Principles of obtaining lube oil components with a narrowed fractional composition from West Siberian crude

1990 ◽  
Vol 26 (2) ◽  
pp. 77-80
Author(s):  
I. O. Kolesnik ◽  
N. A. Rogova ◽  
V. P. Paron'kin ◽  
G. A. Pushkareva
Keyword(s):  
Fractional Composition ◽  
West Siberian Crude ◽  
Oil Components

STUDY OF OIL FRACTIONAL COMPOSITION

2020 ◽  
Vol 5 (3) ◽  
pp. 26-31
Author(s):  
Saodat Sharipova ◽  
◽  
Kakhramon Majidov
Keyword(s):  
Boiling Point ◽  
Fractional Composition ◽  
Raw Materials ◽  
Oil Components

The work is devoted to studying fractional composition of oil. Fractional composition of oil. Determined by distillation of raw materials in different temperature regimes.The unit is offered to study the fractional composition of oil. It is shown that, in the process of distillation at a gradually flowing temperature oil components are distilled in the order of increasing their boiling point.

The research of stimulatory effect of zeolite on destruction of oil components in soil

2017 ◽  
pp. 104-107
Author(s):  
T.P. Alekseeva ◽  
◽  
T.I. Burmistrova ◽  
L.N. Sysoeva ◽  
N.M. Trunova ◽  
...  
Keyword(s):  
Oil Components

Influence of planting material size on Jerusalem artichoke yield during autumn planting

2020 ◽  
Author(s):  
L.D. Popova ◽  
◽  
I.N. Yudina
Keyword(s):  
Fractional Composition ◽  
Sandy Loam ◽  
Jerusalem Artichoke ◽  
Planting Material ◽  
The Cost

The results of the influence of the mass of planting tubers of Jerusalem artichoke on the size and fractional composition of the crop of tubers in the conditions of sod-podzolic sandy loam soils during autumn planting of tubers are presented. It was found that planting tubers weighing 80-100 g g provide a yield of 45 t/ha. With an increase in the mass of planting tubers, the cost of purchasing planting material increases sharply and profitability decreases. Planting small tubers leads to a decrease in yield.

Study of the fractional composition of granulate influence on the performance indicators of tablets based on salmonellosis bacteriophag

2020 ◽  
pp. 74-77
Keyword(s):  
Performance Indicators ◽  
Fractional Composition ◽  
Pressing Pressure ◽  
Technological Properties ◽  
Compression Pressure ◽  
Plastic Properties ◽  
Technological Factors ◽  
Density Flow ◽  
Crush Strength ◽  
Quality Indexes

The author presented experimental data on the influence of technological factors on the quality indexes of tablets based on a cryoliofilized salmonella bacteriophage. The analysis of the technological properties of model granules with such parameters as bulk density, flow ability, vibration compacting index, Hausner index, Сarr's index showed that the fractional composition of the granules should contain no more than 33 % of the pulverized fraction (0,25 mm or less). The granulate, regardless of its fractional composition, has elastic-plastic properties characterizing the strength of the tablets. The influence of the pressing pressure of the cryoliofilized composition tablets with salmonella bacteriophage on the crush strength and disintegration of enteric-soluble tablets was studied. The optimum compression pressure of tablets within 60 mPa of granules with a content of pulp fraction (0.25 mm or less) is not to be higher than 33 %.

Anti-Neuropathic Pain Activity of Ageratum conyzoides L due to The Essential Oil Components

2020 ◽  
Vol 19 ◽  
Author(s):  
Yedy Purwandi Sukmawan ◽  
Kusnandar Anggadiredja ◽  
I Ketut Adnyana
Keyword(s):  
Neuropathic Pain ◽  
Essential Oil ◽  
Opioid Receptor ◽  
Steam Distillation ◽  
Chronic Constriction Injury ◽  
Thermal Hyperalgesia ◽  
Ageratum Conyzoides ◽  
Safety And Efficacy ◽  
Activity Test ◽  
Oil Components

