This paper presents an experimental program conducted to investigate the flexural performance of RC beams with tension reinforcement lap splice strengthened using externally bonded FRP different techniques in splice region. The specimens were reinforced on the tension side with four deformed bars spliced at mid span. The tested beams are of 3200 mm total length and 250*120 mm cross section, tested in positive bending. The considered parameters were splice length, type of FRP (glass or carbon), strengthening techniques in splice region (externally confine strips around cross section, Near Surface Mounted technique "NSM" stirrups, externally bonded sheets or bars on the tension face, number of GFRP strips layers (one layer, two layers, and three layers), and shape of NSM stirrups (Box or U shape). No additional anchorage mechanism or bonding methodology was applied for the FRP strips on the concrete except the epoxy adhesive. The effect of these factors on the failure of modes, the ultimate load, the bond strength and that the ductility were investigated. The results indicated that all applied strengthening techniques were efficient in improving the bond strength of the lap splices, the ductility, and the load-deflection behavior of the tested beams, especially when strips were installed over the splice region. This study approved that NSM technique gave more prominent simplicity of employ.
Effect of groove spacing on bond strength of near-surface mounted (NSM) bonded joints with multiple FRP strips