Optimization of process parameters in electric discharge Machining D3 steel using Grey Relational Analysis

2020 ◽  
Author(s):  
S.V. Kajendirakumar ◽  
G. Sathish Kumar ◽  
P. Parameswaran ◽  
B. SureshKumar
Keyword(s):  
Process Parameters ◽  
Electric Discharge ◽  
Grey Relational Analysis ◽  
Electric Discharge Machining ◽  
Relational Analysis ◽  
Optimization Of Process Parameters ◽  
Grey Relational

Multi-objective optimization of micro wire electric discharge machining parameters using grey relational analysis with Taguchi method

2011 ◽  
Vol 225 (7) ◽  
pp. 1742-1753 ◽  
Author(s):  
K P Somashekhar ◽  
J Mathew ◽  
N Ramachandran
Keyword(s):  
Analysis Of Variance ◽  
Process Parameters ◽  
Electric Discharge ◽  
Grey Relational Analysis ◽  
Performance Characteristics ◽  
Electric Discharge Machining ◽  
Relational Analysis ◽  
Wire Electric Discharge Machining ◽  
Grey Relational ◽  
Wedm Process

Micro wire electric discharge machining (µ-WEDM) is an evolution of conventional wire EDM used for fabricating three-dimensional complex microcomponents, microstructures, and intricate profiles effectively with high-precision capabilities. Being a complex process, it is very difficult to determine optimal parameters for obtaining higher material removal rate (MRR) with minimum overcut (OC), and surface roughness (SR) is a challenging task in µ-WEDM for improving performance characteristics. In this study, a new approach for the optimization of the µ-WEDM process with multiple performance characteristics based on the statistical-based analysis of variance (ANOVA) and grey relational analysis (GRA) is attempted. Analysis of variance was used to study the significance of process parameters on grey relational grade (GRG) which showed capacitance to be the most significant factor. A GRG obtained from the GRA is used to optimize the µ-WEDM process. Optimum process parameters are determined by the GRG as the overall performance index. The process parameters, namely gap voltage, capacitance, and feed rate are optimized by considering multiple performance characteristics including MRR, OC, and SR. To validate the study, confirmation experiment has been carried out at optimal set of parameters, and predicted results have been found to be in good agreement with experimental findings. This approach showed improved machining performance in the µ-WEDM process.

Sign in / Sign up

Export Citation Format

Share Document