STAMPAR: A parallel processing approach for the explicit dynamic analysis of sheet stamping problems

1997 ◽  
pp. 1369-1374
Author(s):  
L. Neamtţu ◽  
F. Zarate ◽  
E. Oñate ◽  
G. A. Duffett ◽  
J. M. Cela
Keyword(s):  
Parallel Processing ◽  
Dynamic Analysis ◽  
Processing Approach ◽  
Sheet Stamping ◽  
Explicit Dynamic

Investigation of Temperature and Stress Distribution on High Speed Machining of Ti6Al4V and 316L Steel Biomaterials Using Explicit Dynamic Analysis

2017 ◽  
Vol 889 ◽  
pp. 84-89
Author(s):  
Pandithevan Ponnusamy ◽  
Mullapudi Joshi
Keyword(s):  
Dynamic Analysis ◽  
Mechanical Behaviour ◽  
High Speed ◽  
Cutting Speed ◽  
Surgical Instruments ◽  
Interface Temperature ◽  
High Speed Machining ◽  
316L Steel ◽  
Explicit Dynamic ◽  
Cutting Speeds

In high speed machining, to dynamically control the mechanical behaviour of the materials, it is essential to control temperature, stress and strain by appropriate speed, feed and depth of cut. In the present work, to predict the mechanical behaviour of Ti6Al4V and 316L steel bio-materials an explicit dynamic analysis with different cutting speeds was carried out. Orthogonal cutting of 316L steel and Ti6Al4V materials with 720 m/min, 900 m/min and 1200 m/min cutting speeds was performed, and the distribution of stress and temperature was investigated using Jonson-Cook material model. Additionally, the work aimed at determining the effect of cutting speed on work piece temperature, when cutting is carried out continuously. From the investigation, it was found that, while machining Ti6Al4V material, for the increase in cutting speed there was increase in tool-chip interface temperature. Specifically, this could found till the cutting speed 900 m/min. But, there was a decrease in tool-chip interface temperature for the increase in speed from 900 m/min to 1200 m/min. Similarly for 316L steel, the tool-chip interface temperature increased when increasing the cutting speed till 900 m/min. But reduction in temperature from 650 °C to 500 °C for steel and 1028 °C to 990 °C for Ti6Al4V were found, when the cutting speed increased from 900 m/min to 1200 m/min. The study can be used to conclude, at what temperature range the adoption of material with controlled shape and geometry is possible for potential applications like, prosthetic design and surgical instruments prior to fabrications.

scholarly journals Non‐linear explicit dynamic analysis of shells using the BST rotation‐free triangle

2002 ◽  
Vol 19 (6) ◽  
pp. 662-706 ◽  
Author(s):  
E. Oñate ◽  
P. Cendoya ◽  
J. Miquel
Keyword(s):  
Dynamic Analysis ◽  
Non Linear ◽  
Explicit Dynamic
Sign in / Sign up

Export Citation Format

Share Document