Relationships between covalency, interatomic distances, and magnetic properties in halides and chalcogenides

1974 ◽  
pp. 1-43 ◽  
Author(s):  
R. D. Shannon ◽  
H. Vincent
Keyword(s):  
Magnetic Properties ◽  
Interatomic Distances

Bindungsverhältnisse und magnetische Eigenschaften ternärer Arsenide ET2As2 / Bonding and Magnetic Properties in Ternary Arsenides ET2As2

1983 ◽  
Vol 38 (7) ◽  
pp. 811-814 ◽  
Author(s):  
Martin Pfisterer ◽  
Günter Nagorsen
Keyword(s):  
Magnetic Properties ◽  
Interatomic Distances ◽  
Magnetic Susceptibilities ◽  
X Ray

Abstract The interatomic distances of ternary arsenides ET2As2 with ThCr2Si2-structure were determined by X-ray powder methods (E = Ca, Sr, Ba; T = Cr, Fe, Co, Ni, Cu). The phases were found to behave according to the Zintl-Klemm-Busmann concept. Magnetic susceptibilities were measured.

AEM analysis of crystallization in Ti-based amorphous alloys

1983 ◽  
Vol 41 ◽  
pp. 270-271
Author(s):  
A.R. Pelton ◽  
A.F. Marshall ◽  
Y.S. Lee
Keyword(s):  
Magnetic Properties ◽  
Amorphous Alloys ◽  
Amorphous Materials ◽  
Isothermal Annealing ◽  
Amorphous Matrix ◽  
Nucleation And Growth ◽  
Current Interest ◽  
Amorphous Films ◽  
Electrical And Magnetic Properties

Amorphous materials are of current interest due to their desirable mechanical, electrical and magnetic properties. Furthermore, crystallizing amorphous alloys provides an avenue for discerning sequential and competitive phases thus allowing access to otherwise inaccessible crystalline structures. Previous studies have shown the benefits of using AEM to determine crystal structures and compositions of partially crystallized alloys. The present paper will discuss the AEM characterization of crystallized Cu-Ti and Ni-Ti amorphous films.Cu60Ti40: The amorphous alloy Cu60Ti40, when continuously heated, forms a simple intermediate, macrocrystalline phase which then transforms to the ordered, equilibrium Cu3Ti2 phase. However, contrary to what one would expect from kinetic considerations, isothermal annealing below the isochronal crystallization temperature results in direct nucleation and growth of Cu3Ti2 from the amorphous matrix.

Atomic orientation effects in proton stopping at low velocity

1983 ◽  
Vol 41 ◽  
pp. 708-709
Author(s):  
Kin Lam
Keyword(s):  
Polycrystalline Material ◽  
Charged Particles ◽  
Target Material ◽  
Stopping Power ◽  
Low Velocity ◽  
Electronic Density ◽  
Interatomic Distances ◽  
Frame Work ◽  
Image Position ◽  
Atomic Orientation

The energy of moving ions in solid is dependent on the electronic density as well as the atomic structural properties of the target material. These factors contribute to the observable effects in polycrystalline material using the scanning ion microscope. Here we outline a method to investigate the dependence of low velocity proton stopping on interatomic distances and orientations.The interaction of charged particles with atoms in the frame work of the Fermi gas model was proposed by Lindhard. For a system of atoms, the electronic Lindhard stopping power can be generalized to the formwhere the stopping power function is defined as

Microstructure in soft magnetic E3 (S1, Al) (Sendust) alloys

1988 ◽  
Vol 46 ◽  
pp. 770-771
Author(s):  
June D. Kim
Keyword(s):  
Electron Microscopy ◽  
Magnetic Properties ◽  
Ternary Phase Diagram ◽  
Vertical Tube ◽  
Vacuum Induction Melting ◽  
Induction Melting ◽  
Soft Magnetic ◽  
Quenching Temperature ◽  
Thin Foils ◽  
Vertical Tube Furnace

Iron-base alloys containing 8-11 wt.% Si, 4-8 wt.% Al, known as “Sendust” alloys, show excellent soft magnetic properties. These magnetic properties are strongly dependent on heat treatment conditions, especially on the quenching temperature following annealing. But little has been known about the microstructure and the Fe-Si-Al ternary phase diagram has not been established. In the present investigation, transmission electron microscopy (TEM) has been used to study the microstructure in a Sendust alloy as a function of temperature.An Fe-9.34 wt.% Si-5.34 wt.% Al (approximately Fe3Si0.6Al0.4) alloy was prepared by vacuum induction melting, and homogenized at 1,200°C for 5 hrs. Specimens were heat-treated in a vertical tube furnace in air, and the temperature was controlled to an accuracy of ±2°C. Thin foils for TEM observation were prepared by jet polishing using a mixture of perchloric acid 15% and acetic acid 85% at 10V and ∼13°C. Electron microscopy was performed using a Philips EM 301 microscope.

Some Aspects of Exelfs Analysis in the Electron Microscope

1980 ◽  
Vol 38 ◽  
pp. 118-119
Author(s):  
D. E. Johnson ◽  
S. Csillag
Keyword(s):  
Fine Structure ◽  
Electron Microscope ◽  
Energy Loss ◽  
Analytical Electron Microscopy ◽  
Interference Effects ◽  
Interatomic Distances ◽  
X Ray ◽  
Structure Information ◽  
Microanalytical Technique ◽  
Analytical Electron

Recently, the applications area of analytical electron microscopy has been extended to include the study of Extended Energy Loss Fine Structure (EXELFS). Modulations past an ionization edge in the energy loss spectrum (EXELFS), contain atomic fine structure information similar to Extended X-ray Absorbtion Fine Structure (EXAFS). At low momentum transfer the main contribution to these modulations comes from interference effects between the outgoing excited inner shell electron waves and electron waves backscattered from the surrounding atoms. The ability to obtain atomic fine structure information (such as interatomic distances) combined with the spatial resolution of an electron microscope is unique and makes EXELFS an important microanalytical technique.

Magnetic properties of new charge-transfer complexes based on manganese porphyrins

1997 ◽  
Vol 90 (3) ◽  
pp. 407-413
Author(s):  
MARC KELEMEN ◽  
CHRISTOPH WACHTER ◽  
HUBERT WINTER ◽  
ELMAR DORMANN ◽  
RUDOLF GOMPPER ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Charge Transfer ◽  
Charge Transfer Complexes ◽  
Manganese Porphyrins

Influence of Ni-substitution on magnetic properties of annealed FeNiNbCuSiB alloys

1998 ◽  
Vol 08 (PR2) ◽  
pp. Pr2-111-Pr2-114 ◽  
Author(s):  
P. Vojtaník ◽  
E. Komová ◽  
R. Varga ◽  
R. Matejko ◽  
R. Grössinger ◽  
...  
Keyword(s):  
Magnetic Properties ◽  
Ni Substitution
Sign in / Sign up

Export Citation Format

Share Document