Measurements of size distribution of titanium dioxide fine particles in a highly concentrated non-aqueous suspension by using particle self-assembly under an electric field

2012 ◽  
Vol 23 (4) ◽  
pp. 517-522 ◽  
Author(s):  
Akira Otsuki ◽  
Gjergj Dodbiba ◽  
Toyohisa Fujita
Keyword(s):  
Titanium Dioxide ◽  
Electric Field ◽  
Size Distribution ◽  
Self Assembly ◽  
Fine Particles ◽  
Aqueous Suspension

scholarly journals The effect of solvent and electric field on the size distribution of iron oxide microdots: Exploitation of self-assembly strategies for photoelectrodes

2011 ◽  
Vol 26 (2) ◽  
pp. 254-261 ◽  
Author(s):  
Rita Toth ◽  
Mateusz Schabikowski ◽  
Jakob Heier ◽  
Artur Braun ◽  
Dariusz Kata ◽  
...  
Keyword(s):  
Iron Oxide ◽  
Electric Field ◽  
Size Distribution ◽  
Self Assembly ◽  
Effect Of Solvent ◽  
Image Position

Abstract

Instability Phenomenon in Dip-Coating Process for Self-Assembly of Fine Particles and Design Countermeasures

2011 ◽  
Vol 5 (5) ◽  
pp. 688-693 ◽  
Author(s):  
Manabu Nishio ◽  
◽  
Nobuyuki Moronuki ◽  
Arata Kaneko
Keyword(s):  
Self Assembly ◽  
Fine Particles ◽  
Aqueous Suspension ◽  
Dip Coating ◽  
Selective Assembly ◽  
Pattern Design ◽  
Instability Phenomenon ◽  
Nano Structures ◽  
Improved Stability ◽  
Site Selective

The self-assembly of fine particles is a promising process for the production of nano-structures. In this process, aqueous suspension is often used. The spreading of the suspension on the substrate is a complex phenomenon that sometimes causes problems of instability. This paper discusses the instability phenomenon and proposes countermeasures from various aspects. It was found that special attention should be paid to the pattern design of site-selective assembly. Finally, complex structures made of particles of different sizes and materials are shown to demonstrate the improved stability after repeated dip-coating.

TEM observation of iron oxide pillars in montmorillonite

1990 ◽  
Vol 48 (4) ◽  
pp. 882-883
Author(s):  
H. Mori ◽  
Y. Murata ◽  
H. Yoneyama ◽  
H. Fujita
Keyword(s):  
Aqueous Solution ◽  
Iron Oxide ◽  
Fine Particles ◽  
Aqueous Suspension ◽  
Volume Ratio ◽  
Exchange Capacity ◽  
Nano Composites ◽  
Pillared Montmorillonite ◽  
Topographic Features ◽  
Transmission Electron

Recently, a new sort of nano-composites has been prepared by incorporating such fine particles as metal oxide microcrystallites and organic polymers into the interlayer space of montmorillonite. Owing to their extremely large specific surface area, the nano-composites are finding wide application[1∼3]. However, the topographic features of the microstructures have not been elucidated as yet In the present work, the microstructures of iron oxide-pillared montmorillonite have been investigated by high-resolution transmission electron microscopy.Iron oxide-pillared montmorillonite was prepared through the procedure essentially the same as that reported by Yamanaka et al. Firstly, 0.125 M aqueous solution of trinuclear acetato-hydroxo iron(III) nitrate, [Fe3(OCOCH3)7 OH.2H2O]NO3, was prepared and then the solution was mixed with an aqueous suspension of 1 wt% clay by continuously stirring at 308 K. The final volume ratio of the latter aqueous solution to the former was 0.4. The clay used was sodium montmorillonite (Kunimine Industrial Co.), having a cation exchange capacity of 100 mequiv/100g. The montmorillonite in the mixed suspension was then centrifuged, followed by washing with deionized water. The washed samples were spread on glass plates, air dried, and then annealed at 673 K for 72 ks in air. The resultant film products were approximately 20 μm in thickness and brown in color.

scholarly journals Photoacoustics for listening to Metal Nanoparticles Super-Aggregates

2021 ◽  
Author(s):  
Roberto Li Voti ◽  
Grigore Leahu ◽  
Concita Sibilia ◽  
Roberto Matassa ◽  
Giuseppe Familiari ◽  
...  
Keyword(s):  
Metal Nanoparticles ◽  
Size Distribution ◽  
Packing Density ◽  
Self Assembly ◽  
Détection Signal ◽  
Photoacoustic Detection ◽  
New Strategy ◽  
Aggregate Packing ◽  
Detection Signal

Photoacoustic detection signal has been used to build a new strategy to determine the mesoscale self-assembly of metal nanoparticles in terms of size distribution and aggregate packing density (metal nanoparticles...

scholarly journals An In-Situ Reaction Route to Molecular Level Dispersed Bisimide and ZnO Nanorod Hybrids with Efficient Photo-Induced Charge Transfer

2021 ◽  
Vol 16 (1) ◽  
Author(s):  
Chunzheng Lv ◽  
Lirong He ◽  
Jiahong Tang ◽  
Feng Yang ◽  
Chuhong Zhang
Keyword(s):  
Charge Transfer ◽  
Electric Field ◽  
Self Assembly ◽  
Molecular Level ◽  
Surface Photovoltage ◽  
Zno Nanorod ◽  
In Situ Reaction ◽  
Perylene Bisimide ◽  
Induced Charge

