Use of low-frequency magnetoacoustic resonance in electromagnetic measurements

1984 ◽  
Vol 27 (2) ◽  
pp. 169-173
Author(s):  
L. N. Gubanova ◽  
E. D. Koltik ◽  
Yu. V. Tarbeev
Geophysics ◽  
2006 ◽  
Vol 71 (5) ◽  
pp. G211-G223 ◽  
Author(s):  
Lasse Amundsen ◽  
Lars Løseth ◽  
Rune Mittet ◽  
Svein Ellingsrud ◽  
Bjørn Ursin

This paper gives a unified treatment of electromagnetic (EM) field decomposition into upgoing and downgoing components for conductive and nonconductive media, where the electromagnetic data are measured on a plane in which the electric permittivity, magnetic permeability, and electrical conductivity are known constants with respect to space and time. Above and below the plane of measurement, the medium can be arbitrarily inhomogeneous and anisotropic. In particular, the proposed decomposition theory applies to marine EM, low-frequency data acquired for hydrocarbon mapping where the upgoing components of the recorded field guided and refracted from the reservoir, that are of interest for the interpretation. The direct-source field, the refracted airwave induced by the source, the reflected field from the sea surface, and mostmagnetotelluric noise traveling downward just below the seabed are field components that are considered to be noise in electromagnetic measurements. The viability and validity of the decomposition method is demonstrated using modeled and real marine EM data, also termed seabed logging (SBL) data. The synthetic data are simulated in a model that is fairly representative of the geologic area where the real SBL were collected. The results from the synthetic data study therefore are used to assist in the interpretation of the real data from an area with [Formula: see text] water depth above a known gas province offshore Norway. The effect of the airwave is seen clearly in measured data. After field decomposition just below the seabed, the upgoing component of the recorded electric field has almost linear phase, indicating that most of the effect of the airwave component has been removed.


Geophysics ◽  
2013 ◽  
Vol 78 (4) ◽  
pp. D209-D222 ◽  
Author(s):  
David Pardo ◽  
Carlos Torres-Verdín

We numerically evaluate the possibility of using borehole electromagnetic measurements to diagnose and quantify hydraulic fractures that have been artificially generated in a horizontal well. Hydrofractures are modeled as thin disks perpendicular to the well and filled with either sand-based or electrically conductive proppant. The study focuses on the effect of thickness and length (radius) of hydrofractures to assess their effects on specific configurations of borehole-resistivity instruments. Numerical results indicate that several measurements (e.g., those obtained with low- and high-frequency solenoids) could be used to assess the thickness of a fracture. However, only low-frequency measurements performed with electrodes and large-spacing between transmitter and receivers (18 m) exhibit the necessary sensitivity to reliably and accurately estimate the length of long hydrofractures (up to 150 m) in open-hole wells. In the case of steel-cased wells, the casing acts as a long electrode, whereby conventional low-frequency short-spaced, through-casing measurements are suitable for the accurate diagnosis of long hydrofractures (up to 150 m in length).


Geophysics ◽  
2001 ◽  
Vol 66 (4) ◽  
pp. 1067-1081 ◽  
Author(s):  
M. A. Pérez‐Flores ◽  
S. Méndez‐Delgado ◽  
E. Gómez‐Treviño

We consider that all types of electromagnetic measurements represent weighted averages of the subsurface electrical conductivity distribution, and that to each type of measurement there corresponds a different weighting function. We use this concept for the quantitative interpretation of dc resistivity, magnetometric resistivity, and low‐frequency electric and magnetic measurements at low induction numbers. In all three cases the corresponding inverse problems are nonlinear because the weighting functions depend on the unknown conductivity distribution. We use linear approximations that adapt to the data and do not require reference resistivity values. The problem is formulated numerically as a solution of a system of linear equations. The unknown conductivity values are obtained by minimizing an objective function that includes the quadratic norm of the residuals as well as the spatial derivatives of the unknowns. We also apply constraints through the use of quadratic programming. The final product is the flattest model that is compatible with the data under the assumption of the given weighting functions. This approximate inversion or imaging technique produces reasonably good results for low and moderate conductivity contrasts. We present the results of inverting jointly and individually different data sets using synthetic and field data.


Author(s):  
K. Hama

The lateral line organs of the sea eel consist of canal and pit organs which are different in function. The former is a low frequency vibration detector whereas the latter functions as an ion receptor as well as a mechano receptor.The fine structure of the sensory epithelia of both organs were studied by means of ordinary transmission electron microscope, high voltage electron microscope and of surface scanning electron microscope.The sensory cells of the canal organ are polarized in front-caudal direction and those of the pit organ are polarized in dorso-ventral direction. The sensory epithelia of both organs have thinner surface coats compared to the surrounding ordinary epithelial cells, which have very thick fuzzy coatings on the apical surface.


Sign in / Sign up

Export Citation Format

Share Document