Multi-criteria evaluation of energy storage technologies based on hesitant fuzzy information: A case study for Turkey

2020 ◽  
Vol 28 ◽  
pp. 101211 ◽  
Author(s):  
Murat Çolak ◽  
İhsan Kaya
Keyword(s):  
Energy Storage ◽  
Fuzzy Information ◽  
Multi Criteria Evaluation ◽  
Storage Technologies

An Alaska case study: Energy storage technologies

2017 ◽  
Vol 9 (6) ◽  
pp. 061708 ◽  
Author(s):  
Jeremy VanderMeer ◽  
Marc Mueller-Stoffels ◽  
Erin Whitney
Keyword(s):  
Energy Storage ◽  
Storage Technologies

scholarly journals Short-run impact of electricity storage on CO2 emissions in power systems with high penetrations of wind power: A case-study of Ireland

2016 ◽  
Vol 231 (6) ◽  
pp. 590-603 ◽  
Author(s):  
Eoghan McKenna ◽  
John Barton ◽  
Murray Thomson
Keyword(s):  
Energy Storage ◽  
Power Systems ◽  
Wind Power ◽  
Carbon Emissions ◽  
Study Data ◽  
System Stability ◽  
Short Run ◽  
Storage Technologies ◽  
The Impact

This article studies the impact on CO2 emissions of electrical storage systems in power systems with high penetrations of wind generation. Using the Irish All-Island power system as a case-study, data on the observed dispatch of each large generator for the years 2008 to 2012 was used to estimate a marginal emissions factor of 0.547 kgCO2/kWh. Selected storage operation scenarios were used to estimate storage emissions factors – the carbon emissions impact associated with each unit of storage energy used. The results show that carbon emissions increase in the short-run for all storage technologies when consistently operated in ‘peak shaving and trough filling’ modes, and indicate that this should also be true for the GB and US power systems. Carbon emissions increase when storage is operated in ‘wind balancing’ mode, but reduce when storage is operated to reduce wind power curtailment, as in this case wind power operates on the margin. For power systems where wind is curtailed to maintain system stability, the results show that energy storage technologies that provide synthetic inertia achieve considerably greater carbon reductions. The results highlight a tension for policy makers and investors in storage, as scenarios based on the operation of storage for economic gains increase emissions, while those that decrease emissions are unlikely to be economically favourable. While some scenarios indicate storage increases emissions in the short-run, these should be considered alongside long-run assessments, which indicate that energy storage is essential to the secure operation of a fossil fuel-free grid.

scholarly journals A General Model for Estimating Emissions from Integrated Power Generation and Energy Storage. Case Study: Integration of Solar Photovoltaic Power and Wind Power with Batteries

Processes ◽  
2018 ◽  
Vol 6 (12) ◽  
pp. 267 ◽  
Author(s):  
Ian Miller ◽  
Emre Gençer ◽  
Francis O’Sullivan
Keyword(s):  
Power Generation ◽  
Energy Storage ◽  
Wind Power ◽  
Ghg Emissions ◽  
Lithium Ion ◽  
Storage Technology ◽  
Renewable Power ◽  
Variable Nature ◽  
Storage Technologies

The penetration of renewable power generation is increasing at an unprecedented pace. While the operating greenhouse gas (GHG) emissions of photovoltaic (PV) and wind power are negligible, their upstream emissions are not. The great challenge with the deployment of renewable power generators is their intermittent and variable nature. Current electric power systems balance these fluctuations primarily using natural gas fired power plants. Alternatively, these dynamics could be handled by the integration of energy storage technologies to store energy during renewable energy availability and discharge when needed. In this paper, we present a model for estimating emissions from integrated power generation and energy storage. The model applies to emissions of all pollutants, including greenhouse gases (GHGs), and to all storage technologies, including pumped hydroelectric and electrochemical storage. As a case study, the model is used to estimate the GHG emissions of electricity from systems that couple photovoltaic and wind generation with lithium-ion batteries (LBs) and vanadium redox flow batteries (VFBs). To facilitate the case study, we conducted a life cycle assessment (LCA) of photovoltaic (PV) power, as well as a synthesis of existing wind power LCAs. The PV LCA is also used to estimate the emissions impact of a common PV practice that has not been comprehensively analyzed by LCA—solar tracking. The case study of renewables and battery storage indicates that PV and wind power remain much less carbon intensive than fossil-based generation, even when coupled with large amounts of LBs or VFBs. Even the most carbon intensive renewable power analyzed still emits only ~25% of the GHGs of the least carbon intensive mainstream fossil power. Lastly, we find that the pathway to minimize the GHG emissions of power from a coupled system depends upon the generator. Given low-emission generation (<50 gCO2e/kWh), the minimizing pathway is the storage technology with lowest production emissions (VFBs over LBs for our case study). Given high-emission generation (>200 gCO2e/kWh), the minimizing pathway is the storage technology with highest round-trip efficiency (LBs over VFBs).

