Macrokinetics of thermal and thermooxidative destruction of organic-reinforced plastic on heating in a gas flow

1994 ◽  
Vol 30 (3) ◽  
pp. 311-315
Author(s):  
G. N. Isakov
Keyword(s):  
Gas Flow ◽  
Thermooxidative Destruction ◽  
Reinforced Plastic

scholarly journals Physio-Chemical and Thermo-Gravimetric Analysis of Prosopis Juliflora and Fibre-Reinforced Plastic for Gasification Process

2019 ◽  
Vol 8 (2) ◽  
pp. 4232-4238
Keyword(s):  
Gas Flow ◽  
Thermo Gravimetric Analysis ◽  
Chemical Conversion ◽  
Prosopis Juliflora ◽  
Nitrogen Atmosphere ◽  
Gravimetric Analysis ◽  
Waste Biomass ◽  
Heating Rates ◽  
Thermo Gravimetric ◽  
Reinforced Plastic

Significance of developing energy from waste biomass has grown extremely high in recent decades. Prosopis Juliflora (PJ - Organic) is a waste plant which was grown in agricultural landfills and Fibre-reinforced plastic (FRP - Inorganic) is procured from composite industry waste are collected for this work, which is abundant in quantity. Gasification are the adequate method for harvesting energy efficiently from organic and inorganic biomass. The objective of this research was to conclude the proximate and ultimate analysis of Prosopis Juliflora and Fibre-reinforced plastic to study the potential for thermo-chemical conversion process. Thermo-gravimetric analysis were observed at heating rates of 20, 30 and 40 ºC/min in inert (nitrogen) atmosphere with gas flow protection rate of 40 ml/min was analyzed for PJ, FRP and PJ+FRP (50:50). Index Terms:

TEM evaluation of graded SixGe1-x heterolayers

1991 ◽  
Vol 49 ◽  
pp. 894-895
Author(s):  
N. David Theodore ◽  
Mamoru Tomozane ◽  
Ming Liaw
Keyword(s):  
Heterojunction Bipolar Transistors ◽  
Gas Flow ◽  
Field Effect Transistors ◽  
Chemical Vapor ◽  
Dark Field ◽  
Bipolar Transistors ◽  
Structural Quality ◽  
Weak Beam ◽  
Transmission Electron ◽  
And Behavior

There is extensive interest in SiGe for use in heterojunction bipolar transistors. SiGe/Si superlattices are also of interest because of their potential for use in infrared detectors and field-effect transistors. The processing required for these materials is quite compatible with existing silicon technology. However, before SiGe can be used extensively for devices, there is a need to understand and then control the origin and behavior of defects in the materials. The present study was aimed at investigating the structural quality of, and the behavior of defects in, graded SiGe layers grown by chemical vapor deposition (CVD).The structures investigated in this study consisted of Si1-xGex[x=0.16]/Si1-xGex[x= 0.14, 0.13, 0.12, 0.10, 0.09, 0.07, 0.05, 0.04, 0.005, 0]/epi-Si/substrate heterolayers grown by CVD. The Si1-xGex layers were isochronally grown [t = 0.4 minutes per layer], with gas-flow rates being adjusted to control composition. Cross-section TEM specimens were prepared in the 110 geometry. These were then analyzed using two-beam bright-field, dark-field and weak-beam images. A JEOL JEM 200CX transmission electron microscope was used, operating at 200 kV.

Electron Microscopy/Diffraction Study of the Ternary Mn-Er-S System

1990 ◽  
Vol 48 (1) ◽  
pp. 76-77
Author(s):  
A. R. Landa Canovas ◽  
L.C. Otero Diaz ◽  
T. White ◽  
B.G. Hyde
Keyword(s):  
Electron Microscopy ◽  
Gas Flow ◽  
Graphite Crucible ◽  
Nominal Composition ◽  
X Ray Diffraction ◽  
Alumina Crucible ◽  
X Ray ◽  
Intermediate Phases ◽  
Twin Band ◽  
Ar Gas

