Photocatalytic activity and stability of TiO2 and WO3 thin films

2012 ◽  
Vol 70 ◽  
pp. 68-73 ◽  
Author(s):  
Radu Adrian Carcel ◽  
Luminita Andronic ◽  
Anca Duta
Keyword(s):  
Thin Films ◽  
Photocatalytic Activity ◽  
Wo3 Thin Films

scholarly journals Highly enhanced photocatalytic activity of WO3 thin films loaded with Pt–Ag bimetallic alloy nanoparticles

RSC Advances ◽  
2017 ◽  
Vol 7 (2) ◽  
pp. 947-956 ◽  
Author(s):  
Pengyu Dong ◽  
Bairen Yang ◽  
Chao Liu ◽  
Fenghua Xu ◽  
Xinguo Xi ◽  
...  
Keyword(s):  
Thin Films ◽  
Photocatalytic Activity ◽  
Alloy Nanoparticles ◽  
Bimetallic Alloy ◽  
Novel Approach ◽  
Wo3 Thin Films

This study provides a novel approach to design efficient WO3 photocatalysts decorated by bimetallic Pt–Ag alloy nanoparticles.

scholarly journals Enhanced Visible Light Active WO3 Thin Films Toward Air Purification: Effect of the Synthesis Conditions

Materials ◽  
2020 ◽  
Vol 13 (16) ◽  
pp. 3506
Author(s):  
Anna Pancielejko ◽  
Marta Rzepnikowska ◽  
Adriana Zaleska-Medynska ◽  
Justyna Łuczak ◽  
Paweł Mazierski
Keyword(s):  
Thin Films ◽  
Photocatalytic Activity ◽  
Air Pollutant ◽  
Air Purification ◽  
Photocurrent Response ◽  
Ambient Conditions ◽  
Photocatalytic Ability ◽  
Synthesis Conditions ◽  
Electrochemical Approach ◽  
Wo3 Thin Films

Taking our current environmental situation in the world into consideration, people should face growing problems of air and water pollution. Heterogeneous photocatalysis is a highly promising tool to improve both air and water quality through decomposition/mineralization of contaminants directly into harmless CO2 and H2O under ambient conditions. In this contribution, we focused on the synthesis of self-assembly WO3 thin films via an electrochemical approach in the aqueous electrolyte containing fluoride ions toward air purification. The effect of preparation conditions such as applied potential (10–50 V), anodization time (15–120 min), concentration of H2SO4 (0.5–1.5 M) and NaF (0.1–1.0 wt.%) on the morphology, photocurrent response, and photocatalytic activity addressed to removal of air pollutant in the presence of as-prepared WO3 samples were thoroughly examined and presented. The results revealed the growth of nanoplatelets and their gradual transformation into flower-like structures. The oxide layers and platelet thickness of the WO3 samples were found to be proportionally related with the synthesis conditions. The photocatalytic ability toward air purification was evaluated by degradation of toluene from air mixture using low-powered LEDs as an irradiation source (λmax = 415 nm). The highest photoactivity was achieved in presence of the sample which possessed a well-ordered, regular shape and repeatable distribution of flower buds (100% of degradation). The results have confirmed that the oxide layer thickness of the anodic WO3 significantly affected the photocatalytic activity, which increased with the increasing thickness of WO3 (to 1.05 μm) and then had a downward trend. The photocurrent response evidenced that the well-organized sample had the highest ability in photocurrent generation under UV-Vis and Vis irradiation. Finally, a possible growth mechanism of WO3 NFs was also discussed.

Photocatalytic degradation of methylene blue from aqueous solutions using nanopillars-TiO2 thin films: Batch reactor studies

2018 ◽  
Vol 18 (3) ◽  
pp. 81-91 ◽  
Author(s):  
C. Lalhriatpuia
Keyword(s):  
Thin Films ◽  
Methylene Blue ◽  
Photocatalytic Activity ◽  
Organic Carbon ◽  
Photocatalytic Degradation ◽  
Batch Reactor ◽  
Tio2 Thin Films ◽  
Initial Concentration ◽  
Bet Specific Surface Area ◽  
Interfering Ions

