State of the art and development prospects for x-ray dilatometry in measuring linear expansion coefficients for refractory materials at high temperatures

1986 ◽  
Vol 29 (9) ◽  
pp. 853-856
Author(s):  
E. I. Zoz ◽  
A. I. Alekhin ◽  
I. N. Rudyak

Barium titanium oxide, which is tetragonal at room temperature, changes about 120° C to a cubic structure. This change has been followed in detail by means of X-ray powder photo­graphs taken in a 19 cm. powder camera at intervals of a few degrees over a range covering the transition point. The unit cell, which contains the formula number of atoms, retains its identity throughout the transition, and the atomic parameters are unaltered. The change is simply in the axial lengths, and these vary continuously with the temperature, though not linearly, the varia­tion becoming more rapid near the transition point. While the linear expansion coefficients along and perpendicular to the tetrad axis are large and of opposite sign, the volume expan­sion coefficient is small and positive. There is no discontinuous change either of linear spacing or of volume detectable at the transition point, but there is a sharp discontinuity in the linear expansion coefficients, and a marked increase in the volume expansion coefficient which is probably, though not certainly, discontinuous. The transition suggests a typical λ-point change. The specific heat has not been deter­mined, but the thermal expansion curve has the characteristic λ shape. Co-existence of cubic and tetragonal structures, in proportions depending on the temperature, occurs over a range of some degrees near the transition point, and is attributed to the effect of local stresses in facilitating or hindering a change between two structures whose energy difference is very small in this temperature range. Below room temperature, observations made down to -183° C suggest that the structure may have a second transition point somewhere below this and become cubic again, the change being of the same nature as that at 120° C. It is argued that the room-temperature structure can only be explained by the existence of directed bonds, and that the breaking of these bonds with increasing temperature is respon­sible for the 120°C transition. The low-temperature transition is explained by postulating a more complete set of bonds, probably an octahedral complex, which partially breaks down at this temperature to give the square formation observed in the room-temperature structure. The possible nature of the directed bonds is discussed qualitatively. The condition which makes possible the formation of such bonds is likely to be the abnormal volume available to the Ti atom, which is due to the effect of the large Ba ion in forcing apart the oxygen lattice. The directed bond system will only contribute a small part to the attractive energy of the lattice, which is mainly ionic in character. The hypothesis that directed bonds exist, whatever their origin, is used for a tentative explanation of anomalous variations of intensity of the X-ray lines observed at temperatures near the transition point.


2013 ◽  
Vol 28 (S2) ◽  
pp. S33-S40 ◽  
Author(s):  
C. González-Silgo ◽  
C. Guzmán-Afonso ◽  
V. M. Sánchez-Fajardo ◽  
S. Acosta-Gutiérrez ◽  
A. Sánchez-Soares ◽  
...  

Two polymorphs of Holmium molybdate, known as β'-phase and γ-phase, were prepared by solid state reaction with different thermal treatments. These polycrystalline samples have been studied for the first time by X-ray thermodiffractometry from room temperature up to 1300 K. We found that the initial β'-phase undergoes a transition to a β-phase and then to a γ-phase. The γ (hydrated)-phase, turns to the γ (dehydrated)-phase and then to the β-phase. Each sequence involves a reversible and an irreversible phase transition for Ho2(MoO4)3. Both polymorphs have remarkable physical properties like nonlinear optics, ferroelectricity and negative thermal expansion. We have calculated the linear expansion coefficients of both phases. We have obtained a positive coefficient for the β'-phase and a negative one for the γ-phase. Moreover, we have made a comparison of the obtained coefficients with previous results for other rare earth molybdates.


Author(s):  
M.G. Isaenkova ◽  
◽  
A.V. Tenishev ◽  
Yu.A. Perlovich ◽  
S.D. Stolbov ◽  
...  

The temperature dependences of the periods a and c of the crystal structure of a-Zr and thermal linear expansion coefficients (TLEC) of textured cladding tubes and rods of E110opt Zr-based alloy in the axial direction in the temperature range of 293-873 K (20-600 °С) were determined. On the basis of Kearns’ integral texture parameters for cladding tubes and rods, TLEC values were calculated. The calculated values of the TLEC turned out to be significantly smaller than the values measured by the dilatometric method. Simulation of the process of thermal expansion of goods showed that the observed differences in the calculated and measured values of the TLEC can be due to layer-by-layer texture inhomogeneity of tubes and internal stresses arising between the layers.


2020 ◽  
Author(s):  
Pia Vervoorts ◽  
Stefan Burger ◽  
Karina Hemmer ◽  
Gregor Kieslich

The zeolitic imidazolate frameworks ZIF-8 and ZIF-67 harbour a series of fascinating stimuli responsive properties. Looking at their responsitivity to hydrostatic pressure as stimulus, open questions exist regarding the isotropic compression with non-penetrating pressure transmitting media. By applying a state-of-the-art high-pressure powder X-ray diffraction setup, we revisit the high-pressure behaviour of ZIF-8 and ZIF-67 up to <i>p</i> = 0.4 GPa in small pressure increments. We observe a drastic, reversible change of high-pressure powder X-ray diffraction data at <i>p</i> = 0.3 GPa, discovering large volume structural flexibility in ZIF-8 and ZIF-67. Our results imply a shallow underlying energy landscape in ZIF-8 and ZIF-67, an observation that might point at rich polymorphism of ZIF-8 and ZIF-67, similar to ZIF-4(Zn).<br>


