Strain patterns within part of the Willard thrust sheet, Idaho–Utah–Wyoming thrust belt

2005 ◽  
Vol 27 (7) ◽  
pp. 1315-1343 ◽  
Author(s):  
Adolph Yonkee
Keyword(s):  
Thrust Belt ◽  
Thrust Sheet ◽  
Willard Thrust

scholarly journals Fault Slip and Exhumation History of the Willard Thrust Sheet, Sevier Fold‐Thrust Belt, Utah: Relations to Wedge Propagation, Hinterland Uplift, and Foreland Basin Sedimentation

Tectonics ◽  
2019 ◽  
Vol 38 (8) ◽  
pp. 2850-2893 ◽  
Author(s):  
W. A. Yonkee ◽  
B. Eleogram ◽  
M. L. Wells ◽  
D. F. Stockli ◽  
S. Kelley ◽  
...  
Keyword(s):  
Foreland Basin ◽  
Fault Slip ◽  
Thrust Belt ◽  
Thrust Sheet ◽  
History Of ◽  
Exhumation History ◽  
Willard Thrust

Indications of Deep Marine Fans in the Early Miocene Foredeep of Lower Austria: A Potential New Play

2021 ◽  
Author(s):  
Ralph Hinsch
Keyword(s):  
Early Miocene ◽  
Thrust Belt ◽  
Vienna Basin ◽  
Thrust Sheet ◽  
Subsequent Formation ◽  
Lower Miocene ◽  
Seismic Amplitude ◽  
Upper Austria ◽  
Basin Floor ◽  
Definition Of

Abstract The petroleum province in Lower Austria resulted from the Alpine collision and the subsequent formation of the Vienna Basin. OMV is active in this area since its foundation in 1956. Several plays have been successfully tested and produced in this complex geological region. The main exploration focus is currently on the deep plays. However, this paper proposes a so far unrecognized and therefore undrilled play in a shallower level to broaden OMV's portfolio in Austria. Seismic re-interpretations of reprocessed 3D seismic data and structural reconstructions were used to review some of the existing plays and get novel ideas from improved understanding of processes. In the frontal accretion zone of the Alpine wedge, the Waschberg-Ždánice zone discoveries are limited to the frontal thrust unit and associated structures. The more internal parts of the thrust belt have only sparsely been drilled and are perceived not to have high-quality reservoir rocks. The detailed structural interpretations indicated that the foredeep axis during the Early Miocene was positioned in the thrust sheet located directly in front of the advancing Alpine wedge (comprising the eroding Rhenodanubian Flysch in its frontal part). Seismic amplitude anomalies can be interpreted to represent Lower Miocene basin floor and slope fans. Nearby wells did not penetrate these fans but drilled instead shale-dominated lithologies. Thus, the presence of potential sand-rich fans in front of the advancing alpine wedge is considered a potential new play in Lower Austria. Analogues are found in Upper Austria some 250 km to the West, where several large gas fields in Lower Miocene deposits located in front of the advancing Alpine wedge have been discovered by another operator. In that area the fans are only partly involved in the fold-thrust belt. In Lower Austria, these fans are located within the rear thrust sheet(s), providing a structural component to a mixed structural-stratigraphic trap. Two potential charge mechanism can be considered: a) biogenic gas charge from the organic matter of surrounding shales (like the Upper Austria analogues) or b) oil charge via the thrust fault planes from the Jurassic Mikulov Formation (the proven main source rock in the broader area). Our results add to the understanding of the Miocene structural-stratigraphic evolution of the Alpine collision zone. The definition of a potential new play may add significant value to OMV's upstream efforts in a very mature hydrocarbon province.

scholarly journals Examining the tectono-stratigraphic architecture, structural geometry, and kinematic evolution of the Himalayan fold-thrust belt, Kumaun, northwest India

Lithosphere ◽  
2019 ◽  
Vol 11 (4) ◽  
pp. 414-435 ◽  
Author(s):  
Subhadip Mandal ◽  
Delores M. Robinson ◽  
Matthew J. Kohn ◽  
Subodha Khanal ◽  
Oindrila Das
Keyword(s):  
Cross Section ◽  
Structural Model ◽  
Kinematic Model ◽  
Thrust Belt ◽  
Main Central Thrust ◽  
Thrust Sheet ◽  
Balanced Cross Section ◽  
Kinematic Evolution ◽  
Thrust Sheets ◽  
Northwest India

Abstract Existing structural models of the Himalayan fold-thrust belt in Kumaun, northwest India, are based on a tectono-stratigraphy that assigns different stratigraphy to the Ramgarh, Berinag, Askot, and Munsiari thrusts and treats the thrusts as separate structures. We reassess the tectono-stratigraphy of Kumaun, based on new and existing U-Pb zircon ages and whole-rock Nd isotopic values, and present a new structural model and deformation history through kinematic analysis using a balanced cross section. This study reveals that the rocks that currently crop out as the Ramgarh, Berinag, Askot, and Munsiari thrust sheets were part of the same, once laterally continuous stratigraphic unit, consisting of Lesser Himalayan Paleoproterozoic granitoids (ca. 1850 Ma) and metasedimentary rocks. These Paleoproterozoic rocks were shortened and duplexed into the Ramgarh-Munsiari thrust sheet and other Paleoproterozoic thrust sheets during Himalayan orogenesis. Our structural model contains a hinterland-dipping duplex that accommodates ∼541–575 km or 79%–80% of minimum shortening between the Main Frontal thrust and South Tibetan Detachment system. By adding in minimum shortening from the Tethyan Himalaya, we estimate a total minimum shortening of ∼674–751 km in the Himalayan fold-thrust belt. The Ramgarh-Munsiari thrust sheet and the Lesser Himalayan duplex are breached by erosion, separating the Paleoproterozoic Lesser Himalayan rocks of the Ramgarh-Munsiari thrust into the isolated, synclinal Almora, Askot, and Chiplakot klippen, where folding of the Ramgarh-Munsiari thrust sheet by the Lesser Himalayan duplex controls preservation of these klippen. The Ramgarh-Munsiari thrust carries the Paleoproterozoic Lesser Himalayan rocks ∼120 km southward from the footwall of the Main Central thrust and exposed them in the hanging wall of the Main Boundary thrust. Our kinematic model demonstrates that propagation of the thrust belt occurred from north to south with minor out-of-sequence thrusting and is consistent with a critical taper model for growth of the Himalayan thrust belt, following emplacement of midcrustal Greater Himalayan rocks. Our revised stratigraphy-based balanced cross section contains ∼120–200 km greater shortening than previously estimated through the Greater, Lesser, and Subhimalayan rocks.

