Study of the influence of silver nanoparticles on the second-order scattering and the fluorescence of the complexes of Tb(III) with quinolones and determination of the quinolones

2006 ◽  
Vol 566 (1) ◽  
pp. 136-143 ◽  
Author(s):  
Fen Ding ◽  
Huichun Zhao ◽  
Linpei Jin ◽  
Dong Zheng
Keyword(s):  
Silver Nanoparticles ◽  
Second Order

Sequential injection for determination of gamma-aminobutyric acid based on its effect on second order light scattering of silver nanoparticles

2016 ◽  
Vol 51 ◽  
pp. 69-75 ◽  
Author(s):  
Amornrassamee Jinnarak ◽  
Pattarapon Anantavichian ◽  
Apichai Intanin ◽  
Suchada Fungladda ◽  
Nathawut Choengchan ◽  
...  
Keyword(s):  
Silver Nanoparticles ◽  
Light Scattering ◽  
Second Order ◽  
Aminobutyric Acid ◽  
Gamma Aminobutyric Acid ◽  
Sequential Injection

scholarly journals Study of Silver Nanoparticles Sensitized Fluorescence and Second-Order Scattering of Terbium(III)-Pefloxacin Mesylate Complex and Determination of Pefloxacin Mesylate

2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
Aiyun Li ◽  
Zhiqiang Song
Keyword(s):  
Silver Nanoparticles ◽  
Excited State ◽  
Relative Intensity ◽  
Second Order ◽  
Keto Acid ◽  
Serum Samples ◽  
Sensitized Fluorescence ◽  
Exciting Wavelength ◽  
Novel Method

α-Keto acid of pefloxacin mesylate (PFLX) can form the complex with Terbium(III). The intramolecular energy from PFLX to Terbium(III) ion takes place when excited, and thus Terbium(III) excited state is formed and then emits the characteristic fluorescence of Terbium(III), locating at 490, 545, 580, and 620 nm. The second-order scattering (SOS) peak at 545 nm also appears for the complex with the exciting wavelength of 273 nm. When the silver nanoparticles are added to the system, the luminescence intensity at 545 nm greatly increased. So, with the adding of nanoparticles to the Terbium(III)-PFLX complex, not only is the intramolecular energy promoted but also the SOS intensity is enhanced. The experimental results show that it is the silver nanoparticles with certain size and certain concentration which can greatly enhance the fluorescence-SOS intensity, and the relative intensity at 545 nm is proportional to the amount of PFLX. Based on this phenomenon, a novel method for the determination of PFLX has been developed and applied to the determination of PFLX in capsule and serum samples.

Determination of Combined and Second Order Factor Effects for Simultaneous Optimization of Physical and Mechanical Properties of NR/BR Blend System

2014 ◽  
Vol 42 (4) ◽  
pp. 290-304
Author(s):  
Rajarajan Aiyengar ◽  
Jyoti Divecha
Keyword(s):  
Physical And Mechanical Properties ◽  
Second Order ◽  
Simultaneous Optimization ◽  
Order Effects ◽  
Elongation At Break ◽  
Five Factors ◽  
Rubber Compounds ◽  
Polybutadiene Rubber ◽  
Contour Plots

ABSTRACT The blends of natural rubber (NR), polybutadiene rubber (BR), and other forms of rubbers are widely used for enhancing the mechanical and physical properties of rubber compounds. Lots of work has been done in conditioning and mixing of NR/BR blends to improve the properties of its rubber compounds and end products such as tire tread. This article employs response surface methodology designed experiments in five factors; high abrasion furnace carbon black (N 330), aromatic oil, NR/BR ratio, sulfur, and N-oxydiethylene-2-benzothiazole sulfenamide for determination of combined and second order effects of the significant factors leading to simultaneous optimization of the NR/BR blend system. One of the overall optimum of eight properties existed at carbon 44 phr, oil 6.1 phr, NR/BR 78/22 phr with the following values of properties: tensile strength (22 MPa), elongation at break (528%), tear resistance (30 kg/mm), rebound resilience (67%), moderate hardness (68 International rubber hardness degrees) with low heat buildup (17 °C), permanent set (12%), and abrasion loss (57 mm3). More optimum combinations can easily be determined from the NR/BR blend system models contour plots.

Determination of rate constants of redox reactions of second order from current-less potential-time curves by a simplified graphical-numerical method

1983 ◽  
Vol 48 (5) ◽  
pp. 1358-1367 ◽  
Author(s):  
Antonín Tockstein ◽  
František Skopal
Keyword(s):  
Numerical Method ◽  
Explicit Form ◽  
Rate Constant ◽  
Optimization Algorithm ◽  
Rate Constants ◽  
Redox Reactions ◽  
Second Order ◽  
Wide Region ◽  
Recurrent Formula

A method for constructing curves is proposed that are linear in a wide region and from whose slopes it is possible to determine the rate constant, if a parameter, θ, is calculated numerically from a rapidly converging recurrent formula or from its explicit form. The values of rate constants and parameter θ thus simply found are compared with those found by an optimization algorithm on a computer; the deviations do not exceed ±10%.

Determination of the Nucleophilicity of Tricarbonyliron Coordinated Cyclohepta-1,3,5-triene

1999 ◽  
Vol 64 (11) ◽  
pp. 1770-1779 ◽  
Author(s):  
Herbert Mayr ◽  
Karl-Heinz Müller
Keyword(s):  
Gibbs Energy ◽  
Ambient Temperature ◽  
Rate Constants ◽  
Second Order ◽  
Order Rate ◽  
Electrophilic Additions ◽  
Kinetics Of

The kinetics of the electrophilic additions of four diarylcarbenium ions (4a-4d) to tricarbonyl(η4-cyclohepta-1,3,5-triene)iron (1) have been studied photometrically. The second-order rate constants match the linear Gibbs energy relationship log k20 °C = s(E + N) and yield the nucleophilicity parameter N(1) = 3.69. It is concluded that electrophiles with E ≥ -9 will react with complex 1 at ambient temperature.

An insight into the determination of size and number concentration of silver nanoparticles in blood using single particle ICP-MS (spICP-MS): Feasibility of application to samples relevant to in vivo toxicology studies

2021 ◽  
Author(s):  
Isabel Abad-Álvaro ◽  
Diego Leite ◽  
Dorota Bartczak ◽  
Susana Cuello ◽  
Beatriz Gomez-Gomez ◽  
...  
Keyword(s):  
Silver Nanoparticles ◽  
Single Particle ◽  
Number Concentration ◽  
Biological Matrices ◽  
Icp Ms ◽  
Toxicological Studies ◽  
Insight Into

Toxicological studies concerning nanomaterials in complex biological matrices usually require a carefully designed workflow that involves handling, transportation and preparation of a large number of samples without affecting the nanoparticle...

Sign in / Sign up

Export Citation Format

Share Document