2020 ◽  
Author(s):  
Pia Vervoorts ◽  
Stefan Burger ◽  
Karina Hemmer ◽  
Gregor Kieslich

The zeolitic imidazolate frameworks ZIF-8 and ZIF-67 harbour a series of fascinating stimuli responsive properties. Looking at their responsitivity to hydrostatic pressure as stimulus, open questions exist regarding the isotropic compression with non-penetrating pressure transmitting media. By applying a state-of-the-art high-pressure powder X-ray diffraction setup, we revisit the high-pressure behaviour of ZIF-8 and ZIF-67 up to <i>p</i> = 0.4 GPa in small pressure increments. We observe a drastic, reversible change of high-pressure powder X-ray diffraction data at <i>p</i> = 0.3 GPa, discovering large volume structural flexibility in ZIF-8 and ZIF-67. Our results imply a shallow underlying energy landscape in ZIF-8 and ZIF-67, an observation that might point at rich polymorphism of ZIF-8 and ZIF-67, similar to ZIF-4(Zn).<br>


Author(s):  
Carlo Grilletto ◽  
Steve Hsiung ◽  
Andrew Komrowski ◽  
John Soopikian ◽  
Daniel J.D. Sullivan ◽  
...  

Abstract This paper describes a method to "non-destructively" inspect the bump side of an assembled flip-chip test die. The method is used in conjunction with a simple metal-connecting "modified daisy chain" die and makes use of the fact that polished silicon is transparent to infra-red (IR) light. The paper describes the technique, scope of detection and examples of failure mechanisms successfully identified. It includes an example of a shorting anomaly that was not detectable with the state of the art X-ray equipment, but was detected by an IR emission microscope. The anomalies, in many cases, have shown to be the cause of failure. Once this has been accomplished, then a reasonable deprocessing plan can be instituted to proceed with the failure analysis.


2021 ◽  
Vol 9 (1) ◽  
Author(s):  
Aysen Degerli ◽  
Mete Ahishali ◽  
Mehmet Yamac ◽  
Serkan Kiranyaz ◽  
Muhammad E. H. Chowdhury ◽  
...  

AbstractComputer-aided diagnosis has become a necessity for accurate and immediate coronavirus disease 2019 (COVID-19) detection to aid treatment and prevent the spread of the virus. Numerous studies have proposed to use Deep Learning techniques for COVID-19 diagnosis. However, they have used very limited chest X-ray (CXR) image repositories for evaluation with a small number, a few hundreds, of COVID-19 samples. Moreover, these methods can neither localize nor grade the severity of COVID-19 infection. For this purpose, recent studies proposed to explore the activation maps of deep networks. However, they remain inaccurate for localizing the actual infestation making them unreliable for clinical use. This study proposes a novel method for the joint localization, severity grading, and detection of COVID-19 from CXR images by generating the so-called infection maps. To accomplish this, we have compiled the largest dataset with 119,316 CXR images including 2951 COVID-19 samples, where the annotation of the ground-truth segmentation masks is performed on CXRs by a novel collaborative human–machine approach. Furthermore, we publicly release the first CXR dataset with the ground-truth segmentation masks of the COVID-19 infected regions. A detailed set of experiments show that state-of-the-art segmentation networks can learn to localize COVID-19 infection with an F1-score of 83.20%, which is significantly superior to the activation maps created by the previous methods. Finally, the proposed approach achieved a COVID-19 detection performance with 94.96% sensitivity and 99.88% specificity.


Nanomaterials ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 560
Author(s):  
Alexandra Carvalho ◽  
Mariana C. F. Costa ◽  
Valeria S. Marangoni ◽  
Pei Rou Ng ◽  
Thi Le Hang Nguyen ◽  
...  

We show that the degree of oxidation of graphene oxide (GO) can be obtained by using a combination of state-of-the-art ab initio computational modeling and X-ray photoemission spectroscopy (XPS). We show that the shift of the XPS C1s peak relative to pristine graphene, ΔEC1s, can be described with high accuracy by ΔEC1s=A(cO−cl)2+E0, where c0 is the oxygen concentration, A=52.3 eV, cl=0.122, and E0=1.22 eV. Our results demonstrate a precise determination of the oxygen content of GO samples.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Mikolaj Grabowski ◽  
Ewa Grzanka ◽  
Szymon Grzanka ◽  
Artur Lachowski ◽  
Julita Smalc-Koziorowska ◽  
...  

AbstractThe aim of this paper is to give an experimental evidence that point defects (most probably gallium vacancies) induce decomposition of InGaN quantum wells (QWs) at high temperatures. In the experiment performed, we implanted GaN:Si/sapphire substrates with helium ions in order to introduce a high density of point defects. Then, we grew InGaN QWs on such substrates at temperature of 730 °C, what caused elimination of most (but not all) of the implantation-induced point defects expanding the crystal lattice. The InGaN QWs were almost identical to those grown on unimplanted GaN substrates. In the next step of the experiment, we annealed samples grown on unimplanted and implanted GaN at temperatures of 900 °C, 920 °C and 940 °C for half an hour. The samples were examined using Photoluminescence, X-ray Diffraction and Transmission Electron Microscopy. We found out that the decomposition of InGaN QWs started at lower temperatures for the samples grown on the implanted GaN substrates what provides a strong experimental support that point defects play important role in InGaN decomposition at high temperatures.


Sign in / Sign up

Export Citation Format

Share Document