Estimation and validation of snow surface temperature using modis data for snow-avalanche studies in NW-Himalaya

2007 ◽  
Vol 35 (4) ◽  
pp. 287-299 ◽  
Author(s):  
H. S. Negi ◽  
N. K. Thakur ◽  
V. D. Mishra
Keyword(s):  
Surface Temperature ◽  
Snow Avalanche ◽  
Snow Surface ◽  
Nw Himalaya ◽  
Modis Data ◽  
Snow Surface Temperature

scholarly journals Retrieving snow surface temperature based on MODIS data

2008 ◽  
Vol 11 (4) ◽  
pp. 247-251
Author(s):  
Ji Zhou ◽  
Yunhao Chen ◽  
Jing Li ◽  
Yan Tang
Keyword(s):  
Surface Temperature ◽  
Snow Surface ◽  
Modis Data ◽  
Snow Surface Temperature

scholarly journals Evaluation of alternative formulae for calculation of surface temperature in snowmelt models using frequency analysis of temperature observations

2009 ◽  
Vol 6 (3) ◽  
pp. 3863-3890 ◽  
Author(s):  
C. H. Luce ◽  
D. G. Tarboton
Keyword(s):  
Time Series ◽  
Energy Balance ◽  
Surface Temperature ◽  
Energy Flux ◽  
Frequency Analysis ◽  
Energy Content ◽  
Balance Model ◽  
Snow Surface ◽  
Fourier Frequency ◽  
Snow Surface Temperature

Abstract. The snow surface temperature is an important quantity in the snow energy balance, since it modulates the exchange of energy between the surface and the atmosphere as well as the conduction of energy into the snowpack. It is therefore important to correctly model snow surface temperatures in energy balance snowmelt models. This paper focuses on the relationship between snow surface temperature and conductive energy fluxed that drive the energy balance of a snowpack. Time series of snow temperature at the surface and through the snowpack were measured to examine energy conduction in a snowpack. Based on these measurements we calculated the snowpack energy content and conductive energy flux at the snow surface. We then used these estimates of conductive energy flux to evaluate formulae for the calculation of the conductive flux at the snow surface based on surface temperature time series. We use a method based on Fourier frequency analysis to estimate snow thermal properties. Among the formulae evaluated, we found that a modified force-restore formula, based on the superimposition of the force-restore equation capturing diurnal fluctuations on a gradually changing temperature gradient, had the best agreement with observations of heat conduction. This formula is suggested for the parameterization of snow surface temperature in a full snowpack energy balance model.

scholarly journals Modeling the snow surface temperature with a one-layer energy balance snowmelt model

2013 ◽  
Vol 10 (12) ◽  
pp. 15071-15118 ◽  
Author(s):  
J. You ◽  
D. G. Tarboton ◽  
C. H. Luce
Keyword(s):  
Energy Balance ◽  
Surface Temperature ◽  
Snow Water Equivalent ◽  
Effective Conductivity ◽  
Energy Content ◽  
Single Layer ◽  
Conductive Heat ◽  
Snow Surface ◽  
Snow Surface Temperature ◽  
Snowmelt Model

Abstract. \\label{sec:abstract} Snow surface temperature is a key control on energy exchanges at the snow surface, particularly net longwave radiation and turbulent energy fluxes. The snow surface temperature is in turn controlled by the balance between various external fluxes and the conductive heat flux, internal to the snowpack. Because of the strong insulating properties of snow, thermal gradients in snow packs are large and nonlinear, a fact that has led many to advocate multiple layer snowmelt models over single layer models. In an effort to keep snowmelt modeling simple and parsimonious, the Utah Energy Balance (UEB) snowmelt model used only one layer but allowed the snow surface temperature to be different from the snow average temperature by using an equilibrium gradient parameterization based on the surface energy balance. Although this procedure was considered an improvement over the ordinary single layer snowmelt models, it still resulted in discrepancies between modeled and measured snowpack energy contents. In this paper we examine the parameterization of snow surface temperature in single layer snowmelt models from the perspective of heat conduction into a semi-infinite medium. We evaluate the equilibrium gradient approach, the force-restore approach, and a modified force-restore approach. In addition, we evaluate a scheme for representing the penetration of a refreezing front in cold periods following melt. We also introduce a method to adjust effective conductivity to account for the presence of ground near to a shallow snow surface. These parameterizations were tested against data from the Central Sierra Snow Laboratory, CA, Utah State University experimental farm, UT, and Subnivean snow laboratory at Niwot Ridge, CO. These tests compare modeled and measured snow surface temperature, snow energy content, snow water equivalent, and snowmelt outflow. We found that with these refinements the model is able to better represent the snowpack energy balance and internal energy content while still retaining a parsimonious one layer format.

scholarly journals The influence of the forest on night-time snow surface temperature

2001 ◽  
Vol 32 ◽  
pp. 217-222 ◽  
Author(s):  
Peter Höller
Keyword(s):  
Surface Temperature ◽  
Open Field ◽  
Air Temperature ◽  
Forest Canopy ◽  
Small Range ◽  
Snow Surface ◽  
Net Radiation ◽  
Night Time ◽  
Near Surface ◽  
Snow Surface Temperature

