Specific contact resistance of IGZO thin film transistors with metallic and transparent conductive oxides electrodes and XPS study of the contact/semiconductor interfaces

2018 ◽  
Vol 18 (7) ◽  
pp. 834-842 ◽  
Author(s):  
M.E. Rivas-Aguilar ◽  
N. Hernandez-Como ◽  
G. Gutierrez-Heredia ◽  
A. Sánchez-Martínez ◽  
M. Mireles Ramirez ◽  
...  
Keyword(s):  
Thin Film ◽  
Contact Resistance ◽  
Thin Film Transistors ◽  
Specific Contact Resistance ◽  
Transparent Conductive Oxides ◽  
Semiconductor Interfaces ◽  
Specific Contact ◽  
Xps Study

Improvement of the Specific Contact Resistance on P-Type 4H-SiC by Using a Highly P-Typed Doped 4H-SiC Layer Selectively Grown by VLS Transport

2014 ◽  
Vol 806 ◽  
pp. 57-60
Author(s):  
Nicolas Thierry-Jebali ◽  
Arthur Vo-Ha ◽  
Davy Carole ◽  
Mihai Lazar ◽  
Gabriel Ferro ◽  
...  
Keyword(s):  
Contact Resistance ◽  
Ohmic Contacts ◽  
Schottky Barrier Height ◽  
Annealing Temperature ◽  
Process Condition ◽  
Specific Contact Resistance ◽  
High Doping Level ◽  
Annealing Temperatures ◽  
Specific Contact ◽  
P Type

This work reports on the improvement of ohmic contacts made on heavily p-type doped 4H-SiC epitaxial layer selectively grown by Vapor-Liquid-Solid (VLS) transport. Even before any annealing process, the contact is ohmic. This behavior can be explained by the high doping level of the VLS layer (Al concentration > 1020 cm-3) as characterized by SIMS profiling. Upon variation of annealing temperatures, a minimum value of the Specific Contact Resistance (SCR) down to 1.3x10-6 Ω.cm2 has been obtained for both 500 °C and 800 °C annealing temperature. However, a large variation of the SCR was observed for a same process condition. This variation is mainly attributed to a variation of the Schottky Barrier Height.

scholarly journals A Study about Schottky Barrier Height and Ideality Factor in Thin Film Transistors with Metal/Zinc Oxide Nanoparticles Structures Aiming Flexible Electronics Application

Nanomaterials ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 1188
Author(s):  
Ivan Rodrigo Kaufmann ◽  
Onur Zerey ◽  
Thorsten Meyers ◽  
Julia Reker ◽  
Fábio Vidor ◽  
...  
Keyword(s):  
Thin Film ◽  
Zinc Oxide ◽  
Schottky Barrier ◽  
Barrier Height ◽  
Flexible Electronics ◽  
Thin Film Transistors ◽  
Zinc Oxide Nanoparticles ◽  
Schottky Barrier Height ◽  
Oxide Nanoparticles ◽  
Semiconductor Interfaces

Zinc oxide nanoparticles (ZnO NP) used for the channel region in inverted coplanar setup in Thin Film Transistors (TFT) were the focus of this study. The regions between the source electrode and the ZnO NP and the drain electrode were under investigation as they produce a Schottky barrier in metal-semiconductor interfaces. A more general Thermionic emission theory must be evaluated: one that considers both metal/semiconductor interfaces (MSM structures). Aluminum, gold, and nickel were used as metallization layers for source and drain electrodes. An organic-inorganic nanocomposite was used as a gate dielectric. The TFTs transfer and output characteristics curves were extracted, and a numerical computational program was used for fitting the data; hence information about Schottky Barrier Height (SBH) and ideality factors for each TFT could be estimated. The nickel metallization appears with the lowest SBH among the metals investigated. For this metal and for higher drain-to-source voltages, the SBH tended to converge to some value around 0.3 eV. The developed fitting method showed good fitting accuracy even when the metallization produced different SBH in each metal-semiconductor interface, as was the case for gold metallization. The Schottky effect is also present and was studied when the drain-to-source voltages and/or the gate voltage were increased.

Current Transport in Ti/Al/Ni/Au Ohmic Contacts to GaN and AlGaN

2007 ◽  
Vol 556-557 ◽  
pp. 1027-1030 ◽  
Author(s):  
Ferdinando Iucolano ◽  
Fabrizio Roccaforte ◽  
Filippo Giannazzo ◽  
A. Alberti ◽  
Vito Raineri
Keyword(s):  
Contact Resistance ◽  
Field Emission ◽  
Ohmic Contacts ◽  
Theoretical Models ◽  
Specific Contact Resistance ◽  
Strong Increase ◽  
Current Transport ◽  
Electrical Characteristics ◽  
Structural And Electrical Properties ◽  
Specific Contact

In this work, the structural and electrical properties of Ti/Al/Ni/Au contacts on n-type Gallium Nitride were studied. An ohmic behaviour was observed after annealing above 700°C. The structural analysis showed the formation of an interfacial TiN layer and different phases in the reacted layer (AlNi, AlAu4, Al2Au) upon annealing. The temperature dependence of the specific contact resistance demonstrated that the current transport occurs through thermoionic field emission in the contacts annealed at 600°C, and field emission after annealing at higher temperatures. By fitting the data with theoretical models, a reduction of the Schottky barrier from 1.21eV after annealing at 600°C to 0.81eV at 800°C was demonstrated, together with a strong increase of the carrier concentration at the interface. The reduction of the contact resistance upon annealing was discussed by correlating the structural and electrical characteristics of the contacts.

Direct and quantitative understanding of the non-Ohmic contact resistance in organic and oxide thin-film transistors

2015 ◽  
Vol 27 ◽  
pp. 253-258 ◽  
Author(s):  
Chuan Liu ◽  
Takeo Minari ◽  
Yong Xu ◽  
Bo-ru Yang ◽  
Hui-Xuan Chen ◽  
...  
Keyword(s):  
Thin Film ◽  
Contact Resistance ◽  
Ohmic Contact ◽  
Thin Film Transistors ◽  
Oxide Thin Film ◽  
Quantitative Understanding
Sign in / Sign up

Export Citation Format

Share Document