Taconian mélanges in the parautochthonous zone of the Quebec Appalachians revisited: implications for foreland basin and thrust belt evolution

2004 ◽  
Vol 41 (12) ◽  
pp. 1473-1490 ◽  
Author(s):  
F -A Comeau ◽  
D Kirkwood ◽  
M Malo ◽  
E Asselin ◽  
R Bertrand
Keyword(s):  
Foreland Basin ◽  
Late Ordovician ◽  
Thrust Faults ◽  
Thrust Belt ◽  
Thrust Sheet ◽  
Utica Shale ◽  
Thermal Maturation ◽  
Early Late

In the Quebec Appalachians, disruption, imbrication, and thrusting of the Taconian foreland basin sequence are responsible for the development of chaotic units within the turbiditic sequence of the Caradocian Sainte-Rosalie Group, the main lithologic assemblage of the parautochthonous zone. These chaotic units have been termed olistostromes or tectonosomes on the basis of field criteria and following Pini's (1999) classification. Olistostromal units containing blocks of the middle mudstone (Utica Shale) and upper turbidite units (Ste-Rosalie Group) of the foreland basin and spanning the Caradocian N. gracilis, C. americanus, O. ruedemanni, and C. spiniferus graptolite zones were deposited and incorporated into the Sainte-Rosalie Group. Disruption of more competent beds of the flyschic sequence and fault stacking and slicing of older rock units occurred along major thrust faults and now form structurally aligned corridors or tectonosomes. Graptolites and new chitinozoan data from both olistostromes and tectonosomes indicate older ages (early Late Ordovician) than the flysch units of Sainte-Rosalie Group (mid Late Ordovocian). Lithological, stratigraphic, and structural criteria indicate that tectonosome slices are imbricated foreland basin rocks that are correlative to the Black River, Trenton, Utica, Sainte-Rosalie, and Lorraine groups of the Laurentian platform. Thermal maturation data indicates that disruption of the autochthonous sequence, and folding and thrusting of the entire foreland basin sequence, must have occurred shortly after their deposition. Contrary to what had been suggested, blocks in the olistostromes and tectonosomes were not derived from the allochthonous Chaudière thrust sheet, even though it presently marks the southern contact with the parautochthonous zone. Imbrication of the foreland basin sequence must have occurred before emplacement of the Chaudière thrust sheet.

scholarly journals Thrust tectonics in the Wetterstein and Mieming mountains, and a new tectonic subdivision of the Northern Calcareous Alps of Western Austria and Southern Germany

2021 ◽  
Author(s):  
Hugo Ortner ◽  
Sinah Kilian
Keyword(s):  
Eastern Alps ◽  
Northern Calcareous Alps ◽  
Main Body ◽  
Thrust Belt ◽  
Southeastern Part ◽  
Thrust Sheet ◽  
Northern Calcareous ◽  
Lateral Contact ◽  
Thrust Tectonics ◽  
Thrust Sheets

AbstractWe investigate the tectonic evolution of the Wetterstein and Mieming mountains in the western Northern Calcareous Alps (NCA) of the European Eastern Alps. In-sequence NW-directed stacking of thrust sheets in this thin-skinned foreland thrust belt lasted from the Hauterivian to the Cenomanian. In the more internal NCA major E-striking intracontinental transform faults dissected the thrust belt at the Albian–Cenomanian boundary that facilitated ascent of mantle melts feeding basanitic dykes and sills. Afterwards, the NCA basement was subducted, and the NCA were transported piggy-back across the tectonically deeper Penninic units. This process was accompanied by renewed Late Cretaceous NW-directed thrusting, and folding of thrusts. During Paleogene collision, N(NE)-directed out-of-sequence thrusts developed that offset the in-sequence thrust. We use this latter observation to revise the existing tectonic subdivision of the western NCA, in which these out-of-sequence thrusts had been used to delimit nappes, locally with young-on-old contacts at the base. We define new units that represent thrust sheets having exclusively old-on-young contacts at their base. Two large thrust sheets build the western NCA: (1) the tectonically deeper Tannheim thrust sheet and (2) the tectonically higher Karwendel thrust sheet. West of the Wetterstein and Mieming mountains, the Imst part of the Karwendel thrust sheet is stacked by an out-of-sequence thrust onto the main body of the Karwendel thrust sheet, which is, in its southeastern part, in lateral contact with the latter across a tear fault.

Sign in / Sign up

Export Citation Format

Share Document