Influence of hydraulic retention time on the nature of foulant organics in a high rate membrane bioreactor

Desalination ◽  
2012 ◽  
Vol 287 ◽  
pp. 116-122 ◽  
Author(s):  
Shan Hong ◽  
Rupak Aryal ◽  
S. Vigneswaran ◽  
M.A.H. Johir ◽  
J. Kandasamy
Keyword(s):  
Retention Time ◽  
Membrane Bioreactor ◽  
Hydraulic Retention Time ◽  
High Rate

Kinetic evaluation of nitrification performance in an immobilized cell membrane bioreactor

2016 ◽  
Vol 73 (12) ◽  
pp. 2904-2912 ◽  
Author(s):  
D. Güven ◽  
E. Ubay Çokgör ◽  
S. Sözen ◽  
D. Orhon
Keyword(s):  
Residence Time ◽  
Retention Time ◽  
Model Calibration ◽  
Membrane Bioreactor ◽  
Hydraulic Retention Time ◽  
Membrane Bioreactors ◽  
High Rate ◽  
Immobilized Cell ◽  
Chemical Cleaning ◽  
Kinetic Evaluation

Abstract High rate membrane bioreactor (MBR) systems operated at extremely low sludge ages (superfast membrane bioreactors (SFMBRs)) are inefficient to achieve nitrogen removal, due to insufficient retention time for nitrifiers. Moreover, frequent chemical cleaning is required due to high biomass flux. This study aims to satisfy the nitrification in SFMBRs by using sponge as carriers, leading to the extension of the residence time of microorganisms. In order to test the limits of nitrification, bioreactor was run under 52, 5 and 2 days of carrier residence time (CRT), with a hydraulic retention time of 6 h. Different degrees of nitrification were obtained for different CRTs. Sponge immobilized SFMBR operation with short CRT resulted in partial nitrification indicating selective dominancy of ammonia oxidizers. At higher CRT, simultaneous nitrification–denitrification was achieved when accompanying with oxygen limitation. Process kinetics was determined through evaluation of the results by a modeling study. Nitrifier partition in the reactor was also identified by model calibration.

Effect of 200 days' sludge retention time on performance of a pilot scale submerged membrane bioreactor for high strength industrial wastewater treatment

2006 ◽  
Vol 53 (11) ◽  
pp. 269-276 ◽  
Author(s):  
C.T. Hay ◽  
D.D. Sun ◽  
S.L. Khor ◽  
J.O. Leckie
Keyword(s):  
Retention Time ◽  
Industrial Wastewater ◽  
Membrane Bioreactor ◽  
Hydraulic Retention Time ◽  
High Strength ◽  
Pilot Scale ◽  
Submerged Membrane Bioreactor ◽  
Sludge Retention Time ◽  
Organic Removal ◽  
Sludge Concentration

A high strength industrial wastewater was treated using a pilot scale submerged membrane bioreactor (MBR) at a sludge retention time (SRT) of 200 d. The MBR was operated at a high sludge concentration of 20 g/L and a low F/M ratio of 0.11 during 300 d of operation. It was found that the MBR could achieve COD and TOC overall removal efficiencies at more than 99 and 98% TN removal. The turbidity of the permeate was consistently in the range of 0.123 to 0.136 NTU and colour254 absorbance readings varied from 0.0912 to 0.0962 a.u. cm−1. The sludge concentration was inversely proportional to the hydraulic retention time (HRT), yielded excellent organic removal and extremely low sludge production (0.0016 kgVSS/day).

scholarly journals Dynamics of Archaeal and Bacterial Communities in Response to Variations of Hydraulic Retention Time in an Integrated Anaerobic Fluidized-Bed Membrane Bioreactor Treating Benzothiazole Wastewater

Archaea ◽  
2018 ◽  
Vol 2018 ◽  
pp. 1-11 ◽  
Author(s):  
Yue Li ◽  
Qi Hu ◽  
Da-Wen Gao
Keyword(s):  
Fluidized Bed ◽  
Removal Efficiency ◽  
Retention Time ◽  
Membrane Fouling ◽  
Membrane Bioreactor ◽  
Hydraulic Retention Time ◽  
Oxygen Demand ◽  
High Strength ◽  
Service Period ◽  
Miseq Platform

An integrated anaerobic fluidized-bed membrane bioreactor (IAFMBR) was investigated to treat synthetic high-strength benzothiazole wastewater (50 mg/L) at a hydraulic retention time (HRT) of 24, 18, and 12 h. The chemical oxygen demand (COD) removal efficiency (from 93.6% to 90.9%), the methane percentage (from 70.9% to 69.27%), and the methane yield (from 0.309 m3 CH4/kg·CODremoved to 0.316 m3 CH4/kg·CODremoved) were not affected by decreasing HRTs. However, it had an adverse effect on membrane fouling (decreasing service period from 5.3 d to 3.2 d) and benzothiazole removal efficiency (reducing it from 97.5% to 82.3%). Three sludge samples that were collected on day 185, day 240, and day 297 were analyzed using an Illumina® MiSeq platform. It is striking that the dominant genus of archaea was always Methanosaeta despite of HRTs. The proportions of Methanosaeta were 80.6% (HRT 24), 91.9% (HRT 18), and 91.2% (HRT 12). The dominant bacterial genera were Clostridium in proportions of 23.9% (HRT 24), 16.4% (HRT 18), and 15.3% (HRT 12), respectively.

Sign in / Sign up

Export Citation Format

Share Document