scholarly journals Numerical studies on the instantaneous fluid–structure interaction of an air-inflated flexible membrane in turbulent flow

2018 ◽  
Vol 82 ◽  
pp. 577-609 ◽  
Author(s):  
G. De Nayer ◽  
A. Apostolatos ◽  
J.N. Wood ◽  
K.U. Bletzinger ◽  
R. Wüchner ◽  
...  
Keyword(s):  
Turbulent Flow ◽  
Fluid Structure Interaction ◽  
Flexible Membrane ◽  
Fluid Structure ◽  
Structure Interaction ◽  
Numerical Studies

Experimental analysis of fluid-structure interaction in flexible wings at low Reynolds number flows

2021 ◽  
Vol ahead-of-print (ahead-of-print) ◽  
Author(s):  
Mustafa Serdar Genç ◽  
Hacımurat Demir ◽  
Mustafa Özden ◽  
Tuna Murat Bodur
Keyword(s):  
Reynolds Number ◽  
Aspect Ratio ◽  
Fluid Structure Interaction ◽  
Leading Edge ◽  
Flexible Wings ◽  
Flexible Membrane ◽  
Fluid Structure ◽  
Content Type ◽  
Structure Interaction ◽  
Membrane Deformations

Purpose The purpose of this exhaustive experimental study is to investigate the fluid-structure interaction in the flexible membrane wings over a range of angles of attack for various Reynolds numbers. Design/methodology/approach In this paper, an experimental study on fluid-structure interaction of flexible membrane wings was presented at Reynolds numbers of 2.5 × 104, 5 × 104 and 7.5 × 104. In the experimental studies, flow visualization, velocity and deformation measurements for flexible membrane wings were performed by the smoke-wire technique, multichannel constant temperature anemometer and digital image correlation system, respectively. All experimental results were combined and fluid-structure interaction was discussed. Findings In the flexible wings with the higher aspect ratio, higher vibration modes were noticed because the leading-edge separation was dominant at lower angles of attack. As both Reynolds number and the aspect ratio increased, the maximum membrane deformations increased and the vibrations became visible, secondary vibration modes were observed with growing the leading-edge vortices at moderate angles of attack. Moreover, in the graphs of the spectral analysis of the membrane displacement and the velocity; the dominant frequencies coincided because of the interaction of the flow over the wings and the membrane deformations. Originality/value Unlike available literature, obtained results were presented comparatively using the sketches of the smoke-wire photographs with deformation measurement or turbulence statistics from the velocity measurements. In this study, fluid-structure interaction and leading-edge vortices of membrane wings were investigated in detail with increasing both Reynolds number and the aspect ratio.

Fluid–Structure Interaction Study and Flowrate Prediction Past a Flexible Membrane Using Immersed Boundary Method and Artificial Neural Network Techniques

2020 ◽  
Vol 142 (5) ◽  
Author(s):  
Mithun Kanchan ◽  
Ranjith Maniyeri
Keyword(s):  
Neural Network ◽  
Artificial Neural Network ◽  
Immersed Boundary Method ◽  
Fluid Structure Interaction ◽  
Immersed Boundary ◽  
Flexible Membrane ◽  
Fluid Structure ◽  
Structure Interaction ◽  
Boundary Method ◽  
Artificial Neural

Abstract Many microfluidics-based applications involve fluid–structure interaction (FSI) of flexible membranes. Thin flexible membranes are now being widely used for mixing enhancement, particle segregation, flowrate control, drug delivery, etc. The FSI simulations related to these applications are challenging to numerically implement. In this direction, techniques like immersed boundary method (IBM) have been successful. In this study, two-dimensional numerical simulation of flexible membrane fixed at two end points in a rectangular channel subjected to uniform fluid flow is carried out at low Reynolds number using a finite volume based IBM. A staggered Cartesian grid system is used and SIMPLE algorithm is used to solve the governing continuity and Navier–Stokes equations. The developed model is validated using the previous research work and numerical simulations are carried out for different parametric test cases. Different membrane mode shapes are observed due to the complex interplay between the hydrodynamics and structural elastic forces. Since the membrane undergoes deformation with respect to inlet fluid conditions, a variation in flowrate past the flexible structure is confirmed. It is found that, by changing the membrane length, bending rigidity, and its initial position in the channel, flowrate can be controlled. Also, for membranes that are placed at the channel midplane undergoing self-excited oscillations, there exists a critical dimensionless membrane length condition L ≥ 1.0 that governs this behavior. Finally, an artificial neural network (ANN) model is developed that successfully predicts flowrate in the channel for different membrane parameters.

