise (Figure 1). 3D velocity field was successfully captured for multiple cardiac cycles. Flow features are shown in Figure 2 where the velocity vectors in two selected slices and some streamlines in 3D space are depicted. Conclusions: We report successful completion of the feasibility studies for volumetric echocardiographic PIV in an LV phantom. The small-scale features of flow in the LV phantom were revealed by this technique. Validation and human studies are currently in progress.

scholarly journals Experiments on wave propagation in grease ice: combined wave gauges and particle image velocimetry measurements

2019 ◽  
Vol 864 ◽  
pp. 876-898 ◽  
Author(s):  
Jean Rabault ◽  
Graig Sutherland ◽  
Atle Jensen ◽  
Kai H. Christensen ◽  
Aleksey Marchenko
Keyword(s):  
Wave Propagation ◽  
Particle Image Velocimetry ◽  
Particle Image ◽  
Wave Attenuation ◽  
Laboratory Data ◽  
Decomposition Analysis ◽  
Small Scale ◽  
Wave Tank ◽  
Wave Elevation ◽  
Image Velocimetry

Water wave attenuation by grease ice is a key mechanism for the polar regions, as waves in ice influence many phenomena such as ice drift, ice breaking and ice formation. However, the models presented so far in the literature are limited in a number of regards, and more insights are required from either laboratory experiments or fieldwork for these models to be validated and improved. Unfortunately, performing detailed measurements of wave propagation in grease ice, either in the field or in the laboratory, is challenging. As a consequence, laboratory data are relatively scarce, and often consist of only a couple of wave elevation measurements along the length of the wave tank. We present combined measurements of wave elevation using an array of ultrasonic probes, and water kinematics using particle image velocimetry (PIV), in a small-scale wave tank experiment. Experiments are performed over a wider frequency range than has been previously investigated. The wave elevation measurements are used to compute the wavenumber and exponential damping coefficient. In contrast to a previous study in grease ice, we find that the wavenumber is consistent with the mass loading model, i.e. it increases compared with the open water case. Wave attenuation is compared with a series of one-layer models, and we show that they satisfactorily describe the viscous damping occurring. PIV data are also consistent with exponential wave amplitude attenuation, and a proper orthogonal decomposition analysis reveals the existence of mean flows under the ice that are a consequence of the displacement and packing of the ice induced by the gradient in the wave-induced stress. Finally, we show that the dynamics of grease ice can generate eddy structures that inject eddy viscosity into the water under the grease ice, which would lead to enhanced mixing and participating in energy dissipation.

Different Modes of Gas Entrainment Through Bottom Discharge Branch by Using Three Dimensional Particle Image Velocimetry System

2007 ◽  
Author(s):  
Wael Fairouz Saleh ◽  
Ibrahim Galal Hassan
Keyword(s):  
Particle Image Velocimetry ◽  
Flow Structure ◽  
Particle Image ◽  
Three Dimensional ◽  
Industrial Applications ◽  
Particle Image Velocimetry System ◽  
Three Dimension ◽  
Two Phase ◽  
Mean Velocity ◽  
Image Velocimetry

The discharge of two-phase flow from a stratified region through single or multiple branches is an important process in many industrial applications including the pumping of fluid from storage tanks, shell-and-tube heat exchangers, and the fluid flow through small breaks in cooling channels of nuclear reactors during loss-of-coolant accidents (LOCA). Knowledge of the flow phenomena involved along with the quality and mass flow rate of the discharging stream(s) is necessary to adequately predict the different phenomena associated with the process. Particle Image Velocimetry (PIV) in three dimension was used to provide detailed measurements of the flow patterns involving distributions of mean velocity, vorticity field, and flow structure. The experimental investigation was carried out to simulate two phase discharge from a stratified region through branches located on a semi-circular wall configuration during LOCA scenarios. The semi-circular test section is in close dimensional resemblance with that of a CANDU header-feeder system, with branches mounted at orientation angles of zero, 45 and 90 degrees from the horizontal. The experimental data for the phase development (mean velocity, flow structure, etc.) was done during single discharge through the bottom branch from an air/water stratified region over a three selected Froude numbers. These measurements were used to describe the effect of outlet flow conditions on phase redistribution in headers and understand the entrainment phenomena.

Wave-in-Deck Impact Loads in Relation With Wave Kinematics

2017 ◽  
Author(s):  
Jule Scharnke ◽  
Rene Lindeboom ◽  
Bulent Duz
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Impact Load ◽  
Breaking Waves ◽  
Offshore Structures ◽  
Small Scale ◽  
Impact Loads ◽  
Piv Measurements ◽  
Wave Kinematics ◽  
Image Velocimetry

Breaking waves have been studied for many decades and are still of interest as these waves contribute significantly to the dynamics and loading of offshore structures. In current MARIN research this awareness has led to the setup of an experiment to determine the kinematics of breaking waves using Particle Image Velocimetry (PIV). The purpose of the measurement campaign is to determine the evolution of the kinematics of breaking focussed waves. In addition to the PIV measurements in waves, small scale wave-in-deck impact load measurements on a fixed deck box were carried out in the same wave conditions. To investigate the link between wave kinematics and wave-in-deck impact loads, simplified loading models for estimating horizontal deck impact loads were applied and compared to the measured impact loads. In this paper, the comparison of the model test data to estimated loads is presented.

Numerical Simulation of Dynamic Process under Low Pressure Casting Based on Two Phase Flow

2015 ◽  
Vol 727-728 ◽  
pp. 358-361
Author(s):  
Shan Guang Liu ◽  
Fu Yang Cao ◽  
Xin Yi Zhao ◽  
Yan Dong Jia ◽  
Zhi Liang Ning ◽  
...  
Keyword(s):  
Numerical Simulation ◽  
Particle Image Velocimetry ◽  
Particle Image ◽  
Mold Filling ◽  
Phase Flow ◽  
Pressure Casting ◽  
Filling Process ◽  
Two Phase ◽  
Image Velocimetry ◽  
Low Pressure Casting

It has been proved that the mold filling under low pressure casting can be described by the second order nonlinear differential equations characterized by damping oscillations. To obtain higher accuracy of the velocity field, the mold filling process with damping oscillations should be considered. A computational model taking the liquid level droping in the crucible into account based on two phase flow for filling process of damping oscillations is presented in this paper. Hydraulic simulation with the particle image velocimetry was adopted to verify the numerical simulation result. It is proved that the nemuerical simulation results used the presented model perfecly match with the particle image velocimetry results. Liquid level droping in crucible is the main reason for damping oscillations in mold filling. Velocity oscilations can be eliminated when the melt flow across a sudden expansion section. The detailed flow field based on the presented model can provide guidance to optimize the process parameters.

Application of Particle Image Velocimetry to a Small-Scale de Laval Nozzle

AIAA Journal ◽  
1999 ◽  
Vol 37 (7) ◽  
pp. 798-804 ◽  
Author(s):  
N. J. Lawson ◽  
G. J. Page ◽  
N. A. Halliwell ◽  
J. M. Coupland
Keyword(s):  
Particle Image Velocimetry ◽  
Laval Nozzle ◽  
Particle Image ◽  
Small Scale ◽  
Image Velocimetry ◽  
De Laval Nozzle
Sign in / Sign up

Export Citation Format

Share Document