The effect of surface tension on phase distribution of two-phase flow in a micro-T-junction

2011 ◽  
Vol 66 (17) ◽  
pp. 3962-3968 ◽  
Author(s):  
Kui He ◽  
Shuangfeng Wang ◽  
Jianzhen Huang
Keyword(s):  
Surface Tension ◽  
Two Phase Flow ◽  
Phase Distribution ◽  
Phase Flow ◽  
Two Phase ◽  
Effect Of Surface

Numerical Investigation of Two-Phase Flow Over Unglazed Plate Collector Covered With Porous Material of Wire Screen for Solar Water Heater Application

2018 ◽  
Vol 141 (3) ◽  
Author(s):  
T. Salameh ◽  
Y. Zurigat ◽  
A. Badran ◽  
C. Ghenai ◽  
M. El Haj Assad ◽  
...  
Keyword(s):  
Surface Tension ◽  
Porous Material ◽  
Water Flow ◽  
Two Phase Flow ◽  
Volume Fraction ◽  
Phase Flow ◽  
Two Phase ◽  
Solar Water ◽  
Wire Screen ◽  
Effect Of Surface

This paper presents three-dimensional numerical simulation results of the effect of surface tension on two-phase flow over unglazed collector covered with a wire screen. The homogenous model is used to simulate the flow with and without the effect of porous material of wire screen and surface tension. The Eulerian-Eulerian multiphase flow approach was used in this study. The phases are completely stratified, the interphase is well defined (free surface flow), and interphase transfer rate is very large. The liquid–solid interface, gas–liquid interface, and the volume fraction for both phases were considered as boundaries for this model. The results show that the use of porous material of wire screen will reduce the velocity of water flow and help the water flow to distribute evenly over unglazed plate collector. The possibility of forming any hot spot region on the surface was reduced. The water velocity with the effect of surface tension was found higher than the one without this effect, due to the extra momentum source added by surface tension in longitudinal direction. The use of porous material of wires assures an evenly distribution flow velocity over the inclined plate, therefore helps a net enhancement of heat transfer mechanism for unglazed solar water collector application.

Effect of Surface Tension on Flow Pattern in Counter-Current Gas-Liquid Two-Phase Flow in an Inclined Pipe

2004 ◽  
Vol 2004.42 (0) ◽  
pp. 369-370
Author(s):  
Deendarlianto ◽  
Masafumi Konishi ◽  
Akiharu Ousaka ◽  
Akira Kariyasaki ◽  
Koji Kusano
Keyword(s):  
Surface Tension ◽  
Flow Pattern ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Inclined Pipe ◽  
Counter Current ◽  
Effect Of Surface

Experimental Investigation of the Effect of Surface Tension and the Correlation on Void Fraction and Frictional Pressure Drop of an Air-Liquid Two-Phase Flow in a Horizontal Flat Capillary Rectangular Channel

2003 ◽  
Author(s):  
Hideo Ide ◽  
Tohru Fukano
Keyword(s):  
Surface Tension ◽  
Pressure Drop ◽  
Void Fraction ◽  
Two Phase Flow ◽  
Rectangular Channel ◽  
Surfactant Solution ◽  
Phase Flow ◽  
Two Phase ◽  
Frictional Pressure Drop ◽  
Effect Of Surface

Air-liquid two-phase flow in a horizontal flat capillary rectangular channel has been studied to clarify the effects of concentration of surfactant solution on the flow phenomena, such as flow patterns, pressure drop, void fraction and so on. The concentrations of surfactant solution were 0, 10, 50 and 100 ppm and the surface tension of each solution was reduced to about 34mN/m from that of pure water of about 72mN/m. The dimension of the channel used was 10.0 mm × 1.0 mm. The drag reduction by mixing the surfactant was examined in both the single phase flow and the two-phase flow. The experimental data of two-phase frictional pressure drop and holdup were compared with the respective correlations which were previously proposed by the other researchers and the present authors. Finally, we proposed new correlations of two-phase frictional pressure drop and holdup in which the effect of surface tension and the aspect ratio of cross section of channel were taken into account.

Experimental Study on the Effect of Surface Tension on Void Fraction and Frictional Pressure Drop of an Air-Liquid Two-Phase Flow in a Horizontal Flat Narrow Rectangular Channel

2003 ◽  
Author(s):  
Hideo Ide ◽  
Tohru Fukano
Keyword(s):  
Surface Tension ◽  
Pressure Drop ◽  
Void Fraction ◽  
Two Phase Flow ◽  
Pure Water ◽  
Rectangular Channel ◽  
Phase Flow ◽  
Two Phase ◽  
Frictional Pressure Drop ◽  
Effect Of Surface

Air-liquid two-phase flow in a horizontal flat capillary rectangular channel has been studied to clarify the effects of surface tension on the flow phenomena, such as flow patterns, holdup and frictional pressure drop and so on. The concentrations of surfactant solution were 0, 10, 50 and 100 ppm and the surface tension of each solution was reduced to about 34mN/m from that of pure water of about 72mN/m. The dimension of the channel used was 10.0 mm×1.0 mm. The drag reduction by mixing the surfactant was examined in both the single phase flow and the two-phase flow. The experimental data of void fraction and two-phase frictional pressure drop were compared with the respective correlations which were previously proposed by the other researchers. Finally, we proposed new correlations of two-phase frictional pressure drop in which the effect of surface tension and the aspect ratio of cross section of channel were taken into account.

F41 Effect of Surface Tension on Gas-liquid Two-phase Flow Characteristics in Horizontal Mini-channels

2007 ◽  
Vol 2007.60 (0) ◽  
pp. 217-218
Author(s):  
Masatoshi MATSUO ◽  
Kazuhiro HORITA ◽  
Michio SADATOMI ◽  
Akimaro KAWAHARA
Keyword(s):  
Surface Tension ◽  
Two Phase Flow ◽  
Flow Characteristics ◽  
Phase Flow ◽  
Two Phase ◽  
Mini Channels ◽  
Effect Of Surface
Sign in / Sign up

Export Citation Format

Share Document