Terminal end of the human odontoblast process: a study using SEM and confocal microscopy

1999 ◽  
Vol 3 (3) ◽  
pp. 126-132 ◽  
Author(s):  
G. Goracci ◽  
G. Mori ◽  
M. Baldi
Keyword(s):  
Confocal Microscopy ◽  
Odontoblast Process

scholarly journals Odontoblast processes in dentin revealed by fluorescent Di-I.

1995 ◽  
Vol 43 (2) ◽  
pp. 159-168 ◽  
Author(s):  
M R Byers ◽  
A Sugaya
Keyword(s):  
Electron Microscopy ◽  
Confocal Microscopy ◽  
Cell Structure ◽  
Carbocyanine Dyes ◽  
Carbocyanine Dye ◽  
Reparative Dentin ◽  
Hard Tissues ◽  
Odontoblast Process ◽  
Odontoblast Processes ◽  
Rat Molars

There has been controversy about the length and structure of the odontoblast process within dentin since the earliest histologic studies of teeth. Our objective was to use the fluorescent carbocyanine dye Di-I combined with a new gelatin embedment procedure and confocal microscopy to determine the structure and extent of odontoblast processes in developing and mature rat teeth, injured rat molars, reparative dentin, and adult monkey teeth. We found that odontoblast processes do not extend into outer dentin or to the dentin-enamel junction except during early stages of development. Those in innervated regions of crown are long and straight, whereas those in roots are extensively branched and shorter. Cavity injury to crown dentin caused odontoblast fragments to be aspirated into outer dentin. In reparative dentin the odontoblast processes were branched and similar to those in roots. We used photoconversion and electron microscopy to show that Di-I fills the entire odontoblast after gelatin embedment, including the cytoplasm. This is a different type of carbocyanine staining from any previously reported, and it also stains other cells in adjacent hard tissues such as bone and cementum. The Di-I-gelatin method is a new way to use carbocyanine dyes. It has enabled us to solve a long-standing controversy about the histology of teeth, and it should be useful for many other studies of cell structure.

Two-photon excitation microscopy in cellular biophysics

1995 ◽  
Vol 53 ◽  
pp. 62-63
Author(s):  
David W. Piston ◽  
Brian D. Bennett ◽  
Robert G. Summers
Keyword(s):  
Confocal Microscopy ◽  
Laser Beam ◽  
Duty Cycle ◽  
Excited Electronic State ◽  
Input Power ◽  
Two Photon ◽  
Simultaneous Absorption ◽  
Photon Excitation ◽  
Very High ◽  
Two Photon Excitation

Two-photon excitation microscopy (TPEM) provides attractive advantages over confocal microscopy for three-dimensionally resolved fluorescence imaging and photochemistry. Two-photon excitation arises from the simultaneous absorption of two photons in a single quantitized event whose probability is proportional to the square of the instantaneous intensity. For example, two red photons can cause the transition to an excited electronic state normally reached by absorption in the ultraviolet. In practice, two-photon excitation is made possible by the very high local instantaneous intensity provided by a combination of diffraction-limited focusing of a single laser beam in the microscope and the temporal concentration of 100 femtosecond pulses generated by a mode-locked laser. Resultant peak excitation intensities are 106 times greater than the CW intensities used in confocal microscopy, but the pulse duty cycle of 10-5 maintains the average input power on the order of 10 mW, only slightly greater than the power normally used in confocal microscopy.

Measurement of spontaneous neuronal membrane activity by time lapse confocal microscopy

1995 ◽  
Vol 53 ◽  
pp. 972-973
Author(s):  
R H. Selinfreund ◽  
A. H. Cornell-Bell
Keyword(s):  
Membrane Potential ◽  
Confocal Microscopy ◽  
Patch Clamp ◽  
Electrical Activity ◽  
Time Lapse ◽  
Neuronal Firing ◽  
Neuronal Membrane ◽  
Pituitary Cells ◽  
Patch Clamp Recording ◽  
Spontaneous Electrical Activity

Cellular electrophysiological properties are normally monitored by standard patch clamp techniques . The combination of membrane potential dyes with time-lapse laser confocal microscopy provides a more direct, least destructive rapid method for monitoring changes in neuronal electrical activity. Using membrane potential dyes we found that spontaneous action potential firing can be detected using time-lapse confocal microscopy. Initially, patch clamp recording techniques were used to verify spontaneous electrical activity in GH4\C1 pituitary cells. It was found that serum depleted cells had reduced spontaneous electrical activity. Brief exposure to the serum derived growth factor, IGF-1, reconstituted electrical activity. We have examined the possibility of developing a rapid fluorescent assay to measure neuronal activity using membrane potential dyes. This neuronal regeneration assay has been adapted to run on a confocal microscope. Quantitative fluorescence is then used to measure a compounds ability to regenerate neuronal firing.The membrane potential dye di-8-ANEPPS was selected for these experiments. Di-8- ANEPPS is internalized slowly, has a high signal to noise ratio (40:1), has a linear fluorescent response to change in voltage.

