Validation of a HPLC method for the quantification and purity determination of SK3530 in drug substance and tablet

2007 ◽  
Vol 43 (3) ◽  
pp. 1179-1184 ◽  
Author(s):  
Joon Gyo Oh ◽  
Woo-Jae Jang ◽  
Sang-Cheol Chi
Chirality ◽  
2003 ◽  
Vol 15 (7) ◽  
pp. 600-604 ◽  
Author(s):  
Janusz Zukowski ◽  
Malcolm Brightwell ◽  
Vern de Biasi

Author(s):  
Suresh Babu Bodempudi ◽  
Ravi Chandra Babu Rupakula ◽  
Konda S. Reddy ◽  
Mahesh Reddy Ghanta

Objective: The main objective of present study was to Isolate, characterize and validate a reverse phase high performance liquid chromatographic method was validated for quantification of bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine in Olanzapine drug substance; it decreases the mental disorders in human body. The method is specific, rapid, precise and accurate for the separation and determination of bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine in Olanzapine drug substance form.Methods: The bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine of Olanzapine was resolved on a Zorbax RX-C 8, 250 mm X 4.6 mm, 5 micron column (L-1) using a mobile phase system containing 0.03 M sodium dodecyl sulphate in water pH 2.5 with 1 N sodium hydroxide solution and acetonitrile in the ratio of (Mobile phase A-52:48 v/v) and (Mobile phase B-buffer and Acetonitrile 30:70 v/v) by using the gradient program. The mobile phase was set at a flow rate of 1.5 ml/min and the volume injected was 20μl for every injection. The detection wavelength was set at 220 nm and the column temperature was set at 35 °C.Results: The proposed method was productively applied for the quantitative determination of bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo [f]azulene)]-1,4-piperazine in Olanzapine drug substance form. The linear regression analysis data for calibration plots showed a good linear relationship over a concentration range of 0.025to 0.903 µg/ml for bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine, 0.081-0.608 µg/ml for Olanzapine. The mean values of the correlation coefficient were 0.999 and 0.999 for bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine and Olanzapine. The method was validated as per the ICH guidelines. The detection limit (LOD) was about 0.007 µg/ml, 0.024 µg/ml and quantitation limit (LOQ) was about 0.024 µg/ml, 0.081 µg/ml for bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine and Olanzapine. The relative standard deviation was found to be 1.64 % and 2.18 % for bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine and Olanzapine.Conclusion: The validated HPLC method and the statistical analysis showed that the method is repeatable and selective for the estimation of the bis-[10-(2-methyl-4H-3-thia-4,9-diazabenzo[f]azulene)]-1,4-piperazine of the Olanzapine drug substance.


2019 ◽  
Vol 58 (3) ◽  
pp. 251-261
Author(s):  
Hala E Zaazaa ◽  
Rasha Abdel-Ghany ◽  
M Abdelkawy ◽  
Mahmoud Sayed

Abstract Two robust and selective stability-indicating chromatographic methods were developed and validated for the determination of metolazone in drug substance and pharmaceutical dosage form in the presence of its degradation products. The HPLC method employed a Kromasil C18 (250 × 4.6,5 μm) column and a mobile phase of acetonitrile: 0.2% orthophosphoric acid (32:68 v/v) at a flow rate 2 mL/min and detection at 238 nm. The separation was performed in HPLC isocratic mode. The robustness of the suggested method was assessed using the Plackett–Burman design, parameters affecting system suitability were established and non-significant intervals for the significant parameters were considered. The HPTLC method employed Nano-SIL-20 UV254 HPTLC plates as adsorbent, ethyl acetate: toluene: acetic acid solution (4:4:0.5, v/v/v), as a developing solvent system and densitometric detection at 238 nm. Metolazone was exposed to different stress conditions, including acid and alkaline hydrolysis and oxidative and photolytic degradation. The main degradation products obtained have been characterized and interpreted based on LC-MS. The linearity of the suggested methods was proved in the concentration range of 20–75 μg/mL for the HPLC method and 100–900 ng/spot for the HPTLC method. The suggested methods were validated according to international conference on harmonization guidelines. These methods were successfully dedicated for the estimation of metolazone in drug substance and pharmaceutical dosage form in the presence of its degradation products. The results of the suggested methods were evaluated and compared statistically with results obtained by an official method without finding any significant difference.


2012 ◽  
Vol 18 (4-1) ◽  
pp. 595-604 ◽  
Author(s):  
P.S. Jain ◽  
A.J. Chaudhari ◽  
S.J. Surana

Olmesartan Medoxomil (OLME) belongs to a group of angiotensin II receptor blockers used as an antihypertensive agent and is currently being used for prevention of Hypertension. This paper describes the Validation and development of stability indicating RP-HPLC method for the determination of OLME in the presence of its degradation products generated from forced degradation study and characterization of degradation product (impurity). The assay involved gradient elution of OLME on An LC GC BDS C18 column (250 ? 4.5mm, 5-?m particle size) was employed for loading the sample. The mobile phase A consists of 7 ml Triethylamine in 1000 ml water (pH adjusted to 3.0 with orthophosphoric acid) and B contains acetonitrile. Quantification was achieved with photodiode array detection at 257 nm. The chromatographic separation was obtained with a retention time of 6.72 min, and the method was linear in the range 50-150 ?g/ml. The method was validated according to the ICH guidelines with respect to linearity, precision, accuracy, limit of detection (LOD), limit of quantification (LOQ), specificity and robustness. Impurity found in stressed and stability studies of Olmesartan Medoxomil in both drug substance and drug product are described. This degradation product is identified as 1-(biphenyl-4-ylmethyl)-1H-imidazole-5-carboxylic acid. An Alkaline degradation pathway of Olmesartan medoxomil, for the formation of this degradation product, has been proposed and degradation product was characterized.


2008 ◽  
Vol 48 (5) ◽  
pp. 1430-1440 ◽  
Author(s):  
Sreenivasa Rao Chitturi ◽  
Ch. Bharathi ◽  
A.V. Raghava Reddy ◽  
K. Chandrasekhar Reddy ◽  
Hemant Kumar Sharma ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document