scholarly journals Electrical and Energy Systems Integration for Maritime Environment-Friendly Transportation

Energies ◽  
2021 ◽  
Vol 14 (21) ◽  
pp. 7240
Author(s):  
Andrea Vicenzutti ◽  
Giorgio Sulligoi
Keyword(s):  
Energy Storage ◽  
Environmental Performance ◽  
Energy Systems ◽  
Electrical Energy ◽  
Marine Transportation ◽  
Environment Friendly ◽  
Storage Technologies ◽  
Port Infrastructure ◽  
Maritime Environment

The policies against climate change require the reduction of greenhouse gas emissions of marine transportation. To reach the planned goals, the most promising approach is working both on ships improvement and ports redesign. The latter must enable the new green ships supply with sustainable electrical energy, by integrating shore connection systems, local renewables, and energy storage systems. In this paper, a methodology to obtain such an objective is proposed, capable of taking into account both ships’ and ports’ characteristics. The methodology workflow is explained through a case study, where two shore connection power sizes and two different operative approaches for recharging the ship onboard energy storage are considered. A discussion about the most suitable energy storage technologies is also provided. The case study shows how the methodology can be applied, as well as demonstrating that the port infrastructure has a direct effect on the ship environmental performance.

An overview of cost-effective energy storage technologies

2020 ◽  
Vol 1 (1) ◽  
pp. 110-115
Author(s):  
Sayed Belal Hashimi ◽  
Hameedullah Zaheb ◽  
Najib Rahman Sabory
Keyword(s):  
Energy Storage ◽  
Cost Effective ◽  
Effective Energy ◽  
Storage Technologies

Site Suitability Analysis for Water Conservation Using AHP and GIS Techniques: A Case Study of Upper Sina River Catchment, Ahmednagar (India)

2020 ◽  
Vol 3 (2) ◽  
pp. 49-59 ◽  
Author(s):  
Yogesh Badhe ◽  
Ravindra Medhe ◽  
Tushar Shelar
Keyword(s):  
Water Conservation ◽  
Soil Depth ◽  
Land Use Land Cover ◽  
Suitability Analysis ◽  
Site Suitability ◽  
Gis Techniques ◽  
Multi Criteria Evaluation ◽  
Conservation Activity ◽  
Suitable Site

The site suitability for construction of water conservation structures is an important step towards groundwater conservation in arid and semi-arid regions. Water is the most crucial for maintaining an environment and ecosystem which is helpful to sustaining all forms of the life. The increasing water scarcity day to day has been one of the common problems over a period of time. On top of it, when the area is a part of rain shadow zone like Ahmednagar district, water conservation activities are become more important. The present study aims to identify the suitable zones for water conservation activity. Multi- criteria evaluation is carried out using Geographic Information System (GIS) techniques to help the choice makers in defining suitable site for construction of water conservation structures. Different layers which were considered for multi-criteria evaluation: slope, land use land cover, soil texture, lithology, soil depth, soil erosion, wells, lineaments and drainage network. Analytical Hierarchy Processes (AHP) is used for weighted sum to find suitable sites for implementation of water conservation activity using selected criterions. The site suitability map was classified into four classes: highly suitable, moderately suitable, less suitable and not suitable with area of 19.19%, 26%, 49.03% and 5.78, respectively. This map will help for selection of suitable sites for construction of Mati Nala Bund (MNB), Check Dam, Cement Nala Bund (CNB) and Continuous Contour Trenches (CCT) for conservation of groundwater resource in the region.

Sign in / Sign up

Export Citation Format

Share Document