Unseating mechanism of a skew bridge with seat-type abutments and a Simplified Method for estimating its support length requirement

2019 ◽  
Vol 191 ◽  
pp. 194-205 ◽  
Author(s):  
Suiwen Wu
Keyword(s):  
Skew Bridge ◽  
Simplified Method ◽  
Support Length

scholarly journals Study on the additional support length requirements of single-span bridges due to skew using a simplified method

2021 ◽  
Vol 2 (1) ◽  
Author(s):  
Suiwen Wu ◽  
Junfeng Jia ◽  
Chiyu Jiao ◽  
Junfei Huang ◽  
Jianzhong Li
Keyword(s):  
Aspect Ratio ◽  
Response Spectrum ◽  
Skew Angle ◽  
Empirical Formulas ◽  
Design Response Spectrum ◽  
Skew Bridges ◽  
Simplified Method ◽  
Additional Support ◽  
Linear Manner ◽  
Support Length

AbstractSkew bridges with seat-type abutments are frequently unseated in earthquakes due to large transverse displacements at their acute corners. It is believed these large displacements are due to in-plane rotation of the superstructure. Lack of detailed guidelines for modeling of skew bridges, many current design codes give empirical expressions rather than theoretical solutions for the additional support length required in skew bridges to prevent unseating. In this paper, a parametric study has been carried out to study the influence of skew angle, aspect ratio and fundamental periods of bridges on the additional support length requirements of single-span bridges due to skew using a shake table experiment validated Simplified Method, which is capable of simulating gap closure based on response spectrum analysis. This method is developed based on the premise that the obtuse corner of the superstructure engages the adjacent back wall during lateral loading and rotates about this corner until the loading reverses direction. A design response spectrum specified in AASHTO LRFD Specifications was employed to represent the design-level earthquakes. The results show the additional length required to prevent unseating due to skew increases with the skew angle in an approximately linear manner when the angle is less than a critical value and decreases for angles above this value. This critical skew angle increases with the aspect ratio approximately in a linear manner and shows negligible dependence on the fundamental periods of the bridges, and combination of span length and width. In addition, the critical skew angle varies between 58° and 66°, when the aspect ratio is varied from 3.0 to 5.0. The results also show that the empirical formulas for minimum support length requirements of skew bridges in current codes and specifications can not accurately reflect the influence of skew.

A simplified method of emulsion coating and development for quantitative electron microscopic radioautography

1978 ◽  
Vol 36 (2) ◽  
pp. 64-65
Author(s):  
K. Yoshida ◽  
F. Murata ◽  
S. Ohno ◽  
T. Nagata
Keyword(s):  
Mass Production ◽  
Identical Condition ◽  
Microscopic Level ◽  
Electron Microscopic Level ◽  
Electron Microscopic ◽  
Simplified Method ◽  
Complicated Process ◽  
Critical Problems ◽  
Electron Microscopic Radioautography ◽  
Quantitative Radioautography

IntroductionSeveral methods of mounting emulsion for radioautography at the electron microscopic level have been reported. From the viewpoint of quantitative radioautography, however, there are many critical problems in the procedure to produce radioautographs. For example, it is necessary to apply and develop emulsions in several experimental groups under an identical condition. Moreover, it is necessary to treat a lot of grids at the same time in the dark room for statistical analysis. Since the complicated process and technical difficulties in these procedures are inadequate to conduct a quantitative analysis of many radioautographs at once, many factors may bring about unexpected results. In order to improve these complicated procedures, a simplified dropping method for mass production of radioautographs under an identical condition was previously reported. However, this procedure was not completely satisfactory from the viewpoint of emulsion homogeneity. This paper reports another improved procedure employing wire loops.

Rate of Sublimation of Ice by Radiative Heating in Freeze-Etching

1980 ◽  
Vol 38 ◽  
pp. 618-619
Author(s):  
Yeshayahu Talmon
Keyword(s):  
Heat Flux ◽  
Freeze Fracture ◽  
Constant Heat Flux ◽  
Radiative Heating ◽  
Constant Heat ◽  
Entire Sample ◽  
Simplified Method ◽  
Freeze Etching ◽  
Sublimation Rates ◽  
Fractured Surface

To bring out details in the fractured surface of a frozen sample in the freeze fracture/freeze-etch technique,the sample or part of it is warmed to enhance water sublimation.One way to do this is to raise the temperature of the entire sample to about -100°C to -90°C. In this case sublimation rates can be calculated by using plots such as Fig.1 (Talmon and Thomas),or by simplified formulae such as that given by Menold and Liittge. To achieve higher rates of sublimation without heating the entire sample a radiative heater can be used (Echlin et al.). In the present paper a simplified method for the calculation of the rates of sublimation under a constant heat flux F [W/m2] at the surface of the sample from a heater placed directly above the sample is described.

