The origins and forms of dynamic instability in clear air at high altitude

1971 ◽  
Vol 20 (1) ◽  
pp. 1-12 ◽  
Author(s):  
R. S. Scorer
Keyword(s):  
High Altitude ◽  
Dynamic Instability

Contrast of Filament Bright Rims

1994 ◽  
Vol 144 ◽  
pp. 365-367
Author(s):  
E. V. Kononovich ◽  
O. B. Smirnova ◽  
P. Heinzel ◽  
P. Kotrč
Keyword(s):  
High Altitude ◽  
Line Profile ◽  
Line Center ◽  
Magnetic Structures ◽  
The Mean

AbstractThe Hα filtergrams obtained at Tjan-Shan High Altitude Observatory near Alma-Ata (Moscow University Station) were measured in order to specify the bright rims contrast at different points along the line profile (0.0; ± 0.25; ± 0.5; ± 0.75 and ± 1.0 Å). The mean contrast value in the line center is about 25 percent. The bright rims interpretation as the bases of magnetic structures supporting the filaments is suggested.

Clean Electron Microscope Substrate Films Used for Micrometeorite Collection and Study

1967 ◽  
Vol 25 ◽  
pp. 366-367
Author(s):  
D. M. Davies ◽  
R. Kemner ◽  
E. F. Fullam
Keyword(s):  
Thin Film ◽  
Electron Microscope ◽  
High Altitude ◽  
Amyl Acetate ◽  
Temperature Variations ◽  
Film Forming ◽  
Film Specimen ◽  
Particulate Contaminants

All serious electron microscopists at one time or another have been concerned with the cleanliness and freedom from artifacts of thin film specimen support substrates. This is particularly important where there are relatively few particles of a sample to be found for study, as in the case of micrometeorite collections. For the deposition of such celestial garbage through the use of balloons, rockets, and aircraft, the thin film substrates must have not only all the attributes necessary for use in the electron microscope, but also be able to withstand rather wide temperature variations at high altitude, vibration and shock inherent in the collection vehicle's operation and occasionally an unscheduled violent landing.Nitrocellulose has been selected as a film forming material that meets these requirements yet lends itself to a relatively simple clean-up procedure to remove particulate contaminants. A 1% nitrocellulose solution is prepared by dissolving “Parlodion” in redistilled amyl acetate from which all moisture has been removed.

Analysis of the Mechanism of Microtubule Dynamic Instability Using a UV Microbeam to Sever Elongating Microtubules

1988 ◽  
Vol 46 ◽  
pp. 122-123
Author(s):  
R.A Walker ◽  
S. Inoue ◽  
E.D. Salmon
Keyword(s):  
Dynamic Instability ◽  
Microtubule Dynamic ◽  
Gtp Hydrolysis ◽  
Abrupt Transition ◽  
Microtubule Associated Proteins ◽  
Asymmetrical Structure ◽  
Associated Proteins

Microtubules polymerized in vitro from tubulin purified free of microtubule-associated proteins exhibit dynamic instability (1,2,3). Free microtubule ends exist in persistent phases of elongation or rapid shortening with infrequent, but, abrupt transitions between these phases. The abrupt transition from elongation to rapid shortening is termed catastrophe and the abrupt transition from rapid shortening to elongation is termed rescue. A microtubule is an asymmetrical structure. The plus end grows faster than the minus end. The frequency of catastrophe of the plus end is somewhat greater than the minus end, while the frequency of rescue of the plus end in much lower than for the minus end (4).The mechanism of catastrophe is controversial, but for both the plus and minus microtubule ends, catastrophe is thought to be dependent on GTP hydrolysis. Microtubule elongation occurs by the association of tubulin-GTP subunits to the growing end. Sometime after incorporation into an elongating microtubule end, the GTP is hydrolyzed to GDP, yielding a core of tubulin-GDP capped by tubulin-GTP (“GTP-cap”).

Time-Resolved Cryo-Electron Microscopy of Oscillating Microtubules

1990 ◽  
Vol 48 (1) ◽  
pp. 502-503
Author(s):  
Eva-Maria Mandelkow ◽  
Ron Milligan
Keyword(s):  
Electron Microscopy ◽  
Dynamic Instability ◽  
Entire Solution ◽  
Reaction Scheme ◽  
Time Resolved ◽  
X Ray ◽  
X Ray Scattering ◽  
A Chain ◽  
Ray Scattering

Microtubules form part of the cytoskeleton of eukaryotic cells. They are hollow libers of about 25 nm diameter made up of 13 protofilaments, each of which consists of a chain of heterodimers of α-and β-tubulin. Microtubules can be assembled in vitro at 37°C in the presence of GTP which is hydrolyzed during the reaction, and they are disassembled at 4°C. In contrast to most other polymers microtubules show the behavior of “dynamic instability”, i.e. they can switch between phases of growth and phases of shrinkage, even at an overall steady state [1]. In certain conditions an entire solution can be synchronized, leading to autonomous oscillations in the degree of assembly which can be observed by X-ray scattering (Fig. 1), light scattering, or electron microscopy [2-5]. In addition such solutions are capable of generating spontaneous spatial patterns [6].In an earlier study we have analyzed the structure of microtubules and their cold-induced disassembly by cryo-EM [7]. One result was that disassembly takes place by loss of protofilament fragments (tubulin oligomers) which fray apart at the microtubule ends. We also looked at microtubule oscillations by time-resolved X-ray scattering and proposed a reaction scheme [4] which involves a cyclic interconversion of tubulin, microtubules, and oligomers (Fig. 2). The present study was undertaken to answer two questions: (a) What is the nature of the oscillations as seen by time-resolved cryo-EM? (b) Do microtubules disassemble by fraying protofilament fragments during oscillations at 37°C?

Dynamic electrocardiography at high altitude

1966 ◽  
Vol 118 (2) ◽  
pp. 132-138 ◽  
Author(s):  
J. S. Sanders
Keyword(s):  
High Altitude

Development of techniques for the evaluation of high altitude pressure suits.

1959 ◽  
Author(s):  
Renato Contini ◽  
Rudolfs Drillis ◽  
Lawrence Slote
Keyword(s):  
High Altitude
Sign in / Sign up

Export Citation Format

Share Document