Nanopillars-TiO2 thin films was obtained on a borosilicate glass substrate with (S1) and without (S2) polyethylene glycol as template. The photocatalytic behaviour of S1 and S2 thin films was assessed inthe degradation of methylene blue (MB) dye from aqueous solution under batch reactor operations. The thin films were characterized by the SEM, XRD, FTIR and AFM analytical methods. BET specific surface area and pore sizes were also obtained. The XRD data confirmed that the TiO2 particles are in its anatase mineral phase. The SEM and AFM images indicated the catalyst is composed with nanosized pillars of TiO2, evenly distributed on the surface of the substrate. The BET specific surface area and pore sizes of S1 and S2 catalyst were found to be 5.217 and 1.420 m2/g and 7.77 and 4.16 nm respectively. The photocatalytic degradation of MB was well studied at wide range of physico-chemical parameters. The effect of solution pH (pH 4.0 to 10.0) and MB initial concentration (1.0 to 10.0 mg/L) was extensively studied and the effect of several interfering ions, i.e., cadmium nitrate, copper sulfate, zinc chloride, sodium chloride, sodium nitrate, sodium nitrite, glycine, oxalic acid and EDTA in the photocatalytic degradation of MB was demonstrated. The maximum percent removal of MB was observed at pH 8.0 beyond which it started decreasing and a low initial concentration of the pollutant highly favoured the photocatalytic degradation using thin films and the presence of several interfering ions diminished the photocatalytic activity of thin films to some extent. The overall photocatalytic activity was in the order: S2 > S1 > UV. The photocatalytic degradation of MB was followed the pseudo-first-order rate kinetics. The mineralization of MB was studied with total organic carbon measurement using the TOC (total organic carbon) analysis.

STRUCTURAL, OPTICAL PROPERTIES AND PHOTOCATALYTIC ACTIVITY OF NANOCRYSTALLINE TiO2 THIN FILMS DEPOSITED BY SOL-GEL SPIN COATING

2019 ◽  
Vol 7 (1) ◽  
pp. 28
Author(s):  
KOMARAIAH DURGAM ◽  
RADHA EPPA ◽  
REDDY M. V. RAMANA ◽  
KUMAR J. SIVA ◽  
R. SAYANNA ◽  
...  
Keyword(s):  
Thin Films ◽  
Optical Properties ◽  
Photocatalytic Activity ◽  
Spin Coating ◽  
Sol Gel ◽  
Tio2 Thin Films ◽  
Nanocrystalline Tio2

Use of Nanopillars-TiO2 Thin Films in the Photocatalytic Degradation of Bromophenol Blue from Aqueous Solution

2018 ◽  
Vol 6 (1) ◽  
pp. 22-30
Author(s):  
C. Lalhriatpuia ◽  
◽  
Thanhming liana ◽  
K. Vanlaldinpuia
Keyword(s):  
Thin Films ◽  
Aqueous Solution ◽  
Photocatalytic Activity ◽  
Photocatalytic Degradation ◽  
Batch Reactor ◽  
Bromophenol Blue ◽  
Tio2 Thin Films ◽  
Initial Concentration ◽  
Bet Specific Surface Area ◽  
Interfering Ions

The photocatalytic activity of Nanopillars-TiO2 thin films was assessed in the degradation of Bromophenol blue (BPB) dye from aqueous solution under batch reactor operations. The thin films were characterized by the XRD, SEM and AFM analytical methods. BET specific surface area and pore sizes were also obtained. The XRD data showed anatase phase of TiO2 particles with average particle size of 25.4 and 21.9 nm, for S1 and S2 catalysts respectively. The SEM and AFM images indicated the catalyst composed with Nanosized pillars of TiO2, evenly distributed on the surface of the substrate. The average height of the pillars was found to be 180 and 40 nm respectively for the S1 and S2 catalyst. The BET specific surface area and pore sizes of S1 and S2 catalyst were found to be 5.217 and 1.420 m2/g and 7.77 and 4.16 nm respectively. The photocatalytic degradation of BPB using the UV light was studied at wide range of physico-chemical parametric studies to determine the mechanism of degradation as well as the practical applicability of the technique. The batch reactor operations were conducted at varied pH (pH 4.0 to 10.0), BPB initial concentration (1.0 to 20.0 mg/L) and presence of several interfering ions, i.e., cadmium nitrate, copper sulfate, zinc chloride, sodium chloride, sodium nitrate, sodium nitrite, glycine, oxalic acid and EDTA in the photocatalytic degradation of BPB. The maximum percent removal of BPB was observed at pH 6.0 and a low initial concentration of the pollutant highly favours the photocatalytic degradation using thin films. The presence of several interfering ions suppressed the photocatalytic activity of thin films to some extent. The time dependence photocatalytic degradation of BPB was demonstrated with the pseudo-first-order rate kinetics. Study was further extended with total organic carbon measurement using the TOC (Total Organic Carbon) analysis. This demonstrated an apparent mineralization of BPB from aqueous solutions.

Preparation, Characterization, and Photocatalytic Activity of Mesoporous TiO2 Thin Films

2013 ◽  
Vol 13 (2) ◽  
pp. 1493-1497 ◽  
Author(s):  
Jinshu Wang ◽  
Hui Li ◽  
Hongyi Li ◽  
Hong Wang ◽  
Qian Cai
Keyword(s):  
Thin Films ◽  
Photocatalytic Activity
Sign in / Sign up

Export Citation Format

Share Document