The effect of Li and La on NiO/Al2O3 catalyst for CH4/O2 to syngas reaction

1999 ◽  
Vol 68 (2) ◽  
pp. 243-247 ◽  
Author(s):  
Shenglin Liu ◽  
Guoxing Xiong ◽  
Weishen Yang ◽  
Shishan Sheng
Keyword(s):  
Al2o3 Catalyst ◽  
Syngas Reaction

Conversion of fructose into methyl lactate over SnO2/Al2O3 catalystin flow regime

2020 ◽  
pp. 43-47
Author(s):  
S.V. Prudius ◽  
◽  
N.L. Hes ◽  
A.M. Mylin ◽  
V.V. Brei ◽  
...  
Keyword(s):  
Flow Reactor ◽  
Practical Interest ◽  
Dimethyl Acetal ◽  
Racemic Mixture ◽  
Process Conditions ◽  
Impregnation Method ◽  
Aqueous Methanol ◽  
Methyl Lactate ◽  
Al2o3 Catalyst ◽  
Target Reaction

In recent years, numerous researchers have focused on the development of catalytic methods for processing of biomass-derived sugars into alkyl lactates, which are widely used as non-toxic solvents and are the starting material for obtaining monomeric lactide. In this work, the transformation of fructose into methyl lactate on Sn-containing catalyst in the flow reactor that may be of practical interest was studied. The supported Sn-containing catalyst was ob-tained by a simple impregnation method of granular γ-Al2O3. The catalytic ex-periments were performed in a flow reactor at temperatures of 160-190 °C and pressure of 3.0 MPa. The 1.6-9.5 wt.% fructose solutions in 80% aqueous methanol were used as a reaction mixture. It was found that addition to a reac-tion mixture of 0.03 wt.% potassium carbonate leads to the increase in selec-tivity towards methyl lactate on 15% at 100% conversion of fructose. Prod-ucts of the target reaction С6Н12О6 + 2СН3ОН = 2С4Н8О3 + 2Н2О were ana-lyzed using 13C NMR method. The following process conditions for obtaining of 65 mol% methyl lactate yield at 100% fructose conversion were found: use of 4.8 wt.% fructose solution in 80% methanol, 180 °С, 3.0 МПа and a load on catalyst 1.5 mmol C6H12O6/mlcat/h at contact time of 11 minutes. The cata-lyst productivity is 2.0 mmol C4H8O3/mlcat/h and the by-productі are 1,3-dihydroxyacetone dimethyl acetal (20%) and 5-hydroxymethylfurfural (10%). It should be noted that a racemic mixture of L- and D-methyl lactates has been obtained by conversion of D-fructose on the SnO2/Al2O3 catalyst. The SnO2/Al2O3 catalyst was found to be stable for 6 h while maintaining full fruc-tose conversion at 55–70% methyl lactate selectivity. After regeneration the catalyst completely restores the initial activity.

Dimethyldisulphide Hydrodesulphurization on NiCoMo / Al2O3 Catalyst

2017 ◽  
Vol 68 (7) ◽  
pp. 1496-1500
Author(s):  
Rami Doukeh ◽  
Mihaela Bombos ◽  
Ancuta Trifoi ◽  
Minodora Pasare ◽  
Ionut Banu ◽  
...  
Keyword(s):  
Good Accuracy ◽  
Fixed Bed ◽  
Continuous System ◽  
Space Velocity ◽  
Molar Ratio ◽  
Catalytic Reactor ◽  
Liquid Hourly Space Velocity ◽  
Hydrodesulfurization Process ◽  
Al2o3 Catalyst ◽  
Simplified Kinetic Model

Hydrodesulphurization of dimethyldisulphide was performed on Ni-Co-Mo /�-Al2O3 catalyst. The catalyst was characterized by determining the adsorption isotherms, the pore size distribution and the acid strength. Experiments were carried out on a laboratory echipament in continuous system using a fixed bed catalytic reactor at 50-100�C, pressure from 10 barr to 50 barr, the liquid hourly space velocity from 1h-1 to 4h-1 and the molar ratio H2 / dimethyldisulphide 60/1. A simplified kinetic model based on the Langmuir�Hinshelwood theory, for the dimethyldisulphide hydrodesulfurization process of dimethyldisulphide has been proposed. The results show the good accuracy of the model.

Catalytic Neutralization of Naphthenic Acid from Petroleum Crude Oil by Using Cerium Oxide Catalyst and 2- Methylimidazole in Polyethylene Glycol

2020 ◽  
Vol 13 ◽  
Author(s):  
Norshahidatul Akmar Mohd Shohaimi ◽  
Norfakhriah Jelani ◽  
Ahmad Zamani Ab Halim ◽  
Nor Hakimin Abdullah ◽  
Nurasmat Mohd Shukri
Keyword(s):  
Polyethylene Glycol ◽  
Crude Oil ◽  
Cerium Oxide ◽  
Active Sites ◽  
Naphthenic Acid ◽  
Naphthenic Acids ◽  
Catalyst Loading ◽  
High Concentration ◽  
Oil Refineries ◽  
Al2o3 Catalyst

