Compression Performances of Integral-Forming Aluminum Foam Sandwich

2021 ◽  
pp. 115090
Author(s):  
Zichen Zhang ◽  
Tao Xu ◽  
Wei Xin ◽  
Jian Ding ◽  
Nannan Liu ◽  
...  
Keyword(s):  
Aluminum Foam

Effect of cell size on the energy absorption of closed-cell aluminum foam

2018 ◽  
Vol 60 (6) ◽  
pp. 583-590 ◽  
Author(s):  
Jinglin Xu ◽  
Jianqing Liu ◽  
Wenbin Gu ◽  
Zhenxiong Wang ◽  
Xin Liu ◽  
...  
Keyword(s):  
Cell Size ◽  
Energy Absorption ◽  
Aluminum Foam ◽  
Closed Cell

scholarly journals Roll forming of aluminum foam immediately after precursor foaming

2021 ◽  
Vol 10 ◽  
pp. 100224
Author(s):  
Yoshihiko Hangai ◽  
Kodai Suzuki ◽  
Masataka Ohashi ◽  
Hironao Mitsugi ◽  
Kenji Amagai
Keyword(s):  
Aluminum Foam ◽  
Roll Forming

Pressure Drop Measurements for Air Flow Through Open-Cell Aluminum Foam

2004 ◽  
Author(s):  
Nihad Dukhan ◽  
Angel Alvarez
Keyword(s):  
Reynolds Number ◽  
Pressure Drop ◽  
Flow Rate ◽  
Aluminum Foam ◽  
Flow Direction ◽  
The Other ◽  
Turbulent Regime ◽  
Thick Sample ◽  
Open Cell ◽  
Two Samples

Wind-tunnel pressure drop measurements for airflow through two samples of forty-pore-per-inch commercially available open-cell aluminum foam were undertaken. Each sample’s cross-sectional area perpendicular to the flow direction measured 10.16 cm by 24.13 cm. The thickness in the flow direction was 10.16 cm for one sample and 5.08 cm for the other. The flow rate ranged from 0.016 to 0.101 m3/s for the thick sample and from 0.025 to 0.134 m3/s for the other. The data were all in the fully turbulent regime. The pressure drop for both samples increased with increasing flow rate and followed a quadratic behavior. The permeability and the inertia coefficient showed some scatter with average values of 4.6 × 10−8 m2 and 2.9 × 10−8 m2, and 0.086 and 0.066 for the thick and the thin samples, respectively. The friction factor decayed with the Reynolds number and was weakly dependent on the Reynolds number for Reynolds number greater than 35.

Mechanical strength improvement of aluminum foam-reinforced matrix for molten carbonate fuel cells

2017 ◽  
Vol 42 (25) ◽  
pp. 16235-16243 ◽  
Author(s):  
Mihui Lee ◽  
Chang-Whan Lee ◽  
Hyung-Chul Ham ◽  
Jonghee Han ◽  
Sung Pil Yoon ◽  
...  
Keyword(s):  
Fuel Cells ◽  
Mechanical Strength ◽  
Aluminum Foam ◽  
Molten Carbonate ◽  
Molten Carbonate Fuel Cells ◽  
Strength Improvement
Sign in / Sign up

Export Citation Format

Share Document