AbstractSnow surface temperature (Ts) plays an important role in the formation of surface hoar or near-surface faceted crystals The goal of this study was to obtain detailed information on Ts in different forest stands nelr the timberline. The investigations were conducted during clear nights and showed that the snow surface temperature is influenced very strongly by the forest canopy. While the air temperature was very similar on the different experimental sites, Ts was higher in the forest than in the open field; on the south-facing slope the difference between the forest and the open field was 3–4.5°C, and on the north-facing slope approximately 3–7°C. Taking into account that εair is 0.7 and εtree is 0.94, the incoming radiation (I ↓) for the different experimental sites was calculated by the equation of Brunt (the canopy density was estimated using photographs taken with an 8 mm fish-eye). To calculate Ts, air temperature and averaged values of the net radiation (because the net radiation (I) has only a small range of variation during clear nights) were used. The results show that the calculated values were higher than the measured values (by approximately 2°C). However, a better correlation was found by using lower values of the emissivity (εair0.67 and εtree0.91).

scholarly journals Evaluation of alternative formulae for calculation of surface temperature in snowmelt models using frequency analysis of temperature observations

2010 ◽  
Vol 14 (3) ◽  
pp. 535-543 ◽  
Author(s):  
C. H. Luce ◽  
D. G. Tarboton
Keyword(s):  
Time Series ◽  
Energy Balance ◽  
Surface Temperature ◽  
Energy Flux ◽  
Frequency Analysis ◽  
Energy Content ◽  
Balance Model ◽  
Snow Surface ◽  
Fourier Frequency ◽  
Snow Surface Temperature

Abstract. The snow surface temperature is an important quantity in the snow energy balance, since it modulates the exchange of energy between the surface and the atmosphere as well as the conduction of energy into the snowpack. It is therefore important to correctly model snow surface temperatures in energy balance snowmelt models. This paper focuses on the relationship between snow surface temperature and conductive energy fluxes that drive the energy balance of a snowpack. Time series of snow temperature at the surface and through the snowpack were measured to examine energy conduction in a snowpack. Based on these measurements we calculated the snowpack energy content and conductive energy flux at the snow surface. We then used these estimates of conductive energy flux to evaluate formulae for the calculation of the conductive flux at the snow surface based on surface temperature time series. We use a method based on Fourier frequency analysis to estimate snow thermal properties. Among the formulae evaluated, we found that a modified force-restore formula, based on the superimposition of the force-restore equation capturing diurnal fluctuations on a gradually changing temperature gradient, had the best agreement with observations of heat conduction. This formula is suggested for the parameterization of snow surface temperature in a full snowpack energy balance model.

scholarly journals Daytime preservation of surface-hoar crystals

1998 ◽  
Vol 26 ◽  
pp. 22-26 ◽  
Author(s):  
Akihiro Hachikubo ◽  
Eizi Akitaya
Keyword(s):  
Shear Strength ◽  
Surface Layer ◽  
Relative Humidity ◽  
Solar Radiation ◽  
Surface Temperature ◽  
Snow Surface ◽  
Previous Night ◽  
Snow Surface Temperature ◽  
Transfer Method

Surface hoar growing for several clear and humid days were observed. During daytime, air and snow-surface temperature increased and relative humidity decreased, hence evaporation (sublimation) occurred at the snow surface. The amount of evaporation calculated using a bulk-transfer method suggests that the surface-hoar crystals which grew during the previous night should have disappeared but they were observed to survive on the snow surface even during the daytime. During the following night, new surface-hoar crystals formed on top of the older ones and grew even larger. This result indicates that, although the surface-hoar crystals evaporated into the air during the daytime, snow grains beneath the surface were warmed by solar radiation and evaporated to the air. They may partially condense into the surface-hoar crystals and make up for the reduction in size. Depth-hoar crystals formed beneath the snow surface for several days and the surface layer, composed of both types of hoar crystal, showed a very weak shear strength.

Evaluation of MODIS land surface temperature with in-situ snow surface temperature from CREST-SAFE

2017 ◽  
Vol 38 (16) ◽  
pp. 4722-4740 ◽  
Author(s):  
Carlos L. Pérez-Díaz ◽  
Tarendra Lakhankar ◽  
Peter Romanov ◽  
Jonathan Muñoz ◽  
Reza Khanbilvardi ◽  
...  
Keyword(s):  
Surface Temperature ◽  
Land Surface Temperature ◽  
Land Surface ◽  
Snow Surface ◽  
Modis Land Surface Temperature ◽  
Snow Surface Temperature

MODIS-based estimates of strong snow surface temperature anomaly related to high altitude earthquakes of 2015

2017 ◽  
Vol 188 ◽  
pp. 1-8 ◽  
Author(s):  
Anshuman Bhardwaj ◽  
Shaktiman Singh ◽  
Lydia Sam ◽  
Akanksha Bhardwaj ◽  
F. Javier Martín-Torres ◽  
...  
Keyword(s):  
Surface Temperature ◽  
High Altitude ◽  
Temperature Anomaly ◽  
Snow Surface ◽  
Snow Surface Temperature
Sign in / Sign up

Export Citation Format

Share Document