Background: Neuropathic pain is one of the contributors to the global burdens of illness. At present many patients do not achieve satisfactory pain relief even with synthetic pain-killers. Taking this into consideration, it is necessary to search for natural product-derived alternative treatment with confirmed safety and efficacy. Ageratum conyzoides L is a plant often used as analgesic in Indonesia, however, anti-neuropathic pain activity of this plant is still unknown. Objective: To determine the anti-neuropathic pain activity of the essential oil and non-essential oil component (distillation residue) of A. conyzoides L. Methods: We conducted separation of the essential oil component from other secondary metabolites through steam distillation. Both components were tested for anti-neuropathic pain activity using chronic constriction injury animal models with thermal hyperalgesia and allodynia tests. The animals were divided into 7 test groups namely normal, sham, negative, positive (pregabalin at 0.195 mg/20 g BW of mice), essential oil component (100 mg/kg BW), and non-essential oil component (100 mg/kg BW). Naloxone was tested against the most potent anti-neuropathic pain component (essential oil or nonessential oil) to investigate the involvement of opioid receptor. Results: The GC-MS of the essential oil component indicated the presence of 60 compounds. Meanwhile, non-essential oil components contained alkaloid, flavonoid, polyphenol, quinone, steroid, and triterpenoid. This non-essential oil component contained a total flavonoid equivalent to 248.89 ppm quercetin. The anti-neuropathic pain activity test showed significantly higher activity of the essential oil component compared to the non-essential oil component and negative groups (p<0.05). Furthermore, the essential oil component showed equal activity to pregabalin (p>0.05). However, this activity was abolished by naloxone, indicating the involvement of opioid receptor in the action of the essential oil component. Conclusion: The essential oil component of A. conyzoides L is a potential novel substance for use as anti-neuropathic pain.

Combined application of phenolic acids and essential oil components against Salmonella Enteritidis and Listeria monocytogenes in vitro and in ready-to-eat cooked ham

LWT ◽  
2021 ◽  
pp. 111881
Author(s):  
Jessica Audrey Feijó Corrêa ◽  
João Vitor Garcia dos Santos ◽  
Alberto Gonçalves Evangelista ◽  
Anne Caroline Schoch Marques Pinto ◽  
Renata Ernlund Freitas de Macedo ◽  
...  
Keyword(s):  
Listeria Monocytogenes ◽  
Essential Oil ◽  
Phenolic Acids ◽  
Salmonella Enteritidis ◽  
Combined Application ◽  
Cooked Ham ◽  
Oil Components

scholarly journals The use of light fractional composition fuels in the electric flame jet of a diesel engine

2021 ◽  
Vol 1901 (1) ◽  
pp. 012090
Author(s):  
V N Kaminsky ◽  
A V Kostyukov ◽  
A V Kolunin ◽  
I V Materi
Keyword(s):  
Diesel Engine ◽  
Fractional Composition

Analysis of Fractional Composition and Specific Surface of Silicone Dioxide Nanopowders

2020 ◽  
Vol 992 ◽  
pp. 551-555
Author(s):  
O.N. Kravtsova ◽  
G.G. Vinokurov ◽  
N.F. Struchkov
Keyword(s):  
Specific Surface ◽  
Surface Area ◽  
Specific Surface Area ◽  
Fractional Composition ◽  
Nanosized Powder ◽  
Nanosized Powders ◽  
Powder Mixtures ◽  
Angle Scattering ◽  
Intermediate Value ◽  
Particle Shapes

For the development of new compositions of modified powder mixtures a comprehensive analysis of the technical characteristics of powder additives is required. The specific surfaces of nanosized powders of "Tarkosil" silicone dioxide were determined by the experimental method. Therefore, at present, the estimating relationships of sizes, particles shapes and specific surface area of nanosized powder is relevant scientific and practical task. And the particles shape was evaluated by the values of these surfaces. Using the method of small-angle scattering the functions of distribution of the modifying powders particles on their sizes were estimated, and the average values of particles size of "Tarkosil" powder were specified The particle shape of the modifying powders has been estimated according to the specific surface values. The particle shapes of T50 powders are close to isometric (a ball, a cube); particle shapes of T150 powders correspond to a tetrahedron, the particle size T80 and T110 corresponds to the intermediate value of the specific surface area.

scholarly journals Disintegration process in disc crushers

2013 ◽  
Vol 59 (No. 3) ◽  
pp. 98-104 ◽  
Author(s):  
P. Vaculík ◽  
J. Maloun ◽  
L. Chládek ◽  
M. Přikryl
Keyword(s):  
Food Industry ◽  
Fractional Composition ◽  
Animal Feed ◽  
Raw Materials ◽  
Specific Energy Consumption ◽  
Low Noise ◽  
Main Process ◽  
Industrial Sectors ◽  
The Subject

Grinding or crushing hard raw materials is usually a primary operation which precedes the follow-up technological processes in a number of industrial sectors. A great variety of machines using different principles of fragmentation are employed in the technology of pulverization. The food industry uses roller mills, in which the main process is the shear grinding. In the animal feed industry impact machines known as hammer mills are often used. In recent years, mills have been employed that use their frontal edges for grinding or crushing during the rotation of one of two adjacent discs. The modern design disc machines used for grinding grain have resulted from long development and their operation has a relatively low noise level with reduced dust. The separation process that occurs in the gap between the active edges of the discs can be described as shear grinding and is currently the subject of attention which is focused on the specific energy consumption and fractional composition of the product of grinding. &nbsp;

Sign in / Sign up

Export Citation Format

Share Document