Vortex-induced vibration of a flexible cylinder: Interaction of the in-line and cross-flow responses

2016 ◽  
Vol 63 ◽  
pp. 238-258 ◽  
Author(s):  
Jie Wu ◽  
Halvor Lie ◽  
Carl M. Larsen ◽  
Stergios Liapis ◽  
Rolf Baarholm
Keyword(s):  
Cross Flow ◽  
Flexible Cylinder ◽  
Vortex Induced Vibration

On the Vortex-Induced Vibration Response of a Model Riser and Location of Sensors for Fatigue Damage Prediction

2010 ◽  
Author(s):  
C. Shi ◽  
L. Manuel ◽  
M. A. Tognarelli ◽  
T. Botros
Keyword(s):  
Fatigue Damage ◽  
Traveling Waves ◽  
Wavelet Transforms ◽  
Cross Flow ◽  
Waveform Analysis ◽  
Flexible Cylinder ◽  
Vortex Induced Vibration ◽  
Damage Prediction ◽  
Time Frequency ◽  
Damage Rate

This study is concerned with vortex-induced vibration (VIV) of deepwater marine risers. Riser response measurements from model tests on a densely instrumented long, flexible riser in uniform and sheared currents offer an almost ideal set-up for our work. Our objectives are two-fold: (i) we use the measured data to describe complexities inherent in riser motions accompanying VIV; and (ii) we discuss how such data sets (and even less spatially dense monitoring) can be used effectively in predicting fatigue damage rates which is of critical interest for deepwater risers. First, we use mathematical tools including Hilbert and wavelet transforms to estimate instantaneous amplitudes and phases of cross-flow (CF) and in-line (IL) displacements for the model riser as well as scalograms to understand time-frequency characteristics of the response; this work confirms that the motion of a long flexible cylinder is far more complex than that of a rigid cylinder, and that non-stationary characteristics, higher harmonics, and traveling waves are evident in the riser response. Second, a well-established empirical procedure, which we refer to as Weighted Waveform Analysis (WWA), is employed to estimate the fatigue damage rate at various locations along the length of the riser from strain measurements at only eight sensors. By iterating over numerous different combinations of these eight strain sensors as inputs (from among all the twenty-four available locations on the riser), optimal locations for the eight sensors on the riser are identified by cross-validation, whereby predicted strains and fatigue damage rates at locations of instrumented sensors are compared with strains and fatigue damage rates based on actual recorded measurements there. We find that, if properly placed, as few as eight sensors can provide reasonably accurate estimates of the fatigue damage rate over the entire riser length. Finally, we demonstrate how more accurate fatigue damage prediction can result when non-stationary response characteristics are considered and a modified WWA method (that more effectively accounts for traveling waves than the WWA method alone does) is employed.

On Vortex Induced Vibration in Two-Degree-of-Freedoms of Flexible Cylinders

2011 ◽  
Author(s):  
Weiping Huang ◽  
Weihong Yu
Keyword(s):  
Natural Frequency ◽  
Current Velocity ◽  
Coupling Effect ◽  
Great Influence ◽  
Cross Flow ◽  
Flexible Cylinder ◽  
Fluid Structure ◽  
Vortex Induced Vibration ◽  
Flow Vortex ◽  
Lock In

In this paper, an experimental study on the in-line and cross-flow vortex-induced vibration (VIV) of flexible cylinders is conducted. The relationship of two-degree-of-freedoms of vortex-induced vibration of flexible cylinders is also investigated. The influence of natural frequency of flexible cylinders on vortex shedding and VIV are studied through the experiment in this paper. Finally, A nonlinear model, with fluid-structure interaction, of two-degree-of-freedom VIV of flexible cylinders is proposed. It is shown that the ratio of the frequencies and amplitudes of in-line and cross flow VIV of the flexible cylinders changes with current velocity and Reynolds number. The natural frequency of flexible cylinder has great influence on the vortex-induced virbation due to the strong fluid-structure coupling effect. Under given current velocity, the natural frequency of flexible cylinder determines its forms of vibration (in circular or ‘8’ form). The ratio of the VIV frequencies is 1.0 beyond the lock in district and 2.0 within the lock in district respectively. And the ratio of the VIV amplitudes is 1.0 beyond the lock in district and 1/3 to 2/3 within the lock in district. The results from this paper indicates that in-line vibration should be considerated when calculating the vibration response and fatigue damage.

