Hydrostatic treatment of α-aluminium oxide powders part 1. Microstructure of the particles and sintering

Refractories ◽  
1994 ◽  
Vol 35 (6) ◽  
pp. 189-194
Author(s):  
V. V. Storozh ◽  
G. Ya. Akimov ◽  
G. K. Volkova ◽  
M. P. Gazhura
Keyword(s):  
Aluminium Oxide ◽  
Oxide Powders ◽  
Hydrostatic Treatment

Nanostructured aluminium oxide powders obtained by aspartic acid–nitrate gel-combustion routes

2010 ◽  
Vol 495 (2) ◽  
pp. 578-582 ◽  
Author(s):  
María Celeste Gardey Merino ◽  
Gustavo E. Lascalea ◽  
Laura M. Sánchez ◽  
Patricia G. Vázquez ◽  
Edgardo D. Cabanillas ◽  
...  
Keyword(s):  
Aspartic Acid ◽  
Aluminium Oxide ◽  
Oxide Powders ◽  
Gel Combustion

Methods to Determine Phytopharmaceuticals in Tobacco and Tobacco Products. 4th Report: A Procedure to Determine Vamidothion and its Metabolites/Methoden zur Bestimmung von Phytopharmaka in Tabak und Tabakerzeugnissen: IV. Mitteilung: Ein Bestimmungsverfahren fuer Vamidothion und seine Metaboliten

1977 ◽  
Vol 9 (2) ◽  
Author(s):  
A.N. Sagredos ◽  
R. Moser
Keyword(s):  
Mass Spectrometry ◽  
Nuclear Magnetic Resonance ◽  
Acetic Acid ◽  
Magnetic Resonance ◽  
Aluminium Oxide ◽  
Nuclear Magnetic Resonance Data ◽  
Gas Chromatograph ◽  
Tobacco Products ◽  
Magnetic Resonance Data ◽  
Resonance Data

AbstractBased on previous work (7) a method to simultaneously determine vamidothion [I], vamidothion-sulfoxide [II] and vamidothion sulfone [III] in tobacco has been developed. The compounds are extracted with water/acetone/acetic acid from the tobacco, cleansed over an aluminium oxide column and then determined on the gas chromatograph with the specific sulphur detector. Rates of recovery are 70 % - 92 %, the determination level is 0.1 ppm. Mass spectrometry and nuclear magnetic resonance data of vamidothion [I], vamidothion-sulfoxide [ II ] and vamidothion-sulfone [III] are given.

Testing Aluminium Oxide based Ceramics at Irregular Interrupted Cut

2013 ◽  
Vol 10 (2) ◽  
pp. 26-28
Author(s):  
Ladislav Kyncl ◽  
Robert Cep ◽  
Pavel Novacek ◽  
Jiri Schreier
Keyword(s):  
Aluminium Oxide ◽  
Cutting Effect ◽  
Intermittent Cutting

Abstract This article discusses the test removable ceramic plates during machining with interrupted cut. Tests were performed on a lathe, which was clamped preparation which simulated us the interrupted cut. By changing the number plates mounted in a preparation it was a regular or irregular cut. When with four plates it was regular interrupted cut, the remaining three variants were already irregular cut. It was examined whether it will have the irregular intermittent cutting effect on the insert and possibly how it will change life of inserts during irregular interrupted cut.

Sign in / Sign up

Export Citation Format

Share Document