AbstractAs an important photoconductive hybrid material, perylene/ZnO has attracted tremendous attention for photovoltaic-related applications, but generally faces a great challenge to design molecular level dispersed perylenes/ZnO nanohybrids due to easy phase separation between perylenes and ZnO nanocrystals. In this work, we reported an in-situ reaction method to prepare molecular level dispersed H-aggregates of perylene bisimide/ZnO nanorod hybrids. Surface photovoltage and electric field-induced surface photovoltage spectrum show that the photovoltage intensities of nanorod hybrids increased dramatically for 100 times compared with that of pristine perylene bisimide. The enhancement of photovoltage intensities resulting from two aspects: (1) the photo-generated electrons transfer from perylene bisimide to ZnO nanorod due to the electric field formed on the interface of perylene bisimide/ZnO; (2) the H-aggregates of perylene bisimide in ZnO nanorod composites, which is beneficial for photo-generated charge separation and transportation. The introduction of ordered self-assembly thiol-functionalized perylene-3,4,9,10-tetracarboxylic diimide (T-PTCDI)/ ZnO nanorod composites induces a significant improvement in incident photo-to-electron conversion efficiency. This work provides a novel mentality to boost photo-induced charge transfer efficiency, which brings new inspiration for the preparation of the highly efficient solar cell.

scholarly journals Nucleation of Ga droplets self-assembly on GaAs(111)A substrates

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Artur Tuktamyshev ◽  
Alexey Fedorov ◽  
Sergio Bietti ◽  
Stefano Vichi ◽  
Riccardo Tambone ◽  
...  
Keyword(s):  
Quantum Dots ◽  
Size Distribution ◽  
Self Assembly ◽  
Cluster Size ◽  
Droplet Size Distribution ◽  
Local Environment ◽  
The Self ◽  
Critical Cluster ◽  
Droplet Nucleation ◽  
High Degree

AbstractWe investigated the nucleation of Ga droplets on singular GaAs(111)A substrates in the view of their use as the seeds for the self-assembled droplet epitaxial quantum dots. A small critical cluster size of 1–2 atoms characterizes the droplet nucleation. Low values of the Hopkins-Skellam index (as low as 0.35) demonstrate a high degree of a spatial order of the droplet ensemble. Around $$350\,^{\circ }\hbox {C}$$ 350 ∘ C the droplet size distribution becomes bimodal. We attribute this observation to the interplay between the local environment and the limitation to the adatom surface diffusion introduced by the Ehrlich–Schwöbel barrier at the terrace edges.

Self-Assembly of Monolayers of Submicron Sized Particles on Thin Liquid Films

2013 ◽  
Author(s):  
Shriram Pillapakkam ◽  
N. A. Musunuri ◽  
P. Singh
Keyword(s):  
Electric Field ◽  
Self Assembly ◽  
Uv Light ◽  
Capillary Forces ◽  
Liquid Films ◽  
Thin Liquid Films ◽  
Liquid Interfaces ◽  
Uv Curable ◽  
Particle Monolayer ◽  
Uv Curable Resin

In this paper, we present a technique for freezing monolayers of micron and sub-micron sized particles onto the surface of a flexible thin film after the self-assembly of a particle monolayer on fluid-liquid interfaces has been improved by the process we have developed where an electric field is applied in the direction normal to the interface. Particles smaller than about 10 microns do not self-assemble under the action of lateral capillary forces alone since capillary forces amongst them are small compared to Brownian forces. We have overcome this problem by applying an electric field in the direction normal to the interface which gives rise to dipoledipole and capillary forces which cause the particles to arrange in a triangular pattern. The technique involves assembling the monolayer on the interface between a UV-curable resin and another liquid by applying an electric field, and then curing the resin by applying UV light. The monolayer becomes embedded on the surface of the solidified resin film.

scholarly journals Flow Characteristics and Grain Size Distribution of Granular Gangue Mineral by Compaction Treatment

2017 ◽  
Vol 2017 ◽  
pp. 1-7 ◽  
Author(s):  
Ran Yuan ◽  
Dan Ma ◽  
Hongwei Zhang
Keyword(s):  
Weight Loss ◽  
Grain Size ◽  
Size Distribution ◽  
Grain Size Distribution ◽  
Water Flow ◽  
Fine Particles ◽  
Flow Characteristics ◽  
Test System ◽  
Chemical Components ◽  
Gangue Mineral

A test system for water flow in granular gangue mineral was designed to study the flow characteristics by compaction treatment. With the increase of the compaction displacement, the porosity decreases and void in granular gangue becomes less. The main reason causing initial porosity decrease is that the void of larger size is filled with small particles. Permeability tends to decrease and non-Darcy flow factor increases under the compaction treatment. The change trend of flow characteristics shows twists and turns, which indicate that flow characteristics of granular gangue mineral are related to compaction level, grain size distribution, crushing, and fracture structure. During compaction, larger particles are crushed, which in turn causes the weight of smaller particles to increase, and water flow induces fine particles to migrate (weight loss); meanwhile, a sample with more weight of size (0–2.5 mm) has a higher amount of weight loss. Water seepage will cause the decrease of some chemical components, where SiO2 decreased the highest in these components; the components decreased are more likely locked at fragments rather than the defect of the minerals. The variation of the chemical components has an opposite trend when compared with permeability.

Sign in / Sign up

Export Citation Format

Share Document