scholarly journals Application of UV–Visible Light Absorption and Scattering technique to low absorption fuels under diesel-like conditions

Fuel ◽  
2016 ◽  
Vol 179 ◽  
pp. 258-266 ◽  
Author(s):  
J.V. Pastor ◽  
J.M. García-Oliver ◽  
J.J. López ◽  
C. Micó
RSC Advances ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 4935-4941
Author(s):  
Riza Ariyani Nur Khasanah ◽  
Hui-Ching Lin ◽  
Hsiang-Yun Ho ◽  
Yen-Ping Peng ◽  
Tsong-Shin Lim ◽  
...  

Cu2O/TNA/Ti photoanode showed spectral response outperformed Cu2O/Ti and Cu2O/FTO photocathodes. Cu2O/TNA/Ti showed better spectral response than that of TNA/Ti, ascribed to UV-visible light absorption of Cu2O, not to charge separation enhancement.


2017 ◽  
Vol 96 (16) ◽  
Author(s):  
C. S. Praveen ◽  
Lorenzo Maschio ◽  
Michel Rérat ◽  
V. Timon ◽  
M. Valant

Fuel ◽  
2012 ◽  
Vol 98 ◽  
pp. 164-175 ◽  
Author(s):  
Ulugbek Azimov ◽  
Nobuyuki Kawahara ◽  
Eiji Tomita

2017 ◽  
Vol 735 ◽  
pp. 185-188 ◽  
Author(s):  
Zhen Yin Hai ◽  
Jian Gong Du ◽  
Chen Yang Xue ◽  
Dan Feng Cui ◽  
Mohammad Karbalaei Akbari ◽  
...  

A facile doping method utilizing inexpensive raw materials was proposed to achieve variation in optical bandgap and UV-visible light absorption property of MoS2 nanosheets. Carbon-assistant heating with degreasing cotton has demonstrated the development of carbon-doped MoS2 nanosheets with enhanced rich defects. The results obtained shown that modified MoS2 nanosheets with the lateral width of ~600 nm are exhibited shift of the intensively blue peaks of photo-luminescence (PL) comparing to those MoS2 nanosheets with a lateral dimension of larger than 1 μm. Optical bandgap of the carbon-doped MoS2 nanosheets was found to be broader than that of the pure MoS2 nanosheets and the prepared samples also exhibited a broadband UV-visible light absorption property.


1998 ◽  
Vol 13 (3) ◽  
pp. 604-609 ◽  
Author(s):  
Wu Xiaochun ◽  
Wang Rongyao ◽  
Zou Bingsuo ◽  
Wang Li ◽  
Liu Shaomei ◽  
...  

In this paper, nanometer-sized CdO organosol was prepared by using microemulsion methods. Its electronic structure and optical properties are characterized through UV-visible light absorption, photoluminescence, and Z-scan techniques. Some newfeatures were observed. Fluorescence and nonlinear optical responses are mainly related to surface trapped states.


Author(s):  
David Maria Tobaldi ◽  
Luc Lajaunie ◽  
ana caetano ◽  
nejc rozman ◽  
Maria Paula Seabra ◽  
...  

<div>Titanium dioxide is by far the most utilised semiconductor material for photocatalytic applications. Still, it is transparent to visible-light. Recently, it has been proved that a type-II band alignment for the rutile−anatase mixture would improve its visible-light absorption.</div><div>In this research paper we thoroughly characterised the real crystalline and amorphous phases of synthesised titanias – thermally treated at different temperatures to get distinct ratios of anatase-rutile-amorphous fraction – as well as that of three commercially available photocatalytic nano-TiO2. </div><div>The structural characterisation was done via advanced X-ray diffraction method, namely the Rietveld-RIR method, to attain a full quantitative phase analysis of the specimens. The microstructure was also investigated via an advanced X-ray method, the whole powder pattern modelling. These methods were validated combining advanced aberration-corrected scanning transmission microscopy and high-resolution electron energy-loss spectroscopy. The photocatalytic activity was assessed in the liquid- and gas-solid phase (employing rhodamine B and 4-chlorophenol, and isopropanol, respectively, as the organic substances to degrade) using a light source irradiating exclusively in the visible-range.</div><div>Optical spectroscopy showed that even a small fraction of rutile (2 wt%) is able to shift to lower energies the apparent optical band gap of an anatase-rutile mixed phase. But is this enough to attain a real photocatalytic activity promoted by merely visible-light?</div><div>We tried to give a reply to that question.</div><div>Photocatalytic activity results in the liquid-solid phase showed that a high surface hydroxylation led to specimen with superior visible light-induced catalytic activity (i.e. dye and ligand-to-metal charge transfer complexes sensitisation effects). That is: not photocatalysis <i>sensu-strictu</i>.</div><div>On the other hand, the gas-solid phase results showed that a higher amount of the rutile fraction (around 10 wt%), together with less recombination of the charge carriers, were more effective for an actual photocatalytic oxidation of isopropanol.</div>


2019 ◽  
Vol 2 (10) ◽  
pp. 7518-7526 ◽  
Author(s):  
Hanggara Sudrajat ◽  
Mitsunori Kitta ◽  
Nobuyuki Ichikuni ◽  
Hiroshi Onishi

Author(s):  
Xin Zou ◽  
Xueyang Han ◽  
Chengxiong Wang ◽  
Yunkun Zhao ◽  
Chun Du ◽  
...  

Ta3N5 is regarded as a promising candidate material with adequate visible light absorption and band structure for photoelectrochemical water splitting. However, the performance of Ta3N5 is severely limited by the...


Sign in / Sign up

Export Citation Format

Share Document