PIV measurements for flow pattern and void fraction in cavitating flows of He II and He I

Cryogenics ◽  
2006 ◽  
Vol 46 (9) ◽  
pp. 648-657 ◽  
Author(s):  
K. Harada ◽  
M. Murakami ◽  
T. Ishii
Keyword(s):  
Flow Pattern ◽  
Void Fraction ◽  
Cavitating Flows ◽  
Piv Measurements

Flow Pattern, Void Fraction and Pressure Drop During Adiabatic Two-Phase Gas-Liquid Flow in Vertical Micro-Channel

2012 ◽  
Author(s):  
Sira Saisorn ◽  
Somchai Wongwises
Keyword(s):  
Pressure Drop ◽  
Flow Pattern ◽  
Void Fraction ◽  
Test Section ◽  
Annular Flow ◽  
Fused Silica ◽  
Working Fluid ◽  
Micro Channel ◽  
Two Phase ◽  
Churn Flow

The experimental investigation is performed to study two-phase flow pattern, void fraction and pressure drop characteristics in a vertical micro-channel. The test section is a fused silica tube with a diameter of 0.53 mm and a length of 320 mm. Air and water are used as working fluid which is introduced to the test section in vertical upward direction. The test runs are done at superficial velocities of gas and liquid ranging respectively from 0.375 to 21.187 m/s and 0.004 to 2.436 m/s. Stereozoom microscope mounted together with camera are employed to conduct flow visualization from which slug flow, throat-annular flow, churn flow, annular flow and annular-rivulet flow are observed. Based on image analysis, void fraction data are obtained and found to be linear relationship with volumetric quality. The frictional pressure drop is relatively high when the formation of churn flow is established. Besides, the two-phase frictional multiplier is found to be strongly dependent on both mass flux and flow pattern.

CFD Simulations and PIV Measurements for Optimization of Flow Pattern in a Sieve Plate Extraction Column

2011 ◽  
Vol 391-392 ◽  
pp. 1464-1468
Author(s):  
Chang Chun Duan ◽  
Chun Jiang Liu ◽  
Xi Gang Yuan
Keyword(s):  
Flow Pattern ◽  
Reverse Flow ◽  
Continuous Phase ◽  
Extraction Column ◽  
Sieve Plate ◽  
Cfd Simulations ◽  
Flow Area ◽  
Piv Measurements ◽  
Image Velocimetry ◽  
Computational Fluid Dynamics Cfd

Present work deals with the optimization for flow pattern of continuous phase in a sieve plate extraction column using both computational fluid dynamics (CFD) simulations and particle image velocimetry (PIV) measurements. Firstly single-phase simulation was conducted for the traditional column and it was found that there was a very large reverse flow area between every two plates. Then step by step, by changing the downcomer structure, consisting of inclining downcomers, adding baffles, slotting downcomers and baffles and adjusting the number and size of slots, the reverse flow area was decreased and thereby the flow pattern of continuous phase was optimized. Finally, an optimal flow pattern was obtained with reverse flow area greatly reduced. In order to prove the validity of the simulation results, PIV experiments of two columns were carried out and it was found that the results of simulations and experiments are in good agreement.

Sign in / Sign up

Export Citation Format

Share Document