Numerical modeling of thermocapillary convection in a fluid layer with local heating of the free surface

1988 ◽  
Vol 22 (4) ◽  
pp. 584-588 ◽  
Author(s):  
Yu. V. Sanochkin ◽  
R. S. Tukhvatullin ◽  
S. S. Filippov
Author(s):  
Timothée Jamin ◽  
Leonardo Gordillo ◽  
Gerardo Ruiz-Chavarría ◽  
Michael Berhanu ◽  
Eric Falcon

We report laboratory experiments on surface waves generated in a uniform fluid layer whose bottom undergoes an upward motion. Simultaneous measurements of the free-surface deformation and the fluid velocity field are focused on the role of the bottom kinematics (i.e. its spatio-temporal features) in wave generation. We observe that the fluid layer transfers bottom motion to the free surface as a temporal high-pass filter coupled with a spatial low-pass filter. Both filter effects are often neglected in tsunami warning systems, particularly in real-time forecast. Our results display good agreement with a prevailing linear theory without any parameter fitting. Based on our experimental findings, we provide a simple theoretical approach for modelling the rapid kinematics limit that is applicable even for initially non-flat bottoms: this may be a key step for more realistic varying bathymetry in tsunami scenarios.


2001 ◽  
Author(s):  
Bok-Cheol Sim ◽  
Abdelfattah Zebib

Abstract Thermocapillary convection driven by a uniform heat flux in an open cylindrical container of unit aspect ratio is investigated by two- and three-dimensional numerical simulations. The undeformable free surface is either flat or curved as determined by the fluid volume (V ≤ 1) and the Young-Laplace equation. Convection is steady and axisymmetric at sufficiently low values of the Reynolds number (Re) with either flat or curved interfaces. Only steady convection is possible in strictly axisymmetric computations. Transition to oscillatory three-dimensional motions occurs as Re increases beyond a critical value dependent on Pr and V. With a flat free surface (V = 1), two-lobed pulsating waves are found on the free surface and prevail with increasing Re. While the critical Re increases with increasing Pr, the critical frequency decreases. In the case of a concave surface, four azimuthal waves are found rotating clockwise on the surface. The critical Re decreases with increasing fluid volume, and the critical frequency is found to increase. The numerical results with either flat or curved free surfaces are in good quantitative agreement with space experiments.


2020 ◽  
Vol 24 (6 Part B) ◽  
pp. 4159-4171
Author(s):  
Shuo Yang ◽  
Rui Ma ◽  
Qiaosheng Deng ◽  
Guofeng Wang ◽  
Yu Gao ◽  
...  

A uniform axial or transverse magnetic field is applied on the silicon oil based ferrofluid of high Prandtl number fluid (Pr ? 111.67), and the effect of magnetic field on the thermocapillary convection is investigated. It is shown that the location of vortex core of thermocapillary convection is mainly near the free surface of liquid bridge due to the inhibition of the axial magnetic field. A velocity stagnation region is formed inside the liquid bridge under the axial magnetic field (B = 0.3-0.5 T). The disturbance of bulk reflux and surface flow is suppressed by the increasing axial magnetic field. There is a dynamic response of free surface deformation to the axial magnetic field, and then the contact angle variation of the free surface at the hot corner is as following, ?hot, B = 0.5 T = 83.34? > ?hot, B = 0.3 T = 72.16? > > ?hot,B = 0.1 T = 54.21? > ?hot, B = 0 T = 43.33?. The results show that temperature distribution near the free surface is less and less affected by thermocapillary convection with the increasing magnetic field, and it presents a characteristic of heat-conduction. In addition, the transverse magnetic field does not realize the fundamental inhibition for thermocapillary convection, but it transfers the influence of thermocapillary convection to the free surface.


Sign in / Sign up

Export Citation Format

Share Document