scholarly journals Some insights into the migration of double imaginary roots under small deviation of two parameters

Automatica ◽  
2018 ◽  
Vol 88 ◽  
pp. 91-97 ◽  
Author(s):  
Dina Alina Irofti ◽  
Keqin Gu ◽  
Islam Boussaada ◽  
Silviu-Iulian Niculescu
Keyword(s):  
Small Deviation ◽  
Two Parameters ◽  
Imaginary Roots

Photo-electric Hβ and uvby photometry

1966 ◽  
Vol 24 ◽  
pp. 170-180
Author(s):  
D. L. Crawford
Keyword(s):  
Narrow Band ◽  
Line Strength ◽  
Interference Filter ◽  
B Stars ◽  
Relative Line ◽  
The Mean ◽  
F Stars ◽  
Two Parameters ◽  
Filter Photometry ◽  
The Continuum

Early in the 1950's Strömgren (1, 2, 3, 4, 5) introduced medium to narrow-band interference filter photometry at the McDonald Observatory. He used six interference filters to obtain two parameters of astrophysical interest. These parameters he calledlandc, for line and continuum hydrogen absorption. The first measured empirically the absorption line strength of Hβby means of a filter of half width 35Å centered on Hβand compared to the mean of two filters situated in the continuum near Hβ. The second index measured empirically the Balmer discontinuity by means of a filter situated below the Balmer discontinuity and two above it. He showed that these two indices could accurately predict the spectral type and luminosity of both B stars and A and F stars. He later derived (6) an indexmfrom the same filters. This index was a measure of the relative line blanketing near 4100Å compared to two filters above 4500Å. These three indices confirmed earlier work by many people, including Lindblad and Becker. References to this earlier work and to the systems discussed today can be found in Strömgren's article inBasic Astronomical Data(7).

Radiation Damage of Support Films

1981 ◽  
Vol 39 ◽  
pp. 28-29
Author(s):  
H.A. Cohen ◽  
W. Chiu
Keyword(s):  
Transfer Function ◽  
Low Temperatures ◽  
Carbon Support ◽  
Contrast Transfer Function ◽  
Electron Dose ◽  
Imaging Parameters ◽  
Negative Stain ◽  
Phase Corrections ◽  
Two Parameters ◽  
Medium Dose

The goal of imaging the finest detail possible in biological specimens leads to contradictory requirements for the choice of an electron dose. The dose should be as low as possible to minimize object damage, yet as high as possible to optimize image statistics. For specimens that are protected by low temperatures or for which the low resolution associated with negative stain is acceptable, the first condition may be partially relaxed, allowing the use of (for example) 6 to 10 e/Å2. However, this medium dose is marginal for obtaining the contrast transfer function (CTF) of the microscope, which is necessary to allow phase corrections to the image. We have explored two parameters that affect the CTF under medium dose conditions.Figure 1 displays the CTF for carbon (C, row 1) and triafol plus carbon (T+C, row 2). For any column, the images to which the CTF correspond were from a carbon covered hole (C) and the adjacent triafol plus carbon support film (T+C), both recorded on the same micrograph; therefore the imaging parameters of defocus, illumination angle, and electron statistics were identical.

Applications of Scanning Microscopy in Biomedical Research

1968 ◽  
Vol 26 ◽  
pp. 354-355
Author(s):  
T. L. Hayes
Keyword(s):  
Information Content ◽  
Biomedical Research ◽  
Biomedical Applications ◽  
Three Dimensional ◽  
Dental Enamel ◽  
Resolving Power ◽  
Whole Mount ◽  
Two Parameters ◽  
Content Information ◽  
Sectioned Tissue

Biomedical applications of the scanning electron microscope (SEM) have increased in number quite rapidly over the last several years. Studies have been made of cells, whole mount tissue, sectioned tissue, particles, human chromosomes, microorganisms, dental enamel and skeletal material. Many of the advantages of using this instrument for such investigations come from its ability to produce images that are high in information content. Information about the chemical make-up of the specimen, its electrical properties and its three dimensional architecture all may be represented in such images. Since the biological system is distinctive in its chemistry and often spatially scaled to the resolving power of the SEM, these images are particularly useful in biomedical research.In any form of microscopy there are two parameters that together determine the usefulness of the image. One parameter is the size of the volume being studied or resolving power of the instrument and the other is the amount of information about this volume that is displayed in the image. Both parameters are important in describing the performance of a microscope. The light microscope image, for example, is rich in information content (chemical, spatial, living specimen, etc.) but is very limited in resolving power.

