Encapsulating Ni/CeO2-ZrO2 with SiO2 layer to improve it catalytic activity for steam reforming of toluene

2017 ◽  
Vol 101 ◽  
pp. 138-141 ◽  
Author(s):  
Xiaoyong Zhao ◽  
Yaping Xue ◽  
Zhuoxin Lu ◽  
Ying Huang ◽  
Changqing Guo ◽  
...  
2012 ◽  
Vol 12 ◽  
pp. S80-S88 ◽  
Author(s):  
Kanit Soongprasit ◽  
Duangdao Aht-Ong ◽  
Viboon Sricharoenchaikul ◽  
Duangduen Atong

2013 ◽  
Vol 140-141 ◽  
pp. 652-662 ◽  
Author(s):  
Mitsuru Koike ◽  
Yuji Hisada ◽  
Lei Wang ◽  
Dalin Li ◽  
Hideo Watanabe ◽  
...  

ACS Omega ◽  
2020 ◽  
Vol 5 (41) ◽  
pp. 26335-26346
Author(s):  
Min Lu ◽  
Zuhong Xiong ◽  
Kejing Fang ◽  
Jiqing Li ◽  
Xi Li ◽  
...  

2021 ◽  
Vol 219 ◽  
pp. 106871
Author(s):  
Shanmukapriya Jayaprakash ◽  
Nikita Dewangan ◽  
Ashok Jangam ◽  
Sibudjing Kawi

Energies ◽  
2021 ◽  
Vol 14 (7) ◽  
pp. 1875
Author(s):  
Prashanth Reddy Buchireddy ◽  
Devin Peck ◽  
Mark Zappi ◽  
Ray Mark Bricka

Amongst the issues associated with the commercialization of biomass gasification, the presence of tars has been one of the most difficult aspects to address. Tars are an impurity generated from the gasifier and upon their condensation cause problems in downstream equipment including plugging, blockages, corrosion, and major catalyst deactivation. These problems lead to losses of efficiency as well as potential maintenance issues resulting from damaged processing units. Therefore, the removal of tars is necessary in order for the effective operation of a biomass gasification facility for the production of high-value fuel gas. The catalytic activity of montmorillonite and montmorillonite-supported nickel as tar removal catalysts will be investigated in this study. Ni-montmorillonite catalyst was prepared, characterized, and tested in a laboratory-scale reactor for its efficiency in reforming tars using naphthalene as a tar model compound. Efficacy of montmorillonite-supported nickel catalyst was tested as a function of nickel content, reaction temperature, steam-to-carbon ratio, and naphthalene loading. The results demonstrate that montmorillonite is catalytically active in removing naphthalene. Ni-montmorillonite had high activity towards naphthalene removal via steam reforming, with removal efficiencies greater than 99%. The activation energy was calculated for Ni-montmorillonite assuming first-order kinetics and was found to be 84.5 kJ/mole in accordance with the literature. Long-term activity tests were also conducted and showed that the catalyst was active with naphthalene removal efficiencies greater than 95% maintained over a 97-h test period. A little loss of activity was observed with a removal decrease from 97% to 95%. To investigate the decrease in catalytic activity, characterization of fresh and used catalyst samples was performed using thermogravimetric analysis, transmission electron microscopy, X-ray diffraction, and surface area analysis. The loss in activity was attributed to a decrease in catalyst surface area caused by nickel sintering and coke formation.


2014 ◽  
Vol 471 ◽  
pp. 157-164 ◽  
Author(s):  
Daiki Mukai ◽  
Yuki Murai ◽  
Takuma Higo ◽  
Shuhei Ogo ◽  
Yukihiro Sugiura ◽  
...  

2010 ◽  
Vol 89-91 ◽  
pp. 645-650 ◽  
Author(s):  
Ya Xu ◽  
Dong Hyun Chun ◽  
Jun Hyuk Jang ◽  
Masahiko Demura ◽  
Dang Moon Wee ◽  
...  

The catalytic activity of oxidation-reduction pre-treated Ni3Al powder for methane steam reforming was examined. The oxidation-reduction pre-treatment consisted of two steps: oxidation in air at various temperatures from 973 to 1373 K, and then followed by reduction in H2 at 873 K. It was found that the oxidation-reduction treatments significantly reduced the onset temperature of activity, i.e., improved the activity of Ni3Al powder at low temperatures. The characterization of Ni3Al surface showed that an outer surface layer of fine NiO particles were formed on the surface of Ni3Al after oxidation. These NiO particles were reduced to metallic Ni by the subsequent reduction treatment, resulting in the high activity for methane steam reforming. These results indicate that the Ni3Al can form highly active surface structure with oxidation-reduction treatment, having excellent heat resistance.


Sign in / Sign up

Export Citation Format

Share Document