Cross-flow vortex induced vibrations of inclined helically straked circular cylinders: An experimental study

2015 ◽  
Vol 59 ◽  
pp. 178-201 ◽  
Author(s):  
M. Zeinoddini ◽  
A. Farhangmehr ◽  
M.S. Seif ◽  
A.P. Zandi
Keyword(s):  
Experimental Study ◽  
Cross Flow ◽  
Circular Cylinders ◽  
Vortex Induced Vibrations ◽  
Flow Vortex

VIV Response and Drag Measurements of Circular Cylinders Fitted With Permeable Meshes

2015 ◽  
Author(s):  
Murilo M. Cicolin ◽  
Gustavo R. S. Assi
Keyword(s):  
Reynolds Number ◽  
Long Range ◽  
Flow Direction ◽  
Cross Flow ◽  
Circular Cylinders ◽  
Peak Response ◽  
Vortex Induced Vibrations ◽  
Different Types ◽  
Cylindrical Tubes ◽  
Low Mass

Experiments have been carried out on models of rigid circular cylinders fitted with three different types of permeable meshes to investigate their effectiveness in the suppression of vortex-induced vibrations (VIV). Measurements of amplitude of vibration and drag force are presented for models with low mass and damping which are free to respond in the cross-flow direction. Results for two meshes made of ropes and cylindrical tubes are compared with the VIV response of a bare cylinder and that of a known suppressor called the “ventilated trousers” (VT). All three meshes achieved an average 50% reduction of the peak response when compared with that of the bare cylinder. The sparse mesh configuration presented a similar behaviour to the VT, while the dense mesh produced considerable VIV response for an indefinitely long range of reduced velocity. All the three meshes have increased drag when compared with that of the bare cylinder. Reynolds number ranged from 5,000 to 25,000 and reduced velocity was varied between 2 and 15.

Forced Vibration Tests for In-Line Vortex-Induced Vibration to Assess Partially Strake-Covered Pipeline Spans

2020 ◽  
Vol 143 (3) ◽  
Author(s):  
Jie Wu ◽  
Decao Yin ◽  
Elizabeth Passano ◽  
Halvor Lie ◽  
Ralf Peek ◽  
...  
Keyword(s):  
Forced Vibration ◽  
Hydrodynamic Force ◽  
Cross Flow ◽  
Added Mass ◽  
Vortex Induced Vibrations ◽  
Helical Strakes ◽  
Vibration Tests ◽  
Flow Vortex ◽  
Hydrodynamic Data ◽  
Mass Functions

Abstract Helical strakes can suppress vortex-induced vibrations (VIVs) in pipelines spans and risers. Pure in-line (IL) VIV is more of a concern for pipelines than for risers. To make it possible to assess the effectiveness of partial strake coverage for this case, an important gap in the hydrodynamic data for strakes is filled by the reported IL forced-vibration tests. Therein, a strake-covered rigid cylinder undergoes harmonic purely IL motion while subject to a uniform “flow” created by towing the test rig along SINTEF Ocean's towing tank. These tests cover a range of frequencies, and amplitudes of the harmonic motion to generate added-mass and excitation functions are derived from the in-phase and 90 deg out-of-phase components of the hydrodynamic force on the pipe, respectively. Using these excitation- and added-mass functions in VIVANA together with those from experiments on bare pipe by Aronsen (2007 “An Experimental Investigation of In-Line and Combined In-Line and Cross-Flow Vortex Induced Vibrations,” Ph.D. thesis, Norwegian University of Science and Technology, Trondheim, Norway.), the IL VIV response of partially strake-covered pipeline spans is calculated. It is found that as little as 10% strake coverage at the optimal location effectively suppresses pure IL VIV.

Improved In-Line Vortex-Induced Vibrations Prediction for Combined In-Line and Cross-Flow Vortex-Induced Vibrations Responses

2017 ◽  
Vol 140 (3) ◽  
Author(s):  
Decao Yin ◽  
Elizabeth Passano ◽  
Carl M. Larsen
Keyword(s):  
Cross Flow ◽  
Hydrodynamic Coefficients ◽  
Marine Structures ◽  
Flexible Pipe ◽  
Flexible Beams ◽  
Forced Motion ◽  
Pipe Model ◽  
Vortex Induced Vibrations ◽  
Flow Vortex ◽  
Semi Empirical

Slender marine structures are subjected to ocean currents, which can cause vortex-induced vibrations (VIV). Accumulated damage due to VIV can shorten the fatigue life of marine structures, so it needs to be considered in the design and operation phase. Semi-empirical VIV prediction tools are based on hydrodynamic coefficients. The hydrodynamic coefficients can either be calculated from experiments on flexible beams by using inverse analysis or theoretical methods, or obtained from forced motion experiments on a circular cylinder. Most of the forced motion experiments apply harmonic motions in either in-line (IL) or crossflow (CF) direction. Combined IL and CF forced motion experiments are also reported. However, measured motions from flexible pipe VIV tests contain higher order harmonic components, which have not yet been extensively studied. This paper presents results from conventional forced motion VIV experiments, but using measured motions taken from a flexible pipe undergoing VIV. The IL excitation coefficients were used by semi-empirical VIV prediction software vivana to perform combined IL and CF VIV calculation. The key IL results are compared with Norwegian Deepwater Programme (NDP) flexible pipe model test results. By using present IL excitation coefficients, the prediction of IL responses for combined IL and CF VIV responses is improved.

The Numerical Research of Two-Degrees-of-Freedom Vortex-Induced Vibrations of Circular Cylinders

2012 ◽  
Vol 204-208 ◽  
pp. 4598-4601
Author(s):  
Jie Li Fan ◽  
Wei Ping Huang
Keyword(s):  
Degrees Of Freedom ◽  
Amplitude Ratio ◽  
Flow Direction ◽  
Cross Flow ◽  
Circular Cylinders ◽  
Two Degrees Of Freedom ◽  
Line Frequency ◽  
Ansys Cfx ◽  
Vortex Induced Vibrations ◽  
Lock In

The two-degrees-of-freedom of vortex-induced vibration of circular cylinders is numerically simulated with the software ANSYS/CFX. The VIV characteristic, in the two different conditions (A/D=0.07 and A/D=1.0), is analyzed. When A/D is around 0.07, the amplitude ratio of the cylinder’s VIV between in-line and cross-flow direction in the lock-in is lower than that in the lock-out. The in-line frequency is twice of that in cross-flow direction in the lock-out, but in the lock-in, it is the same as that in cross-flow direction and the same as that of lift force. When A/D is around 1.0, the amplitude ratio of the VIV between in-line and cross-flow in the lock-in is obviously larger than that in the lock-out. Both in the lock-in and in the lock-out, the in-line frequency is twice of that in cross-flow direction.

scholarly journals Phasing mechanisms between the in-line and cross-flow vortex-induced vibrations of a long tensioned beam in shear flow

2013 ◽  
Vol 122 ◽  
pp. 155-163 ◽  
Author(s):  
Rémi Bourguet ◽  
George Em Karniadakis ◽  
Michael S. Triantafyllou
Keyword(s):  
Shear Flow ◽  
Cross Flow ◽  
Vortex Induced Vibrations ◽  
Flow Vortex
Sign in / Sign up

Export Citation Format

Share Document