The nature and role of incoherent interphase interfaces in diffusional solid-solid phase transformations

2006 ◽  
Vol 37 (13) ◽  
pp. 825-831
Author(s):  
T. B. Massalski ◽  
W. A. Soffa ◽  
D. E. Laughlin
Keyword(s):  
Phase Transformations ◽  
Solid Phase

Heat capacities and enthalpies of fusion and transformation for solvates of some salts with dimethyl sulfoxide and dimethylformamide

1988 ◽  
Vol 53 (12) ◽  
pp. 3072-3079
Author(s):  
Mojmír Skokánek ◽  
Ivo Sláma
Keyword(s):  
Heat Capacity ◽  
Phase Transformation ◽  
Phase Transformations ◽  
Dimethyl Sulfoxide ◽  
Liquidus Temperature ◽  
Molar Heat Capacity ◽  
Solid Phase ◽  
Zinc Nitrate ◽  
Heat Capacities ◽  
Liquid Phases

Molar heat capacities and molar enthalpies of fusion of the solvates Zn(NO3)2 . 2·24 DMSO, Zn(NO3)2 . 8·11 DMSO, Zn(NO3)2 . 6 DMSO, NaNO3 . 2·85 DMSO, and AgNO3 . DMF, where DMSO is dimethyl sulfoxide and DMF is dimethylformamide, have been determined over the temperature range 240 to 400 K. Endothermic peaks found for the zinc nitrate solvates below the liquidus temperature have been ascribed to solid phase transformations. The molar enthalpies of the solid phase transformations are close to 5 kJ mol-1 for all zinc nitrate solvates investigated. The dependence of the molar heat capacity on the temperature outside the phase transformation region can be described by a linear equation for both the solid and liquid phases.

Introduction to geomicrobiology

2018 ◽  
Author(s):  
David L. Kirchman
Keyword(s):  
Fossil Fuels ◽  
Solid Phase ◽  
Direct Reduction ◽  
Iron Oxidation ◽  
Mineral Dissolution ◽  
Precipitation Process ◽  
Soluble Ions ◽  
Chemolithoautotrophic Bacteria ◽  
The Impact

Geomicrobiology, the marriage of geology and microbiology, is about the impact of microbes on Earth materials in terrestrial systems and sediments. Many geomicrobiological processes occur over long timescales. Even the slow growth and low activity of microbes, however, have big effects when added up over millennia. After reviewing the basics of bacteria–surface interactions, the chapter moves on to discussing biomineralization, which is the microbially mediated formation of solid minerals from soluble ions. The role of microbes can vary from merely providing passive surfaces for mineral formation, to active control of the entire precipitation process. The formation of carbonate-containing minerals by coccolithophorids and other marine organisms is especially important because of the role of these minerals in the carbon cycle. Iron minerals can be formed by chemolithoautotrophic bacteria, which gain a small amount of energy from iron oxidation. Similarly, manganese-rich minerals are formed during manganese oxidation, although how this reaction benefits microbes is unclear. These minerals and others give geologists and geomicrobiologists clues about early life on Earth. In addition to forming minerals, microbes help to dissolve them, a process called weathering. Microbes contribute to weathering and mineral dissolution through several mechanisms: production of protons (acidity) or hydroxides that dissolve minerals; production of ligands that chelate metals in minerals thereby breaking up the solid phase; and direct reduction of mineral-bound metals to more soluble forms. The chapter ends with some comments about the role of microbes in degrading oil and other fossil fuels.

scholarly journals The Role of Electric Pressure/Stress Suppressing Pinhole Defect on Coalescence Dynamics of Electrified Droplet

Coatings ◽  
2021 ◽  
Vol 11 (5) ◽  
pp. 503
Author(s):  
Jaehyun Lee ◽  
Ehsan Esmaili ◽  
Giho Kang ◽  
Baekhoon Seong ◽  
Hosung Kang ◽  
...  
Keyword(s):  
Solid Phase ◽  
Critical Factor ◽  
Air Pressure ◽  
Conical Shape ◽  
Electric Stress ◽  
Bottom Interface ◽  
Electric Pressure ◽  
Pressure Stress ◽  
Air Film

The dimple occurs by sudden pressure inversion at the droplet’s bottom interface when a droplet collides with the same liquid-phase or different solid-phase. The air film entrapped inside the dimple is a critical factor affecting the sequential dynamics after coalescence and causing defects like the pinhole. Meanwhile, in the coalescence dynamics of an electrified droplet, the droplet’s bottom interfaces change to a conical shape, and droplet contact the substrate directly without dimple formation. In this work, the mechanism for the dimple’s suppression (interfacial change to conical shape) was studied investigating the effect of electric pressure. The electric stress acting on a droplet interface shows the nonlinear electric pressure adding to the uniform droplet pressure. This electric stress locally deforms the droplet’s bottom interface to a conical shape and consequentially enables it to overcome the air pressure beneath the droplet. The electric pressure, calculated from numerical tracking for interface and electrostatic simulation, was at least 108 times bigger than the air pressure at the center of the coalescence. This work helps toward understanding the effect of electric stress on droplet coalescence and in the optimization of conditions in solution-based techniques like printing and coating.

scholarly journals Internal melt figures in ice by rapid adiabatic compression

1994 ◽  
Vol 40 (134) ◽  
pp. 132-134
Author(s):  
R.E. Gagnon ◽  
C. Tulk ◽  
H. Kiefte
Keyword(s):  
Phase Transformations ◽  
Grain Boundaries ◽  
Single Crystals ◽  
Adiabatic Compression ◽  
Air Bubbles ◽  
Water Ice ◽  
Deep Focus ◽  
And Behavior ◽  
First Time

AbstractSingle crystals and bicrystals of water ice have been adiabatically pressurized to produce, and clearly illustrate, two types of internal melt figures: (1) dendritic figures that grow from nucleation imperfections on the specimen’s surface, or from air bubbles at grain boundaries, into the ice as pressure is elevated; and (2) compression melt fractures, flat liquid-filled disks, that nucleate at imperfections in the crystal and grow with the application of pressure eventually to sprout dendritic fingers at the periphery. The transparency of the ice permitted visualization of the growth and behavior of the figures, and this could be an important tool in understanding the role of phase transformations in deep-focus earthquakes. Correlation between figure size and pressure is noted for the first time.

Sign in / Sign up

Export Citation Format

Share Document