scholarly journals Numerical investigation of structural behavior during fluid excited vibrations

2007 ◽  
pp. 491-519
Author(s):  
Saim Yigit ◽  
Michael Schäfer ◽  
Marcus Heck
Keyword(s):  
Incompressible Flows ◽  
Fluid Structure Interaction ◽  
Solution Procedure ◽  
Adequate Treatment ◽  
Fluid Structure ◽  
Flow Solver ◽  
Test Configuration ◽  
Structure Interaction ◽  
Numerical Studies ◽  
Structural Configurations

In the present paper different occurring phenomena during the interaction between certain structural configurations and laminar incompressible flows are investigated. Preliminary investigations concerning the grid movement technique provide the basis for the adequate treatment of the fluid structure interaction problems. Several mechanisms according to real experiments are presented. Systematical numerical studies of material parameters are performed on the basis of a moderately complex fluid structure interaction test configuration. The solution procedure involves the finite-volume flow solver FASTEST, the finite-element structural solver FEAP, and the coupling interface MpCCI.

scholarly journals Fluid–structure interaction of free convection in a square cavity divided by a flexible membrane and subjected to sinusoidal temperature heating

2019 ◽  
Vol 30 (6) ◽  
pp. 2883-2911 ◽  
Author(s):  
Mohammad Ghalambaz ◽  
S.A.M. Mehryan ◽  
Muneer A. Ismael ◽  
Ali Chamkha ◽  
D. Wen
Keyword(s):  
Heat Transfer ◽  
Prandtl Number ◽  
Elasticity Modulus ◽  
Fluid Structure Interaction ◽  
Vertical Wall ◽  
Convection And Heat Transfer ◽  
Flexible Membrane ◽  
Fluid Structure ◽  
Content Type ◽  
Structure Interaction

Purpose The purpose of the present paper is to model a cavity, which is equally divided vertically by a thin, flexible membrane. The membranes are inevitable components of many engineering devices such as distillation systems and fuel cells. In the present study, a cavity which is equally divided vertically by a thin, flexible membrane is model using the fluid–structure interaction (FSI) associated with a moving grid approach. Design/methodology/approach The cavity is differentially heated by a sinusoidal time-varying temperature on the left vertical wall, while the right vertical wall is cooled isothermally. There is no thermal diffusion from the upper and lower boundaries. The finite-element Galerkin technique with the aid of an arbitrary Lagrangian–Eulerian procedure is followed in the numerical procedure. The governing equations are transformed into non-dimensional forms to generalize the solution. Findings The effects of four pertinent parameters are investigated, i.e., Rayleigh number (104 = Ra = 107), elasticity modulus (5 × 1012 = ET = 1016), Prandtl number (0.7 = Pr = 200) and temperature oscillation frequency (2p = f = 240p). The outcomes show that the temperature frequency does not induce a notable effect on the mean values of the Nusselt number and the deformation of the flexible membrane. The convective heat transfer and the stretching of the thin, flexible membrane become higher with a fluid of a higher Prandtl number or with a partition of a lower elasticity modulus. Originality/value The authors believe that the modeling of natural convection and heat transfer in a cavity with the deformable membrane and oscillating wall heating is a new subject and the results have not been published elsewhere.

Sign in / Sign up

Export Citation Format

Share Document