Experimental Investigation of the Effects of the In-Line Top-Motion on the Vortex-Induced Vibration Response of a Flexible Riser

2020 ◽  
Author(s):  
Wei Yang ◽  
Chuanzhen Ma ◽  
Zhuang Kang ◽  
Cheng Zhang ◽  
Shaojie Li
Keyword(s):  
Experimental Investigation ◽  
Vibration Frequency ◽  
Flow Direction ◽  
Excitation Frequency ◽  
Cross Flow ◽  
Excitation Amplitude ◽  
Flexible Cylinder ◽  
Amplitude Analysis ◽  
Vortex Induced Vibration ◽  
Flexible Risers

Abstract In order to understand the relation between top-motion and VIV of flexible risers, this paper presents an experimental investigation on concomitant vortex-induced vibration and top-motion excitation with flexible risers. The riser can was mounted vertically, with the diameter of 2 cm and the length of 5 m. The responses of amplitude, frequency and other parameters were analyzed in detail under conditions of different excitation amplitude and frequency in uniform flow. It was found that the concomitant VIV and top-motion excitation significantly affects the flexible cylinder response when compared to the pure VIV tests. The amplitude analysis results show that when the reduced velocity is small (less than about 15), the top-motion excitation has an important influence on amplitude of in-line directions. However, the excitation amplitude and frequency of in-line direction have a little influence on amplitude of cross flow direction. The frequency analysis results show that when the reduced velocity is small (less than about 5), the riser motion amplitude is small and irregular in different excitation and when the reduced velocity is large (5 < Ur < 55), the in-line vibration frequency is two times the cross-flow vibration frequency. A strong connection between the top-motion excitation frequency and the vibration frequency was also found. Overall, some phenomena and characteristics observed in the VIV considering top-motion excitation are different from those in classic VIV, which may provide basic reference for the VIV investigation involving the effect of floating bodies.

Vortex-Induced Vibration of a Flexible Cylinder Experiencing Oscillatory Flow With Different Aspect Ratios

2019 ◽  
Author(s):  
Di Deng ◽  
Lei Wu ◽  
Decheng Wan
Keyword(s):  
Oscillatory Flow ◽  
Flow Direction ◽  
Decomposition Analysis ◽  
Cross Flow ◽  
Offshore Platforms ◽  
Analysis Method ◽  
Flexible Cylinder ◽  
Vortex Induced Vibration ◽  
Aspect Ratios ◽  
Oil Exploitation

Abstract In deep sea oil exploitation, offshore platforms will move periodically in the water under the combined effects of waves, currents and winds. The relatively oscillatory flow is generated between the riser connected to the platform and the water. Vortex-induced Vibration (VIV) features of a single cylinder in the oscillatory flow are more complicated than that in the uniform flow. In this paper, numerical investigations on VIV of a flexible cylinder with different aspect ratios exposed to the oscillatory flow are carried out by the in-house CFD solver viv-FOAM-SJTU, which is developed based on the open source toolbox OpenFOAM. The flexible cylinder is forced to oscillate harmonically in the in-line direction in the still water and is allowed to freely vibrate in the cross-flow direction. Firstly, comparisons on referred experiments and simulations are conducted to verify the validity of the solver. Then, the modal decomposition analysis method and the Fast Fourier Transform (FFT) method are used to obtain the dominant vibration modes and frequencies of the cylinder in the following simulations.

Features of Vortex-Induced Vibration in Oscillatory Flow

2013 ◽  
Vol 136 (1) ◽  
Author(s):  
Shixiao Fu ◽  
Jungao Wang ◽  
Rolf Baarholm ◽  
Jie Wu ◽  
C. M. Larsen
Keyword(s):  
Wavelet Transformation ◽  
Oscillatory Flow ◽  
Cross Flow ◽  
Ocean Basin ◽  
Mode Transition ◽  
Time Sharing ◽  
Flexible Cylinder ◽  
Vortex Induced Vibration ◽  
Flow Features ◽  
Lock In

Vortex-induced vibration (VIV) in oscillatory flow is experimentally investigated in the ocean basin. The test flexible cylinder was forced to harmonically oscillate in various combinations of amplitude and period with Keulegan-Carpenter (KC) number between 26 and 178 in three different maximum reduced velocities, URmax=4, URmax=6.5, and URmax=7.9 separately. VIV responses at cross-flow (CF) direction are investigated using modal decomposition and wavelet transformation. The results show that VIV in oscillatory flow is quite different from that in steady flow; features, such as intermittent VIV, hysteresis, amplitude modulation, and mode transition (time sharing) are observed. Moreover, a VIV developing process including “building-up,” “lock-in,” and “dying-out” in oscillatory flow, is further proposed and analyzed.