516: A Simplified Method to Estimate the Absolute Renal Uptake of 99MTC-DMSA: Evaluation with a New Model using the Radioactivity of Nephrectomy Specimens as Reference

2005 ◽  
Vol 173 (4S) ◽  
pp. 140-141
Author(s):  
Mariana Lima ◽  
Celso D. Ramos ◽  
Sérgio Q. Brunetto ◽  
Marcelo Lopes de Lima ◽  
Carla R.M. Sansana ◽  
...  
Keyword(s):  
New Model ◽  
Renal Uptake ◽  
Simplified Method ◽  
The Absolute

Dosimetry with 188Re-labelled monoclonal anti-CD66 antibodies

2006 ◽  
Vol 45 (03) ◽  
pp. 134-138 ◽  
Author(s):  
T. Kull ◽  
N. M. Blumstein ◽  
D. Bunjes ◽  
B. Neumaier ◽  
A. K. Buck ◽  
...  
Keyword(s):  
Monoclonal Antibody ◽  
Bone Marrow ◽  
Gamma Camera ◽  
Absorbed Dose ◽  
Correlation Coefficients ◽  
Residence Times ◽  
Reliable Prediction ◽  
Red Bone Marrow ◽  
Antibody Preparation ◽  
Simplified Method

SummaryAim: For the therapeutic application of radiopharmaceuticals the activity is determined on an individual basis. Here we investigated the accuracy for a simplified assessment of the residence times for a 188Re-labelled anti-CD66 monoclonal antibody. Patients, methods: For 49 patients with high risk leukaemia (24 men, 25 women, age: 44 ± 12 years) the residence times were determined for the injected 188Re-labelled anti-CD66 antibodies (1.3 ± 0.4 GBq, 5–7 GBq/mg protein, >95% 188Re bound to the antibody) based on 5 measurements (1.5, 3, 20, 26, and 44 h p.i.) using planar conjugate view gamma camera images (complete method). In a simplified method the residence times were calculated based on a single measurement 3 h p.i. Results: The residence times for kidneys, liver, red bone marrow, spleen and remainder of body for the complete method were 0.4 ± 0.2 h, 1.9 ± 0.8 h, 7.8 ± 2.1 h, 0.6 ± 0.3 h and 8.6 ± 2.1 h, respectively. For all organs a linear correlation exists between the residence times of the complete method and the simplified method with the slopes (correlation coefficients R > 0.89) of 0.89, 0.99, 1.23, 1.13 and 1.09 for kidneys, liver, red bone marrow, spleen and remainder of body, respectively. Conclusion: The proposed approach allows reliable prediction of biokinetics of 188Re-labelled anti-CD66 monoclonal antibody biodistribution with a single study. Efficient pretherapeutic estimation of organ absorbed dose may be possible, provided that a more stable anti-CD66 antibody preparation is available.

EVALUATION OF A SIMPLIFIED METHOD FOR DETERMINING SERUM THYROXINE BY COMPETITIVE PROTEIN BINDING ANALYSIS

1970 ◽  
Vol 64 (4) ◽  
pp. 630-636 ◽  
Author(s):  
Stephen C. Thorson ◽  
Ronald Tsujikawa ◽  
James L. Brown ◽  
Robert T. Morrison ◽  
Hamish W. McIntosh
Keyword(s):  
Protein Binding ◽  
Clinical Application ◽  
Thyroid Status ◽  
Serum Thyroxine ◽  
Binding Analysis ◽  
Simplified Method ◽  
Competitive Protein Binding ◽  
Hypothyroid Patients

ABSTRACT Serum thyroxine concentrations were determined in 66 euthyroid, 30 hyperthyroid and 13 hypothyroid patients using both the established Murphy method and a simplified method of competitive protein binding analysis. A diagnosis compatibility of 96% was found with both methods indicating that the simplified method has comparable clinical application as an initial screen of thyroid status.

Sign in / Sign up

Export Citation Format

Share Document