Five-Dimensional Microscopy using Widefield-Deconvolution: Practical Considerations and Biological Applications

1996 ◽  
Vol 54 ◽  
pp. 268-269
Author(s):  
W.F. Marshall ◽  
K. Oegema ◽  
J. Nunnari ◽  
A.F. Straight ◽  
D.A. Agard ◽  
...  
Keyword(s):  
Confocal Microscopy ◽  
High Speed ◽  
Laser Scanning ◽  
Ccd Camera ◽  
Image Plane ◽  
Time Lapse ◽  
Laser Scanning Confocal Microscopy ◽  
Three Dimensions ◽  
Excitation Light ◽  
Cooled Ccd

The ability to image cells in three dimensions has brought about a revolution in biological microscopy, enabling many questions to be asked which would be inaccessible without this capability. There are currently two major methods of three dimensional microscopy: laser-scanning confocal microscopy and widefield-deconvolution microscopy. The method of widefield-deconvolution uses a cooled CCD to acquire images from a standard widefield microscope, and then computationally removes out of focus blur. Using such a scheme, it is easy to acquire time-lapse 3D images of living cells without killing them, and to do so for multiple wavelengths (using computer-controlled filter wheels). Thus, it is now not only feasible, but routine, to perform five dimensional microscopy (three spatial dimensions, plus time, plus wavelength).Widefield-deconvolution has several advantages over confocal microscopy. The two main advantages are high speed of acquisition (because there is no scanning, a single optical section is acquired at a time by using a cooled CCD camera) and the use of low excitation light levels Excitation intensity can be much lower than in a confocal microscope for three reasons: 1) longer exposures can be taken since the entire 512x512 image plane is acquired in parallel, so that dwell time is not an issue, 2) the higher quantum efficiently of a CCD detect over those typically used in confocal microscopy (although this is expected to change due to advances in confocal detector technology), and 3) because no pinhole is used to reject light, a much larger fraction of the emitted light is collected. Thus we can typically acquire images with thousands of photons per pixel using a mercury lamp, instead of a laser, for illumination. The use of low excitation light is critical for living samples, and also reduces bleaching. The high speed of widefield microscopy is also essential for time-lapse 3D microscopy, since one must acquire images quickly enough to resolve interesting events.

Laser Scanning Confocal Microscopy and Three-Dimesnsional Reconstruction of the Mitotic Spindles of Unequally Dividing Embryonic Cells

1990 ◽  
Vol 48 (3) ◽  
pp. 166-167
Author(s):  
J. Holy ◽  
G. Schatten
Keyword(s):  
Confocal Microscopy ◽  
Mitotic Spindle ◽  
Laser Scanning ◽  
Three Dimensional ◽  
Laser Scanning Confocal Microscopy ◽  
Two Dimensions ◽  
Embryonic Cells ◽  
Mitotic Spindles ◽  
Cleavage Division ◽  
Scanning Confocal Microscopy

One of the classic limitations of light microscopy has been the fact that three dimensional biological events could only be visualized in two dimensions. Recently, this shortcoming has been overcome by combining the technologies of laser scanning confocal microscopy (LSCM) and computer processing of microscopical data by volume rendering methods. We have employed these techniques to examine morphogenetic events characterizing early development of sea urchin embryos. Specifically, the fourth cleavage division was examined because it is at this point that the first morphological signs of cell differentiation appear, manifested in the production of macromeres and micromeres by unequally dividing vegetal blastomeres.The mitotic spindle within vegetal blastomeres undergoing unequal cleavage are highly polarized and develop specialized, flattened asters toward the micromere pole. In order to reconstruct the three-dimensional features of these spindles, both isolated spindles and intact, extracted embryos were fluorescently labeled with antibodies directed against either centrosomes or tubulin.

Two-photon excitation fluorescence microscopy in living systems

1993 ◽  
Vol 51 ◽  
pp. 154-155 ◽  
Author(s):  
David W. Piston
Keyword(s):  
Confocal Microscopy ◽  
Fluorescence Microscopy ◽  
Singlet State ◽  
Excited Electronic State ◽  
Input Power ◽  
Two Photon ◽  
Simultaneous Absorption ◽  
Photon Excitation ◽  
Very High ◽  
Two Photon Excitation

Two-photon excitation fluorescence microscopy provides attractive advantages over confocal microscopy for three-dimensionally resolved fluorescence imaging. Two-photon excitation arises from the simultaneous absorption of two photons in a single quantitized event whose probability is proportional to the square of the instantaneous intensity. For example, two red photons can cause the transition to an excited electronic state normally reached by absorption in the ultraviolet. In our fluorescence experiments, the final excited state is the same singlet state that is populated during a conventional fluorescence experiment. Thus, the fluorophore exhibits the same emission properties (e.g. wavelength shifts, environmental sensitivity) used in typical biological microscopy studies. In practice, two-photon excitation is made possible by the very high local instantaneous intensity provided by a combination of diffraction-limited focusing of a single laser beam in the microscope and the temporal concentration of 100 femtosecond pulses generated by a mode-locked laser. Resultant peak excitation intensities are 106 times greater than the CW intensities used in confocal microscopy, but the pulse duty cycle of 10−5 maintains the average input power on the order of 10 mW, only slightly greater than the power normally used in confocal microscopy.

Selected Papers on Confocal Microscopy

1998 ◽  
Vol 189 (1) ◽  
pp. 98-99
Author(s):  
Alan Entwistle
Keyword(s):  
Confocal Microscopy
Sign in / Sign up

Export Citation Format

Share Document