Inheritance of grain filling duration in spring wheat (Triticum aestivum L. em thell)

2007 ◽  
Vol 50 (4) ◽  
pp. 504-507 ◽  
Author(s):  
Kamaluddin ◽  
Rishi Muni Singh ◽  
Malik Zainul Abdin ◽  
Mather Ali Khan ◽  
Tanweer Alam ◽  
...  
1994 ◽  
Vol 74 (4) ◽  
pp. 681-686 ◽  
Author(s):  
S. D. Duguid ◽  
A. L. Brûlé-Babel

Final grain dry weight, a component of yield in spring wheat, is determined by the rate and duration of grain filling. The objective of this study was to compare grain dry weight and rate and duration of grain filling amongst five spring wheat genotypes (Triticum aestivum L.) that differed in time to maturity. Glenlea, Katepwa, PT516, Roblin, and Wildcat were sown in replicated trials on four seeding dates in 1988 and 1989 at Winnipeg, Manitoba. Mean grain dry weight was measured at various intervals from anthesis to maturity. A logistic equation was used to characterize grain filling and estimate final grain dry weight, and the duration and maximum rate of grain filling. Stepwise multivariate analysis indicated that final grain dry weight was the most important variable characterizing the grain filling curves, followed by duration and then maximum rate of grain filling. The highest grain dry weights were produced by Glenlea (40.4 mg) and Wildcat (36.9 mg). Roblin (34.9 mg) was intermediate in grain dry weight while Katepwa (32.4 mg) and PT516 (30.3 mg) produced the smallest grains. Genotypes with the highest grain dry weights had shorter durations and higher maximum rates of grain filling. Key words:Triticum aestivum L., grain filling, duration, rate, phenological development, yield


1991 ◽  
Vol 71 (1) ◽  
pp. 63-69 ◽  
Author(s):  
S. Pararajasingham ◽  
L. A. Hunt

Estimates of the base temperature for grain filling duration of wheat (Triticum aestivum L.) differ between outdoor and indoor studies. This study was set up to determine whether this difference could be attributed to variation in spike-air temperature differentials. Spike and/or spikelet temperatures were determined in wheat grown outdoors as well as indoors. Spike temperature, measured with an infrared thermometer, of wheat grown outdoors with adequate water supply was 1.5 °C greater than air temperature while spikelet temperature measured with a thermocouple closely approximated air temperature. In indoor grown wheat, on the other hand, regardless of the magnitude of air temperature, spikelet temperature was found to be 3–4 °C above that of air when lights were on. Estimating the base temperature for grain filling duration with data from a previous indoor study, with compensation for the 3–4 °C increase in spikelet temperature, resulted in 8.8 °C base temperature for grain filling duration, comparable to that obtained in outdoor studies. Differences between outdoor and indoor studies may thus reflect spike-air temperature differentials. Estimation of the base temperature for grain filling with air temperature appears appropriate for outdoor studies. Key words: Triticum aestivum (L.), base temperature, grain filling duration, wheat


1983 ◽  
Vol 63 (1) ◽  
pp. 73-90 ◽  
Author(s):  
C. A. CAMPBELL ◽  
H. R. DAVIDSON ◽  
T. N. McCAIG

