Partial identification in the statistical matching problem

When designing radioelectronic devices, that are included in the composition of various systems, it is important to solve broadband matching problem and filtering problem. However, usually these problems are separated and not considered together. Moreover, the synthesis of filters does not take into account the behavior of impedances of the generator and the load in the stopbands. The solution of the complex problem is actual, since it allows expanding the functionality of the device, which can greatly simplify the construction of the radio engineering product. It should be noted that in the known literature solution of this problem in such a formulation is not considered. The aim of the work is to develop a synthesis method and algorithm of broadband devices that connect arbitrary immitances of the generator and the load, and these devices should perform simultaneously functions of both matching and filtering in reactive lumped electric element base and in distributed electric element base, limited only by transmission lines with T-waves. In this paper, a two-stage automated method of synthesis presented here stage allows at the first to adequately find a good initial solution to the posed problem (determining structure and parameters of the broadband matching and filtering quadrupole), in the second stage this approach allows to find the optimal solution to the complex problem, taking into account the constraints on physical and circuit realizability. In this work, the synthesis of broadband matching and filtering devices in lumped and distributed electrical element basis is carried out, and these devices connect complex impedances of the source and the load. The characteristics of the devices obtained after the synthesis show that the solution of the complex problem of matching and filtering gives a significant improvement in filtering properties with small losses in the level of transmitted power.

Download Full-text

Spectral Analysis of Stationary Signals Based on Two Simplified Arrangements of Chirp Transform Spectrometer

Electronics ◽

10.3390/electronics10010065 ◽

2020 ◽

Vol 10 (1) ◽

pp. 65

Author(s):

Quan Zhao ◽

Ling Tong ◽

Bo Gao

Keyword(s):

Spectral Analysis ◽

Frequency Conversion ◽

Frequency Resolution ◽

Matching Problem ◽

System Sensitivity ◽

Deep Space Exploration ◽

Spectrum Measurement ◽

Stationary Signals ◽

Simulation And Experiment ◽

Remote Sensing Systems

The classical two-channel push-pull chirp transform spectrometer (CTS) has been widely applied in satellite-borne remote sensing systems for earth observation and deep space exploration. In this paper, we present two simplified structures with single M(l)-C(s) CTS arrangements for the spectral analysis of stationary signals. A simplified CTS system with a single M(l)-C(s) arrangement and a time delay line was firstly developed. Another simplified structure of CTS with a M(l)-C(s) arrangement and a frequency conversion channel was also developed for spectral analysis of stationary signals. Simulation and experiment results demonstrate that the two simplified arrangements can both realize spectrum measurement for the stationary signals and obtain the same frequency resolution, amplitude accuracy and system sensitivity as that of the classical two-channel push–pull CTS system. Compared to the classical CTS structure, the two simplified arrangements require fewer devices, save power consumption and have reduced mass. The matching problem between the two channels can be avoided in the two simplified arrangements. The simplified CTS arrangements may have potential application in the spectrum measurement of stationary signals in the field of aviation and spaceflight.

Download Full-text