An experimental investigation of vortex-induced vibration of a curved flexible cylinder

2021 ◽  
Vol 927 ◽  
Author(s):  
Banafsheh Seyed-Aghazadeh ◽  
Bridget Benner ◽  
Xhino Gjokollari ◽  
Yahya Modarres-Sadeghi
Keyword(s):  
Vortex Shedding ◽  
Flow Direction ◽  
Cross Flow ◽  
Mode Number ◽  
Radius Of Curvature ◽  
Mode Transition ◽  
Flexible Cylinder ◽  
Number Range ◽  
Vortex Induced Vibration ◽  
The Cross

Vortex-induced vibration of a curved flexible cylinder placed in the test section of a recirculating water tunnel and fixed at both ends is studied experimentally. Both the concave and the convex orientations (with respect to the incoming flow direction) are considered. The cylinder was hung by its own weight with a dimensionless radius of curvature of $R/D=66$ , and a low mass ratio of $m^{*} = 3.6$ . A high-speed imaging technique was employed to record the oscillations of the cylinder in the cross-flow direction for a reduced velocity range of $U^{*} = 3.7 - 48.4$ , corresponding to a Reynolds number range of $Re= 165 - 2146$ . Mono- and multi-frequency responses as well as transition from low-mode-number to high-mode-number oscillations were observed. Regardless of the type of curvature, both odd and even mode shapes were excited in the cross-flow directions. However, the response of the system, in terms of the excited modes, amplitudes and frequencies of the oscillations, was observed to be sensitive to the direction of the curvature (i.e. concave vs convex), in particular at higher reduced velocities, where mode transition occurred. Hydrogen bubble flow visualization exhibited highly three-dimensional vortex shedding patterns in the wake of the cylinder, where there existed spatial and temporal evolution of the vortex shedding modes along the length of the cylinder. The time-varying intermittent vortex shedding in the wake of the cylinder was linked to the spanwise travelling wave behaviour of the vortex-induced vibration response. The observed spatially altering wake corresponded to the multi-modal excitation and mode transition along the length of the cylinder.

scholarly journals Vortex-induced vibrations of a long flexible cylinder in shear flow

2011 ◽  
Vol 677 ◽  
pp. 342-382 ◽  
Author(s):  
REMI BOURGUET ◽  
GEORGE E. KARNIADAKIS ◽  
MICHAEL S. TRIANTAFYLLOU
Keyword(s):  
Shear Flow ◽  
Vortex Shedding ◽  
Cross Flow ◽  
Maximum Velocity ◽  
Travelling Wave ◽  
Transition To Turbulence ◽  
Wave Component ◽  
Flexible Cylinder ◽  
Vortex Induced Vibrations ◽  
Lock In

We investigate the in-line and cross-flow vortex-induced vibrations of a long cylindrical tensioned beam, with length to diameter ratio L/D = 200, placed within a linearly sheared oncoming flow, using three-dimensional direct numerical simulation. The study is conducted at three Reynolds numbers, from 110 to 1100 based on maximum velocity, so as to include the transition to turbulence in the wake. The selected tension and bending stiffness lead to high-wavenumber vibrations, similar to those encountered in long ocean structures. The resulting vortex-induced vibrations consist of a mixture of standing and travelling wave patterns in both the in-line and cross-flow directions; the travelling wave component is preferentially oriented from high to low velocity regions. The in-line and cross-flow vibrations have a frequency ratio approximately equal to 2. Lock-in, the phenomenon of self-excited vibrations accompanied by synchronization between the vortex shedding and cross-flow vibration frequencies, occurs in the high-velocity region, extending across 30% or more of the beam length. The occurrence of lock-in disrupts the spanwise regularity of the cellular patterns observed in the wake of stationary cylinders in shear flow. The wake exhibits an oblique vortex shedding pattern, inclined in the direction of the travelling wave component of the cylinder vibrations. Vortex splittings occur between spanwise cells of constant vortex shedding frequency. The flow excites the cylinder under the lock-in condition with a preferential in-line versus cross-flow motion phase difference corresponding to counter-clockwise, figure-eight orbits; but it damps cylinder vibrations in the non-lock-in region. Both mono-frequency and multi-frequency responses may be excited. In the case of multi-frequency response and within the lock-in region, the wake can lock in to different frequencies at various spanwise locations; however, lock-in is a locally mono-frequency event, and hence the flow supplies energy to the structure mainly at the local lock-in frequency.

Sign in / Sign up

Export Citation Format

Share Document