Investigation of the annealing temperature effect on structural, morphology, dielectric and magnetic properties of BiFeO3 nanoparticles

2018 ◽  
Vol 549 ◽  
pp. 73-76 ◽  
Author(s):  
M. Ranjbar ◽  
M.E. Ghazi ◽  
M. Izadifard
Keyword(s):  
Magnetic Properties ◽  
Temperature Effect ◽  
Annealing Temperature ◽  
Structural Morphology ◽  
Bifeo3 Nanoparticles

Effect of Annealing temperature on the Structural and Magnetic Properties of TbxY3-xFe5O12(x = 0.0, 1.0, 2.0) Thin Films Prepared by Sol-Gel Process

2012 ◽  
Vol 501 ◽  
pp. 236-241 ◽  
Author(s):  
Ftema W. Aldbea ◽  
Noor Bahyah Ibrahim ◽  
Mustafa Hj. Abdullah ◽  
Ramadan E. Shaiboub
Keyword(s):  
Thin Films ◽  
Magnetic Properties ◽  
Room Temperature ◽  
Annealing Temperature ◽  
Sol Gel ◽  
Vibrating Sample Magnetometer ◽  
X Ray ◽  
Garnet Phase ◽  
Sol Gel Process ◽  
Amorphous Structures

Thin films nanoparticles TbxY3-xFe5O12 (x=0.0, 1.0, 2.0) were prepared by the sol-gel process followed by annealing process at various annealing temperatures of 700° C, 800° C and 900° C in air for 2 h. The results obtained from X-ray diffractometer (XRD) show that the films annealed below 900°C exhibit peaks of garnet mixed with small amounts of YFeO3 and Fe2O3. Pure garnet phase has been detected in the films annealed at 900°C. Before annealing the films show amorphous structures. The particles sizes measurement using the field emission scanning electron microscope (FE-SEM) showed that the particles sizes increased as the annealing temperature increased. The magnetic properties were measured at room temperature using the vibrating sample magnetometer (VSM). The saturation magnetization (Ms) of the films also increased with the annealing temperature. However, different behavior of coercivity (Hc) has been observed as the annealing temperature was increased.

scholarly journals Influence of Cu on the Improvement of Magnetic Properties and Structure of L10 FePt Nanoparticles

Nanomaterials ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 1097
Author(s):  
Luran Zhang ◽  
Xinchen Du ◽  
Hongjie Lu ◽  
Dandan Gao ◽  
Huan Liu ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Annealing Temperature ◽  
Reduction Method ◽  
Solid Phase ◽  
Average Particle Size ◽  
Fept Nanoparticles ◽  
Average Particle ◽  
Phase Reduction ◽  
Different Temperatures ◽  
One Step

L10 ordered FePt and FePtCu nanoparticles (NPs) with a good dispersion were successfully fabricated by a simple, green, one-step solid-phase reduction method. Fe (acac)3, Pt (acac)2, and CuO as the precursors were dispersed in NaCl and annealed at different temperatures with an H2-containing atmosphere. As the annealing temperature increased, the chemical order parameter (S), average particle size (D), coercivity (Hc), and saturation magnetization (Ms) of FePt and FePtCu NPs increased and the size distribution range of the particles became wider. The ordered degree, D, Hc, and Ms of FePt NPs were greatly improved by adding 5% Cu. The highest S, D, Hc, and Ms were obtained when FePtCu NPs annealed at 750 °C, which were 0.91, 4.87 nm, 12,200 Oe, and 23.38 emu/g, respectively. The structure and magnetic properties of FePt and FePtCu NPs at different annealing temperatures were investigated and the formation mechanism of FePt and FePtCu NPs were discussed in detail.

Elaboration and Characterization of Mg-Doped ZnO Thin Films by Thermal Evaporation: Annealing Temperature Effect

2021 ◽  
Author(s):  
Fouaz Lekoui ◽  
Salim Hassani ◽  
Mohammed Ouchabane ◽  
Hocine Akkari ◽  
Driss Dergham ◽  
...  
Keyword(s):  
Thin Films ◽  
Temperature Effect ◽  
Annealing Temperature ◽  
Thermal Evaporation ◽  
Zno Thin Films ◽  
Doped Zno ◽  
Mg Doped

Annealing Effects on the Physical and Magnetic Properties of Tb1.5Y1.5Fe5O12 Films Nanoparticles Prepared by Sol-Gel Method

2013 ◽  
Vol 756 ◽  
pp. 91-98 ◽  
Author(s):  
Ftema W. Aldbea ◽  
Noor Bahyah Ibrahim ◽  
Mustafa Hj. Abdullah
Keyword(s):  
Particle Size ◽  
Magnetic Properties ◽  
Annealing Temperature ◽  
Quartz Substrate ◽  
Sol Gel ◽  
Lattice Parameter ◽  
Gel Method ◽  
X Ray ◽  
Sol Gel Method ◽  
Iron Garnet