X-Ray diffraction revealed two intermediate phases in the system MnS+Er2S3,:MnEr2S4= MnS.Er2S3, and MnEr4S7= MnS.2Er2S3. Their structures may be described as NaCl type, chemically twinned at the unit cell level, and isostructural with CaTi2O4, and Y5S7 respectively; i.e. {l13} NaCl twin band widths are (4,4) and (4,3).The present study was to search for structurally-related (twinned B.) structures and or possible disorder, using the more sensitive and appropiate technigue of electron microscopy/diffraction.A sample with nominal composition MnEr2S4 was made by heating Mn3O4 and Er2O3 in a graphite crucible and a 5% H2S in Ar gas flow at 1500°C for 4 hours. A small amount of this material was thenannealed, in an alumina crucible, contained in sealed evacuated silica tube, for 24 days at 1100°C. Both samples were studied by X-ray powder diffraction, and in JEOL 2000 FX and 4000 EX microscopes.

SCIENTIFIC AND ENGINEERING PRINCIPLES OF EFFICIENT FUEL USE AND ENVIRONMENTALLY FRIENDLY GAS COMBUSTION IN STOVE PLATES. PART 1. MODERN STATE-OF-THE-ART AND DIRECTIONS FOR IMPROVEMENT THE GAS BURNING IN DOMESTIC GAS COOKERS

2017 ◽  
pp. 3-18 ◽  
Author(s):  
B.S. Soroka ◽  
V.V. Horupa
Keyword(s):  
Natural Gas ◽  
Flow Rate ◽  
Gas Flow ◽  
Renewable Energy Sources ◽  
Combustion Process ◽  
Orifice Diameter ◽  
Firing Process ◽  
Gas Flow Rate ◽  
Gas Combustion ◽  
Gas Stoves

Natural gas NG consumption in industry and energy of Ukraine, in recent years falls down as a result of the crisis in the country’s economy, to a certain extent due to the introduction of renewable energy sources along with alternative technologies, while in the utility sector the consumption of fuel gas flow rate enhancing because of an increase the number of consumers. The natural gas is mostly using by domestic purpose for heating of premises and for cooking. These items of the gas utilization in Ukraine are already exceeding the NG consumption in industry. Cooking is proceeding directly in the living quarters, those usually do not meet the requirements of the Ukrainian norms DBN for the ventilation procedures. NG use in household gas stoves is of great importance from the standpoint of controlling the emissions of harmful components of combustion products along with maintenance the satisfactory energy efficiency characteristics of NG using. The main environment pollutants when burning the natural gas in gas stoves are including the nitrogen oxides NOx (to a greater extent — highly toxic NO2 component), carbon oxide CO, formaldehyde CH2O as well as hydrocarbons (unburned UHC and polyaromatic PAH). An overview of environmental documents to control CO and NOx emissions in comparison with the proper norms by USA, EU, Russian Federation, Australia and China, has been completed. The modern designs of the burners for gas stoves are considered along with defining the main characteristics: heat power, the natural gas flow rate, diameter of gas orifice, diameter and spacing the firing openings and other parameters. The modern physical and chemical principles of gas combustion by means of atmospheric ejection burners of gas cookers have been analyzed from the standpoints of combustion process stabilization and of ensuring the stability of flares. Among the factors of the firing process destabilization within the framework of analysis above mentioned, the following forms of unstable combustion/flame unstabilities have been considered: flashback, blow out or flame lifting, and the appearance of flame yellow tips. Bibl. 37, Fig. 11, Tab. 7.

Effect of N2 and O2 Additions to CO2 on Extinction Limitation of Axial Gas Flow Arc

2013 ◽  
Vol 133 (11) ◽  
pp. 858-866 ◽  
Author(s):  
Yasunobu Yokomizu ◽  
Yasuhiro Hayashi ◽  
Toshiro Matsumura ◽  
Amane Majima ◽  
Toshiyuki Uchii ◽  
...  
Keyword(s):  
Gas Flow
Sign in / Sign up

Export Citation Format

Share Document