A spectrophotometric method for the determination of the oxygen to metal ratio in U3O8

1994 ◽  
Vol 188 (6) ◽  
pp. 463-470 ◽  
Author(s):  
N. L. Sreenivasan ◽  
T. G. Srinivasan ◽  
P. R. Vasudeva Rao
Keyword(s):  
Spectrophotometric Method ◽  
Metal Ratio

scholarly journals Spectroscopic Determination of Fluoride Using Eriochrome Black T (EBT) as a Spectrophotometric Reagent from Groundwater

2021 ◽  
Vol 2021 ◽  
pp. 1-10
Author(s):  
Atinafu G/Mariam ◽  
Abebe Diro ◽  
Tsegaye Girma Asere ◽  
Demelash Jado ◽  
Fekadu Melak
Keyword(s):  
Spectrophotometric Method ◽  
Toxic Chemicals ◽  
Attractive Alternative ◽  
Eriochrome Black T ◽  
Ligand Type ◽  
Groundwater Samples ◽  
Experimental Parameters ◽  
Metal Ratio ◽  
Concentration Levels

Fluoride health problem is a great concern worldwide, most often as a result of groundwater intake. Thus, determination of fluoride is vital to take appropriate measures upon fluoride contamination of water. Potentiometric method of analysis is reliable for the determination of fluoride in various samples. In addition, spectroscopic methods are found important to quantify fluoride levels from water; however, several factors hinder its easier determination. Among the bottlenecks, the use of toxic chemicals and tedious steps in preparing chemicals (e.g., SPADNS method) are to mention a few. In this study, a spectrophotometric method was developed for the determination of fluoride from groundwater using Eriochrome Black T (EBT) as a spectroscopic reagent. Experimental parameters that influence the determination of fluoride including ligand type, kinetics, pH, and ligand-to-metal ratio were assayed. Evaluation of fluoride levels showed that Beer–Lambert’s law is obeyed in the range of 0.3–5.0 mg/L at 544 nm. The calibration curve, resulting in good linearity (R2 = 0.9997), was considered during quantitative analysis of the samples and in the spiking analysis. The limits of detection (LOD) and quantification (LOQ) of the method were found to be 0.19 and 0.64 mg/L, respectively. The precision studied in terms of intraday and interday at three concentration levels showed less than 5.4% RSD. Applicability of the method was investigated by analyzing groundwater samples spiked with fluoride standards, and satisfactory recoveries in the range of 98.18–111.4 were demonstrated. The developed spectrophotometric method has been successfully applied for fluoride determinations in groundwater samples. Thus, it could be used as an attractive alternative for the determination of fluoride from groundwater.

Extractive Spectrophotometric Method for the Determination of Glibenclamide by Ion-Pair Complex in Pure Form and Pharmaceutical Formulation

2019 ◽  
Vol 9 (o3) ◽  
Author(s):  
RUAA MUAYAD MAHMOOD ◽  
HAMSA MUNAM YASSEN ◽  
SAMAR , NAJWA ISSAC ABDULLA AHMED DARWEESH ◽  
NAJWA ISSAC ABDULLA
Keyword(s):  
Spectrophotometric Method ◽  
Molar Absorptivity ◽  
Ion Pair ◽  
Pharmaceutical Formulation ◽  
Ratio Method ◽  
Colored Complex ◽  
Colored Product ◽  
Method Of Continuous Variation ◽  
Job's Method

Simple, rapid and sensitive extractive spectrophotometric method is presented for the determination of glibenclamide (Glb) based on the formation of ion-pair complex between the Glb and anionic dye, methyl orange (MO) at pH 4. The yellow colored complex formed was quantitatively extracted into dichloromethane and measured at 426 nm. The colored product obeyed Beer’s law in the concentration range of (0.5-40) μg.ml-1. The value of molar absorptivity obtained from Beer’s data was found to be 31122 L.mol-1.cm-1, Sandell’s sensitivity value was calculated to be 0.0159 μg.cm-2, while the limits of detection (LOD) and quantification (LOQ) were found to be 0.1086 and 0.3292 μg.ml-1, respectively. The stoichiometry of the complex created between the Glb and MO was 1:1 as determined via Job’s method of continuous variation and mole ratio method. The method was successfully applied for the analysis of pharmaceutical formulation.

UV spectroscopic method for determination of phenytoin in bulk and injection forms

2019 ◽  
Author(s):  
Chem Int
Keyword(s):  
Quality Control ◽  
Spectrophotometric Method ◽  
Spectroscopic Method ◽  
Ich Guidelines ◽  
Precision And Accuracy ◽  
Routine Quality Control

Recent study was conducted to develop a simple UV spectrophotometric method to determine Phenytoin in bulk and injection form according to official requirement and validate as per ICH guidelines. λmax of Phenytoin was found 202 nm. Linearity existed perceived in the concentration assortment 2-8 μg/ml (r2 = 0.999) for the method. The method was validated pertaining to linearity, precision and accuracy studies, LOD and LOQ consistent with ICH guidelines. The existent method was establish to be simple, linear, precise, accurate as well as sensitive and can be applied for routine quality control enquiry for the analysis of Phenytoin in bulk and injection form.

Sign in / Sign up

Export Citation Format

Share Document