Physical effects which distort measurement of the rest mass of the neutrino from beta spectra

1984 ◽  
Vol 27 (4) ◽  
pp. 279-286
Author(s):  
M. E. Gertsenshtein
Keyword(s):  
Rest Mass ◽  
Beta Spectra ◽  
Physical Effects

Auger lines in the beta-spectra of ux and as

Physica ◽  
1952 ◽  
Vol 18 (2) ◽  
pp. 1253-1256
Author(s):  
P STOKER ◽  
O HOK
Keyword(s):  
Beta Spectra

Modeling Vibration-Induced Tire-Pavement Interaction Noise in the Mid-frequency Range

2020 ◽  
Author(s):  
Sterling McBride ◽  
Ricardo Burdisso ◽  
Corina Sandu
Keyword(s):  
Sound Intensity ◽  
Element Model ◽  
Dominant Frequency ◽  
Contact Forces ◽  
Surface Velocity ◽  
New Wave ◽  
Normal Surface ◽  
Radiated Noise ◽  
Physical Effects ◽  
Effects Of Rotation

ABSTRACT Tire-pavement interaction noise (TPIN) is one of the main sources of exterior noise produced by vehicles traveling at greater than 50 kph. The dominant frequency content is typically within 500–1500 Hz. Structural tire vibrations are among the principal TPIN mechanisms. In this work, the structure of the tire is modeled and a new wave propagation solution to find its response is proposed. Multiple physical effects are accounted for in the formulation. In an effort to analyze the effects of curvature, a flat plate and a cylindrical shell model are presented. Orthotropic and nonuniform structural properties along the tire's transversal direction are included to account for differences between its sidewalls and belt. Finally, the effects of rotation and inflation pressure are also included in the formulation. Modeled frequency response functions are analyzed and validated. In addition, a new frequency-domain formulation is presented for the computation of input tread pattern contact forces. Finally, the rolling tire's normal surface velocity response is coupled with a boundary element model to demonstrate the radiated noise at the leading and trailing edge locations. These results are then compared with experimental data measured with an on-board sound intensity system.

Translocations In Space-Time and Simultaneous States of the Universe: Convergent Quantifications and Alternative Solutions from the Principles of Physics for the Challenges of “Time Travel” and “Parallel Universes”

2016 ◽  
pp. 4058-4069
Author(s):  
Michael A Persinger
Keyword(s):  
Single Photon ◽  
Rest Mass ◽  
Space Time ◽  
Hydrogen Line ◽  
Magnetic Forces ◽  
Universal Space ◽  
Potential Applications ◽  
Order Of Magnitude ◽  
Alternative Solutions ◽  
The Universe

                                Translation of four dimensional axes anywhere within the spatial and temporal boundaries of the universe would require quantitative values from convergence between parameters that reflect these limits. The presence of entanglement and volumetric velocities indicates that the initiating energy for displacement and transposition of axes would be within the upper limit of the rest mass of a single photon which is the same order of magnitude as a macroscopic Hamiltonian of the modified Schrödinger wave function. The representative metaphor is that any local 4-D geometry, rather than displaying restricted movement through Minkowskian space, would instead expand to the total universal space-time volume before re-converging into another location where it would be subject to cause-effect. Within this transient context the contributions from the anisotropic features of entropy and the laws of thermodynamics would be minimal.  The central operation of a fundamental unit of 10-20 J, the hydrogen line frequency, and the Bohr orbital time for ground state electrons would be required for the relocalized manifestation. Similar quantified convergence occurs for the ~1012 parallel states within space per Planck’s time which solve for phase-shift increments where Casimir and magnetic forces intersect.  Experimental support for these interpretations and potential applications is considered. The multiple, convergent solutions of basic universal quantities suggest that translations of spatial axes into adjacent spatial states and the transposition of four dimensional configurations any where and any time within the universe may be accessed but would require alternative perspectives and technologies.

NUMERICAL STUDY OF DETONATION PROPAGATION IN VISCOUS TURBULENT FLOW IN A DUCT

2020 ◽  
Author(s):  
V. A. SABELNIKOV ◽  
◽  
V. V. VLASENKO ◽  
S. BAKHNE ◽  
S. S. MOLEV ◽  
...  
Keyword(s):  
Complex Geometry ◽  
Numerical Study ◽  
Navier Stokes ◽  
Detonation Waves ◽  
Detonation Propagation ◽  
Eddy Simulation ◽  
Detonation Structure ◽  
Classical Studies ◽  
Large Eddy ◽  
Physical Effects

Gasdynamics of detonation waves was widely studied within last hundred years - analytically, experimentally, and numerically. The majority of classical studies of the XX century were concentrated on inviscid aspects of detonation structure and propagation. There was a widespread opinion that detonation is such a fast phenomenon that viscous e¨ects should have insigni¦cant in§uence on its propagation. When the era of calculations based on the Reynolds-averaged Navier- Stokes (RANS) and large eddy simulation approaches came into effect, researchers pounced on practical problems with complex geometry and with the interaction of many physical effects. There is only a limited number of works studying the in§uence of viscosity on detonation propagation in supersonic §ows in ducts (i. e., in the presence of boundary layers).

scholarly journals Possible Pitfalls in the Analysis of Minerals and Loose Materials by Portable XRF, and How to Overcome Them

Minerals ◽  
2020 ◽  
Vol 11 (1) ◽  
pp. 33
Author(s):  
Valérie Laperche ◽  
Bruno Lemière
Keyword(s):  
Fluorescence Spectroscopy ◽  
Laboratory Data ◽  
Data Sets ◽  
Light Elements ◽  
Portable Xrf ◽  
X Ray ◽  
Protective Films ◽  
The Matrix ◽  
Valuable Complement ◽  
Physical Effects

Portable X-ray fluorescence spectroscopy is now widely used in almost any field of geoscience. Handheld XRF analysers are easy to use, and results are available in almost real time anywhere. However, the results do not always match laboratory analyses, and this may deter users. Rather than analytical issues, the bias often results from sample preparation differences. Instrument setup and analysis conditions need to be fully understood to avoid reporting erroneous results. The technique’s limitations must be kept in mind. We describe a number of issues and potential pitfalls observed from our experience and described in the literature. This includes the analytical mode and parameters; protective films; sample geometry and density, especially for light elements; analytical interferences between elements; physical effects of the matrix and sample condition, and more. Nevertheless, portable X-ray fluorescence spectroscopy (pXRF) results gathered with sufficient care by experienced users are both precise and reliable, if not fully accurate, and they can constitute robust data sets. Rather than being a substitute for laboratory analyses, pXRF measurements are a valuable complement to those. pXRF improves the quality and relevance of laboratory data sets.

Sign in / Sign up

Export Citation Format

Share Document