Transcription factor/DNA interactions visualized by electron spectroscopic imaging

1992 ◽  
Vol 50 (1) ◽  
pp. 450-451
Author(s):  
David P. Bazett-Jones ◽  
Mark L. Brown
Keyword(s):  
Transcription Factor ◽  
Dna Sequences ◽  
Transcription Initiation ◽  
Molecular Mechanisms ◽  
Phosphorus Content ◽  
Spectroscopic Imaging ◽  
Electron Spectroscopic Imaging ◽  
Dna Backbone ◽  
Two Parameters ◽  
High Level

A multisubunit RNA polymerase enzyme is ultimately responsible for transcription initiation and elongation of RNA, but recognition of the proper start site by the enzyme is regulated by general, temporal and gene-specific trans-factors interacting at promoter and enhancer DNA sequences. To understand the molecular mechanisms which precisely regulate the transcription initiation event, it is crucial to elucidate the structure of the transcription factor/DNA complexes involved. Electron spectroscopic imaging (ESI) provides the opportunity to visualize individual DNA molecules. Enhancement of DNA contrast with ESI is accomplished by imaging with electrons that have interacted with inner shell electrons of phosphorus in the DNA backbone. Phosphorus detection at this intermediately high level of resolution (≈lnm) permits selective imaging of the DNA, to determine whether the protein factors compact, bend or wrap the DNA. Simultaneously, mass analysis and phosphorus content can be measured quantitatively, using adjacent DNA or tobacco mosaic virus (TMV) as mass and phosphorus standards. These two parameters provide stoichiometric information relating the ratios of protein:DNA content.

Practical Importance of Spatial Resolution and Analytical Sensitivity in AEM X-ray Microanalysis

1990 ◽  
Vol 48 (2) ◽  
pp. 432-433
Author(s):  
J. Zhang ◽  
D.B. Williams ◽  
J.I. Goldstein
Keyword(s):  
Spatial Resolution ◽  
Practical Importance ◽  
Beam Current ◽  
Specimen Thickness ◽  
Analytical Sensitivity ◽  
Related Factors ◽  
X Ray ◽  
Probe Size ◽  
Excitation Volume ◽  
Two Parameters

Analytical sensitivity and spatial resolution are important and closely related factors in x-ray microanalysis using the AEM. Analytical sensitivity is the ability to distinguish, for a given element under given conditions, between two concentrations that are nearly equal. The analytical sensitivity is directly related to the number of x-ray counts collected and, therefore, to the probe current, specimen thickness and counting time. The spatial resolution in AEM analysis is determined by the probe size and beam broadening in the specimen. A finer probe and a thinner specimen give a higher spatial resolution. However, the resulting lower beam current and smaller X-ray excitation volume degrade analytical sensitivity. A compromise must be made between high spatial resolution and an acceptable analytical sensitivity. In this paper, we show the necessity of evaluating these two parameters in order to determine the low temperature Fe-Ni phase diagram.A Phillips EM400T AEM with an EDAX/TN2000 EDS/MCA system and a VG HB501 FEG STEM with a LINK AN10 EDS/MCA system were used.

On the influence of specimen thickness in TEM images of super-conducting vortices

1996 ◽  
Vol 54 ◽  
pp. 724-725
Author(s):  
J. Bonevich ◽  
D. Capacci ◽  
G. Pozzi ◽  
K. Harada ◽  
H. Kasai ◽  
...  
Keyword(s):  
Flux Line ◽  
Analytical Form ◽  
Realistic Model ◽  
Electron Holography ◽  
Specimen Thickness ◽  
Flux Tubes ◽  
Analytical Expression ◽  
Flux Lines ◽  
Normal Core ◽  
Two Parameters

The successful observation of superconducting flux lines (fluxons) in thin specimens both in conventional and high Tc superconductors by means of Lorentz and electron holography methods has presented several problems concerning the interpretation of the experimental results. The first approach has been to model the fluxon as a bundle of flux tubes perpendicular to the specimen surface (for which the electron optical phase shift has been found in analytical form) with a magnetic flux distribution given by the London model, which corresponds to a flux line having an infinitely small normal core. In addition to being described by an analytical expression, this model has the advantage that a single parameter, the London penetration depth, completely characterizes the superconducting fluxon. The obtained results have shown that the most relevant features of the experimental data are well interpreted by this model. However, Clem has proposed another more realistic model for the fluxon core that removes the unphysical limitation of the infinitely small normal core and has the advantage of being described by an analytical expression depending on two parameters (the coherence length and the London depth).

