Experimental technique with three-axis spectrometers

1982 ◽  
pp. 8-15
Author(s):  
Bruno Dorner
Keyword(s):  
Experimental Technique

Reconstruction of electron holograms recorded in a non-FEG, non-biprism TEM

1995 ◽  
Vol 53 ◽  
pp. 618-619
Author(s):  
Z.L. Wang
Keyword(s):  
Electron Microscope ◽  
Single Crystal ◽  
Experimental Technique ◽  
Transmission Electron Microscope ◽  
The Other ◽  
Electron Holography ◽  
Transmission Electron ◽  
Coherent Sources ◽  
Imaging Theory ◽  
Normal Specimen

An experimental technique for performing electron holography using a non-FEG, non-biprism transmission electron microscope (TEM) has been introduced by Ru et al. A double stacked specimens, one being a single crystal foil and the other the specimen, are loaded in the normal specimen position in TEM. The single crystal, which is placed onto the specimen, is responsible to produce two beams that are equivalent to two virtual coherent sources illuminating the specimen beneath, thus, permitting electron holography of the specimen. In this paper, the imaging theory of this technique is described. Procedures are introduced for digitally reconstructing the holograms.

Front Matter

2019 ◽  
Vol 1 (1) ◽  
Author(s):  
Edy Saputra
Keyword(s):  
Experimental Technique ◽  
Legal Responsibility

Statements of fact and opinion in the articles in the Journal of Applied Materials and Technology are those of the respective authors and contributors and not of Journal of Applied Materials and Technology or the institution of Applied Materials and Technology Society and Faculty of Engineering, Universitas Riau. Neither Applied Materials and Technology Society and Faculty of Engineering, Universitas Riau nor Journal of Applied Materials and Technology make any representation, express or implied, in respect of the accuracy of the material in this journal and cannot accept any legal responsibility or liability for any errors or omissions that may be made by the reader should make her or his own evaluation as to the appropriateness or otherwise of any experimental technique described.

A laboratory experimental technique for simulating combined blast and impact loading

2019 ◽  
Vol 134 ◽  
pp. 103382
Author(s):  
Lang Li ◽  
Qian-Cheng Zhang ◽  
Rui Zhang ◽  
Xin Wang ◽  
Zhen-Yu Zhao ◽  
...  
Keyword(s):  
Experimental Technique ◽  
Impact Loading

Experimental technique for growth of Trichophyton mentagrophytes on fabric

1972 ◽  
Vol 47 (3) ◽  
pp. 237-240 ◽  
Author(s):  
Donald C. Kelley ◽  
Gary J. Plumberg
Keyword(s):  
Experimental Technique ◽  
Trichophyton Mentagrophytes

A New Experimental Technique for Measuring Surface Heat Transfer Coefficients Using Uncalibrated Liquid Crystals

1999 ◽  
Author(s):  
Wayne N. O. Turnbull ◽  
Patrick H. Oosthuizen
Keyword(s):  
Heat Transfer ◽  
Heat Flux ◽  
Experimental Technique ◽  
Surface Heat Flux ◽  
Local Heat ◽  
Surface Heat ◽  
Phase Delay ◽  
Transfer Coefficients ◽  
Periodic Surface ◽  
Heat Transfer Coefficients

Abstract A new experimental technique has been developed that permits the determination of local surface heat transfer coefficients on surfaces without requirement for calibration of the temperature-sensing device. The technique uses the phase delay that develops between the surface temperature response and an imposed periodic surface heat flux. This phase delay is dependent upon the thermophysical properties of the model, the heat flux driving frequency and the local heat transfer coefficient. It is not a function of magnitude of the local heat flux. Since only phase differences are being measured there is no requirement to calibrate the temperature sensor, in this instance a thermochromic liquid crystal. Application of a periodic surface heat flux to a flat plate resulted in a surface colour response that was a function of time. This response was captured using a standard colour CCD camera and the phase delay angles were determined using Fourier analysis. Only the 8 bit G component of the captured RGB signal was required, there being no need to determine a Hue value. From these experimentally obtained phase delay angles it was possible to determine heat transfer coefficients that compared well with those predicted using a standard correlation.

Sign in / Sign up

Export Citation Format

Share Document