scholarly journals Stability indicating high performance thin-layer chromatographic method for simultaneous estimation of pantoprazole sodium and itopride hydrochloride in combined dosage form

2011 ◽  
Vol 1 (4) ◽  
pp. 275-283 ◽  
Author(s):  
Deepak Bageshwar ◽  
Vineeta Khanvilkar ◽  
Vilasrao Kadam
Keyword(s):  
Thin Layer ◽  
High Performance ◽  
Dosage Form ◽  
Chromatographic Method ◽  
Simultaneous Estimation ◽  
Stability Indicating ◽  
Itopride Hydrochloride

scholarly journals NOVEL NOVEL STABILITY-INDICATING HIGH-PERFORMANCE LIQUID CHROMATOGRAPHIC ASSAY METHOD FOR SIMULTANEOUS ESTIMATION OF HYDROCORTISONE AND TETRACYCLINE IN BULK AND PHARMACEUTICAL DOSAGE FORM

2019 ◽  
pp. 255-258
Author(s):  
MUNI SAI VARAGANTI ◽  
PRASANTHI CHENGALVA ◽  
ARUNA GUNDALA
Keyword(s):  
High Performance ◽  
Dosage Form ◽  
Chromatographic Method ◽  
High Performance Liquid Chromatographic ◽  
Simultaneous Estimation ◽  
Reverse Phase ◽  
Pharmaceutical Dosage Form ◽  
Stability Indicating ◽  
Liquid Chromatographic Method ◽  
Liquid Chromatographic

Objective: A combination of hydrocortisone and tetracycline as topical ophthalmic ointment is used for skin irritations, eye infections, inflammation, skin infections, acne, and rashes. The objective of the current work is to a simple, rapid, accurate, and precise, stability-indicating reverse-phase liquid chromatographic method was developed for the simultaneous estimation of hydrocortisone and tetracycline in bulk and pharmaceutical dosage form. Methods: The separation was carried out in Discovery C18 column (250 × 4.6 mm, 5 μm) using mobile phase ratio of water (pH 2.2 adjusted with orthophosphoric acid):acetonitrile (40:60 v/v) in an isocratic elution mode with a flow rate of 1.0 ml/min at detection wavelength of 244 nm. The injection volume was 10 μl and the column temperature was set at 30°C. Results: The retention time for hydrocortisone and tetracycline was found to be 2.214 ± 0.001 min and 3.497 ± 0.001 min, respectively. Calibration curves were linear (r2=0.999) at a concentration range of 2.5–15 mg/ml for both hydrocortisone and tetracycline. The percentage recoveries were found to be 99.13–99.67% for hydrocortisone and 99.39–99.61% for tetracycline. Relative standard deviation was found to be 0.3% for both the drugs. Limit of detection and limit of quantification values of hydrocortisone and tetracycline were found to be 0.09 μg/ml and 0.27 μg/ml and 0.17 μg/ml and 0.52 μg/ml, respectively. The drugs were subjected to various stress conditions and found no interference of degraded products peak at the retention times of analyte peaks. Conclusion: A rapid and accurate reverse-phase high-performance liquid chromatographic method was developed for simultaneous estimation of hydrocortisone and tetracycline, and the method was validated as per the International Council for Harmonization guidelines. Hence, the developed method can be successfully applied for the simultaneous estimation of hydrocortisone and tetracycline in bulk and ointment formulation.

scholarly journals STABILITY-INDICATING HIGH-PERFORMANCE THIN-LAYER CHROMATOGRAPHY METHOD FOR SIMULTANEOUS ESTIMATION OF FORMOTEROL FUMARATE DIHYDRATE AND FLUTICASONE PROPIONATE IN BULK DRUG AND PHARMACEUTICAL DOSAGE FORM

2019 ◽  
pp. 149-155
Author(s):  
RAJASHI B PHARATE ◽  
SUNEELA S DHANESHWAR
Keyword(s):  
Fluticasone Propionate ◽  
Thin Layer ◽  
Mobile Phase ◽  
High Performance ◽  
Dosage Form ◽  
Simultaneous Estimation ◽  
Pharmaceutical Dosage Form ◽  
Stability Indicating ◽  
Bulk Drug ◽  
Formoterol Fumarate

Objective: The objective of the present work was to develop validated stability-indicating high-performance thin-layer chromatographic method for simultaneous estimation of formoterol fumarate dihydrate (FFD) and fluticasone propionate (FP) in bulk drug and pharmaceutical dosage form. Methods: Pre-coated silica gel aluminum plates 60 F-254 were used as stationary phase. The mixture of toluene:ethyl acetate:formic acid (98%) (6:4:0.1; v/v/v) was used as a mobile phase. The densitometric quantification was carried out at 233 nm. The method was validated according to the ICH guidelines. The specificity and stability indicating the capability of the method were proven though degradation studies. Both drugs were subjected to acid (0.1N HCl) and base (0.1N NaOH) hydrolysis, oxidation (3% v/v H2O2), photolytic, and neutral degradation conditions. Results: The selected mobile phase resolved peaks of FFD and FP with Rf values 0.27±0.10 and 0.64±0.10, respectively. Determination coefficients of calibration curves were found to be 0.998 and 0.999 in the range of 1–3.5 μg/spot and 10–60 μg/spot for FFD and FP with an accuracy of 99.09% for FFD and 99.20% for FP. The degradation products of FFD and FP were resolved from the pure drug with significant differences in their retention factor values. Conclusion: The developed method is simple, accurate and can be successfully applied for quantification of FFD and FP in bulk drug and pharmaceutical dosage form, contributing to improve the quality control and assure the therapeutic efficacy.

Sign in / Sign up

Export Citation Format

Share Document