Fibrin Derivatives, Plasma Hemoglobin and Glomerular Fibrin Deposition in Experimental Intravascular Coagulation

1973 ◽  
Vol 29 (02) ◽  
pp. 363-374 ◽  
Author(s):  
F. K Beller ◽  
W Theiss
Keyword(s):  
Quantitative Measurement ◽  
Plasma Fibrinogen ◽  
Moderate Increase ◽  
Consumption Coagulopathy ◽  
Fibrin Deposition ◽  
Intravascular Coagulation ◽  
Plasma Hemoglobin ◽  
Three Stages ◽  
Two Parameters ◽  
Gelation Test

SummaryPlasma fibrinogen, circulating fibrinmonomers (as indicated by a positive ethanol gelation test), fibrinolysis breakdown products and plasma hemoglobin were assayed in 122 rats subjected to endotoxin injection or infusion. The results were correlated with the quantitative measurement of glomerular fibrin deposition. Based on these data four groups were determined : consumption coagulopathy and three stages of increasing severity of disseminated intravascular coagulation (DIG).Consumption coagulopathy was defined by a decrease in plasma fibrinogen and a positive ethanol gelation test in the absence of glomerular fibrin deposition. Plasma hemoglobin and fibrinolysis breakdown products were normal or only slightly increased.DIG as characterized by glomerular fibrin deposition was defined as moderate (1 to 20% glomeruli showing fibrin strands), intermediate (21 to 80%), and severe (81 to 100%). Decrease in plasma fibrinogen and frequence of a positive ethanol gelation test in all stages of DIG were only slightly different from the findings in consumption coagulopathy. However, a sharp increase in plasma hemoglobin levels was noted when glomerular fibrin deposition did occur even in small amounts. At this time only a moderate increase was noted in fibrin(ogen) breakdown products. These two parameters increased only slightly in the group of intermediate DIG. Severe DIG was characterized by a massive increase in fibrin (ogen) breakdown products and high levels of plasma hemoglobin.

Proposal for Objective Evaluation of the Performance of Various Functional APC-resistance Tests in Genotyped Patients

1997 ◽  
Vol 78 (05) ◽  
pp. 1360-1365 ◽  
Author(s):  
G Freyburger ◽  
S Javorschi ◽  
S Labrouche ◽  
P Bernard
Keyword(s):  
Protein S ◽  
Objective Evaluation ◽  
Original Method ◽  
Screening Methods ◽  
Factor Xii ◽  
Factor V ◽  
Likelihood Ratios ◽  
Modified Method ◽  
Apc Resistance ◽  
Two Parameters

SummaryThe aim of the present study was to evaluate the relative performance of five screening methods for APC resistance caused by the factor V:Q506 mutation: the original method Coatest® APC™ Resistance Chromogenix, a modified method using the same reagents but a predilution 1+4 of the plasma in a factor V deficient plasma from Stago (Stago deficient V) or from Chromogenix (V-DEF Plasma), the Coatest® APC™ Resistance V (Chromogenix), and Accelerimat™ from bioMérieux. Normalization was done against a pool of normal plasmas for the methods from Chromogenix. The study included 350 subjects, 219 were genotyped (174 FV:R506R, 42 FV:Q506R, 3 FV:Q506Q) and most of them were assessed by more than one method. Uncertainty in predicting the FV genotype was evaluated by statistical analysis, which provided a way to quantitate the performance of the different diagnostic approaches. Performance of each test was evaluated by its sensitivity, specificity, R.O.C. curves, positive and negative likelihood ratios (LR), and the overall performance was determined by two parameters derived from the LR curves : the maximum LR value obtained at the crossover of the two curves, and the distance between the two curves for LR = 10. Coatest® APC™ Resistance V and Accelerimat™ were proven to be the methods most able to discriminate for factor V:Q506, while normalization was not shown to improve the screening performance. The original method from Chromogenix was confirmed to undergo many influences (factor XII, PAI-1, thrombin- antithrombin complexes, antithrombin III, hematocrit). Although a very good improvement was provided by the newest methods, they were shown to be influenced by protein S and/or factor V levels in the sample plasma.

Sign in / Sign up

Export Citation Format

Share Document