: The presence of relatively high naphthenic acid in crude oil may contribute to the major corrosion in oil pipelines and distillation units in crude oil refineries. Thus, high concentration Naphthenic Acids crude oil is considered tobe of low quality and is marketed at lower prices. In order to overcome this problem, neutralization method had been developed to reduce the TAN value in crude oil. In this study, crude oil from Petronas Penapisan Melaka was investigated. The parameters studied were reagent concentration, catalyst loading, calcination temperature and reusability of the potential catalyst. Basic chemical used were 2- methylimidazole in polyethylene glycol (PEG 600) with concentration 100, 500 and 1000 ppm. Cerium oxide-based catalysts supported onto alumina prepared with different calcination temperatures. The catalyst was characterized by using Brunauer-Emmett-Teller (BET), Fourier Transform Infrared Spectroscopy (FTIR) and Thermogravimetry Analysis-Differential Thermal Gravity (TGA-DTG) to study physical properties of the catalyst. The Ce/Al2O3 catalyst calcined at 1000°C was the best catalyst due to larger surface area formation which lead to increment of active sites thus will boost the catalytic activity. The result showed that the Ce/Al2O3 catalyst meet Petronas requirement as the TAN value reduced to 0.6 mgKOH/g from original TAN value of 4.22 mgKOH/g. The best reduction of TAN was achieved by using catalyst loading of 0.39% and reagent of 1000 ppm.

Kinetics of catalytic reduction of nitrogen oxide by carbon monoxide on CuO/Al2O3 catalyst

1983 ◽  
Vol 48 (11) ◽  
pp. 3202-3208 ◽  
Author(s):  
Zdeněk Musil ◽  
Vladimír Pour
Keyword(s):  
Carbon Monoxide ◽  
Nitrogen Oxide ◽  
Rate Equation ◽  
Catalytic Reduction ◽  
Zero Order ◽  
Spectroscopic Measurements ◽  
First Order ◽  
Ir Spectroscopic ◽  
Kinetics Of ◽  
Al2o3 Catalyst

The kinetics of the reduction of nitrogen oxide by carbon monoxide on CuO/Al2O3 catalyst (8.36 mass % CuO) were determined at temperatures between 413 and 473 K. The reaction was found to be first order in NO and zero order in CO. The observed kinetics are consistent with a rate equation derived from a mechanism proposed on the basis of IR spectroscopic measurements.

Phenol Hydrodeoxygenation over a Reduced and Sulfided NiMo/γ-Al2O3 Catalyst

2019 ◽  
Vol 58 (16) ◽  
pp. 6278-6287 ◽  
Author(s):  
Chrysovalantis C. Templis ◽  
Constantinos J. Revelas ◽  
Anestis A. Papastylianou ◽  
Nikos G. Papayannakos
Keyword(s):  
Al2o3 Catalyst

scholarly journals Glycerol Hydrogenolysis with In Situ Hydrogen Produced via Methanol Steam Reforming: The Promoting Effect of Pd on a Cu/ZnO/Al2O3 Catalyst

Catalysts ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 110
Author(s):  
Yuanqing Liu ◽  
Chau T. Q. Mai ◽  
Flora T. T. Ng
Keyword(s):  
Steam Reforming ◽  
Catalyst Activity ◽  
Promoting Effect ◽  
Glycerol Conversion ◽  
Glycerol Hydrogenolysis ◽  
Glycerol Dehydration ◽  
Effect Of Pd ◽  
Al2o3 Catalyst ◽  
Reaction Equilibrium

The glycerol hydrogenolysis to produce 1,2-propanediol without using externally supplied hydrogen was investigated using methanol present in crude glycerol to provide in situ hydrogen via its steam reforming reaction. This paper focuses on the promoting effect of Pd on the reactivity of a Cu/Zn/Al2O3 catalyst. Adding 2 wt% Pd onto a Cu/ZnO/Al2O3 catalyst significantly improved the selectivity to 1,2-propanediol from 63.0% to 82.4% and the glycerol conversion from 70.2% to 99.4%. This enhancement on the catalytic activity by Pd is mainly due to the improved hydrogenation of acetol, which is the intermediate formed during the glycerol dehydration. The rapid hydrogenation of acetol can shift the reaction equilibrium of glycerol dehydration forward resulting in a higher glycerol conversion. The improved reducibility of the catalyst by Pd allows the catalyst to be reduced in situ during the reaction preventing any loss of catalyst activity due to any potential oxidation of the catalyst. The catalyst was slightly deactivated when it was firstly recycled resulting in a 5.4% loss of glycerol conversion due to the aggregation of Cu and the deactivation became less noticeable upon further recycling.

Improved Cl2 yield and stability of CeO2-MnOx/Al2O3 catalyst for HCl oxidation to Cl2 at higher reaction temperature

2021 ◽  
Vol 506 ◽  
pp. 111563
Author(s):  
Xin Tian ◽  
Yaping Li ◽  
Baining Lin ◽  
Shuai Wang ◽  
Yonghua Zhou ◽  
...  
Keyword(s):  
Reaction Temperature ◽  
Al2o3 Catalyst

Promoted adsorption of methyl mercaptan by γ-Al2O3 catalyst loaded with Cu/Mn

2021 ◽  
Vol 21 ◽  
pp. 101349
Author(s):  
Honghong Yi ◽  
Tao Tao ◽  
Shunzheng Zhao ◽  
Qingjun Yu ◽  
Fengyu Gao ◽  
...  
Keyword(s):  
Methyl Mercaptan ◽  
Al2o3 Catalyst
Sign in / Sign up

Export Citation Format

Share Document