Terbium –substituted yttrium iron garnet (Tb1.5Y1.5Fe5O12) films nanoparticles were successfully prepared by a sol-gel method. The films were deposited on the quartz substrate using spin coating technique. To study effect of annealing temperature, the annealing process was executed at 700, 800 and 900 °C in air for 2 hours. The X-ray diffraction (XRD) proved that the pure phase of garnet structure was detected for the film annealed at 900 °C. The lattice parameter increased with the increment of annealing temperature and the highest value of 12.35 Å was obtained at 900 °C. Field Emission Scanning Electron Microscope (FE-SEM) results showed that the particle size increased from 43nm to 56nm as annealing temperature increased from 700 to 900°C. The film’s thickness also affected by increasing of annealing temperature and become thin at 900 °C due to densification process occurred at high annealing temperature. The elemental compositions of the Tb1.5Y1.5Fe5O12 film were detected using an Energy Dispersive X-raySpectroscopy (EDX). Magnetic properties at room temperature were measured using a Vibrating Sample Magnetometer (VSM).The saturation magnetization Ms increased with the annealingtemperature and showed a high value of 104emu/cm3, but the coercivity Hc of the film was decreased due to the increment of the particle size. Normal 0 21 false false false MS X-NONE X-NONE MicrosoftInternetExplorer4 Terbium –substituted yttrium iron garnet (Tb1.5Y1.5Fe5O12) films nanoparticles were successfully prepared by a sol-gel method. The films were deposited on the quartz substrate using spin coating technique. To study effect of annealing temperature, the annealing process was executed at 700, 800 and 900°C in air for 2 hours. The X-ray diffraction (XRD) proved that the pure phase of garnet structure was detected for the film annealed at 900 °C. The lattice parameter increased with the increment of annealing temperature and the highest value of 12.35 Å was obtained at 900 °C. Field Emission Scanning Electron Microscope (FE-SEM) results showed that the particle size increased from 43nm to 56nm as annealing temperature increased from 700 to 900 °C. The film’s thickness also affected by increasing of annealing temperature and become thin at 900 °C due to densification process occurred at high annealing temperature. The elemental compositions of the Tb1.5Y1.5Fe5O12 film were detected using an Energy Dispersive X-ray Spectroscopy (EDX). Magnetic properties at room temperature were measured using a Vibrating Sample Magnetometer (VSM).The saturation magnetization Ms increased with the annealing temperature and showed a high value of 104emu/cm3, but the coercivity Hc of the film was decreased due to the increment of the particle size. st1\:*{behavior:url(#ieooui) } /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-priority:99; mso-style-qformat:yes; mso-style-parent:""; mso-padding-alt:0cm 5.4pt 0cm 5.4pt; mso-para-margin:0cm; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:11.0pt; font-family:"Calibri","sans-serif"; mso-ascii-font-family:Calibri; mso-ascii-theme-font:minor-latin; mso-fareast-font-family:"Times New Roman"; mso-fareast-theme-font:minor-fareast; mso-hansi-font-family:Calibri; mso-hansi-theme-font:minor-latin; mso-bidi-font-family:"Times New Roman"; mso-bidi-theme-font:minor-bidi;}

Structural, morphological and magnetic properties of Sr0,54Ca0,46Fe6,5Al5,5O19 M-type hexaferrites: Effects of annealing temperature

2021 ◽  
pp. 114453
Author(s):  
S. Elkhouad ◽  
Z. Yamkane ◽  
J. Louafi ◽  
M. Moutataouia ◽  
L.H. Omari ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Annealing Temperature

scholarly journals Structural and Magnetic Properties of Ni81Fe19Thin Film Grown on Si(001) Substrate via Single Graphene Layer

2015 ◽  
Vol 2015 ◽  
pp. 1-5 ◽  
Author(s):  
Gui-fang Li ◽  
Shibin Liu ◽  
Shanglin Yang ◽  
Yongqian Du
Keyword(s):  
Thin Films ◽  
Magnetic Properties ◽  
Vapor Deposition ◽  
Graphene Layer ◽  
Structural Investigation ◽  
Annealing Temperature ◽  
Chemical Vapor ◽  
Magnetic Thin Films ◽  
Structural And Magnetic Properties

We prepared magnetic thin films Ni81Fe19on single-crystal Si(001) substrates via single graphene layer through magnetron sputtering for Ni81Fe19and chemical vapor deposition for graphene. Structural investigation showed that crystal quality of Ni81Fe19thin films was significantly improved with insertion of graphene layer compared with that directly grown on Si(001) substrate. Furthermore, saturation magnetization of Ni81Fe19/graphene/Si(001) heterostructure increased to 477 emu/cm3with annealing temperatureTa=400°C, which is much higher than values of Ni81Fe19/Si(001) heterostructures withTaranging from 200°C to 400°C.

Sign in / Sign up

Export Citation Format

Share Document