Manitou spring wheat (Triticum aestivum L.) was grown at combinations of three different day/night temperatures (27/12 °C, 22/12 °C and 17/12 °C), three levels of fertilizer N (58, 116 and 174 kg N/ha), and three moisture stresses (nominally −0.03, −1.5 and −4.0 MPa) applied for four durations (viz., no stress throughout, stress from (i) four-tiller (Tg), (ii) boot (Bt), or (iii) flowering (Fl) stages to harvest (Hvst)). Plant and soil samples were analyzed at eight growth stages. Plants grown at 22/12 °C or 17/12 °C and given 116 or 174 kg N/ha lost some N between heading and flowering. Plant N content (dry weight × % N) was depressed by moisture stress in proportion to the duration of the stress even though N concentration was increased. Plant N content was not greatly affected by temperature due to the compensating effects of temperature on dry matter and N concentration. N content of heads was depressed most by moisture stress applied from the Bt stage. Between Fl and Hvst the roots, leaves and stems lost an average 27, 39 and 63% of their N content, respectively. Stems could have contributed a maximum of about 30%, roots 14%, leaves 10% and chaff 7% of the grain N content at Hvst; thus, almost 40% of the grain’s N was taken up during grain filling. An average 75% of the aboveground plant N was located in the grain. At 27/12 °C nonstructural carbohydrate (NSC) concentration in stems reached a maximum at Fl compared to dough stage at 22/12 °C, but it decreased rapidly thereafter. In contrast to N concentration, NSC concentration in stems was lowest at 27/12 °C; also, moisture stress from Bt or Tg stages decreased NSC concentration. Like N content, NSC content was reduced in proportion to the duration of moisture stress. High temperature, N fertilizer, and moisture stress from Tg or Bt stages (conditions favoring high grain protein) increased the proportion of the vegetative organs’ weight loss, between Fl and Hvst, that was N-linked. The amount of NSC-associated dry matter lost from stems during grain filling was generally greater for late or low moisture stressed plants, for plants grown under cooler conditions, and for plants grown at higher N rates (conditions favoring greater grain yields). Of the moisture treatments, stress applied from Fl increased NSC-associated dry matter lost from stems the most, probably suggesting that assimilate translocation was used by the plant to compensate for reduced flag-leaf-produced photosynthate. Respiration losses associated with NSC translocation from stems to heads was greater at 22/12° than at 17/12 °C; there was little NSC translocation apparent at T27/12 °C.Key words: Plant nitrogen, soluble sugars, nitrogen effect, temperature effect, moisture stress effect, spring wheat (Triticum aestivum L.)


1991 ◽  
Vol 71 (3) ◽  
pp. 609-617 ◽  
Author(s):  
L. A. Hunt ◽  
G. van der Poorten ◽  
S. Pararajasingham

To help define traits that are likely to improve wheat (Triticum aestivum L.) grain yield in a warm, humid continental climate, genotypic variations in various grain growth characteristics in wheat were examined. Winter habit cultivars were grown indoors under a 16-h photoperiod and at day/night temperatures of 20/15 °C, and spring habit cultivars at temperatures ranging from 15/15 °C to 30/25 °C. Grain-filling duration of the winter wheats varied from 36.4 d for Peking-10 to 31.8 d for Priboy. Final kernel weights, which varied from 61.7 mg for Lovrin-10 to 38.3 for Jokionen-3057, were highly correlated with rates of dry matter accumulation. Grain-filling duration of the spring wheats ranged from 56.4 to 47.0 d at 15/15 °C, and from 23.8 to 18.1 d at 30/25 °C. Grain number per spike decreased from 15/15 °C to 30/25 °C. The inverse of grain-filling duration was linearly related to mean temperature, with the intercept on the x-axis (the base temperature of grain filling) being the same for all cultivars. Variation for grain-filling duration among the genotypes tested was present, although small in relation to temperature effects. Breeding for extended grain-filling duration as a strategy for increasing wheat grain yield in a warm climate will thus be difficult. However, an application of the degree-day concept would be desirable. Key words: Triticum aestivum (L.), grain-filling duration, rate of grain filling, temperature


2008 ◽  
Vol 3 (1) ◽  
pp. 75-82 ◽  
Author(s):  
Milka Brdar ◽  
Marija Kraljević-Balalić ◽  
Borislav Kobiljski

AbstractFinal grain dry weight, a component of yield in wheat, is dependent on the duration and the rate of grain filling. The purpose of the study was to compare the grain filling patterns between common wheat, (Triticum aestivum L.), and durum wheat, (Triticum turgidum L. var. durum), and investigate relationships among grain filling parameters, yield components and the yield itself. The most important variables in differentiating among grain filling curves were final grain dry weight (W) for common wheat genotypes and grain filling rate (R) for durum wheat genotypes; however, in all cases the sets of variables important in differentiating among grain filling curves were extended to either two or all three parameters. Furthermore, in one out of three environmental conditions and for both groups of genotypes, the most important parameter in the set was grain filling duration (T). It indicates significant impact of environmental conditions on dry matter accumulation and the mutual effect of grain filling duration and its rate on the final grain dry weight. The medium early anthesis date could be associated with further grain weight and yield improvements in wheat. Grain filling of earlier genotypes occurs in more temperate environments, which provides enough time for gradual grain fill and avoids the extremes of temperature and the stress of dry conditions.


2019 ◽  
Vol 132 (11) ◽  
pp. 3023-3033 ◽  
Author(s):  
Firdissa E. Bokore ◽  
Richard D. Cuthbert ◽  
Ron E. Knox ◽  
Arti Singh ◽  
Heather L. Campbell ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document