Investigation of the kinetics of deformation of previously loaded steel Kh18N10T strained in tension at elevated temperatures

1974 ◽  
Vol 8 (1) ◽  
pp. 1-4 ◽  
Author(s):  
F. P. Yanchishin ◽  
V. S. Baranetskii ◽  
G. G. Maksimovich
Keyword(s):  
Elevated Temperatures ◽  
Steel Kh18n10t ◽  
Kinetics Of

On the use of Ozawa/Flynn/Wall method to determine aging activation energy for elastomers

2021 ◽  
pp. 009524432110203
Author(s):  
Sudhir Bafna
Keyword(s):  
Mechanical Properties ◽  
Activation Energy ◽  
Weight Loss ◽  
Oxygen Consumption ◽  
Dwell Time ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Degradation Mechanism ◽  
Kinetics Of ◽  
Wall Method

It is often necessary to assess the effect of aging at room temperature over years/decades for hardware containing elastomeric components such as oring seals or shock isolators. In order to determine this effect, accelerated oven aging at elevated temperatures is pursued. When doing so, it is vital that the degradation mechanism still be representative of that prevalent at room temperature. This places an upper limit on the elevated oven temperature, which in turn, increases the dwell time in the oven. As a result, the oven dwell time can run into months, if not years, something that is not realistically feasible due to resource/schedule constraints in industry. Measuring activation energy (Ea) of elastomer aging by test methods such as tensile strength or elongation, compression set, modulus, oxygen consumption, etc. is expensive and time consuming. Use of kinetics of weight loss by ThermoGravimetric Analysis (TGA) using the Ozawa/Flynn/Wall method per ASTM E1641 is an attractive option (especially due to the availability of commercial instrumentation with software to make the required measurements and calculations) and is widely used. There is no fundamental scientific reason why the kinetics of weight loss at elevated temperatures should correlate to the kinetics of loss of mechanical properties over years/decades at room temperature. Ea obtained by high temperature weight loss is almost always significantly higher than that obtained by measurements of mechanical properties or oxygen consumption over extended periods at much lower temperatures. In this paper, data on five different elastomer types (butyl, nitrile, EPDM, polychloroprene and fluorocarbon) are presented to prove that point. Thus, use of Ea determined by weight loss by TGA tends to give unrealistically high values, which in turn, will lead to incorrectly high predictions of storage life at room temperature.

scholarly journals Influence of Heterointerfaces on the Kinetics of Oxygen Surface Exchange on Epitaxial La1.85Sr0.15CuO4 Thin Films

2021 ◽  
Vol 11 (9) ◽  
pp. 3778
Author(s):  
Gene Yang ◽  
So-Yeun Kim ◽  
Changhee Sohn ◽  
Jong K. Keum ◽  
Dongkyu Lee
Keyword(s):  
Thin Films ◽  
Oxygen Vacancies ◽  
Elevated Temperatures ◽  
Surface Exchange ◽  
Electrical Conductivity Relaxation ◽  
Exchange Kinetics ◽  
Relaxation Curves ◽  
Kinetics Of ◽  
Oxygen Surface Exchange ◽  
Oxygen Surface

Considerable attention has been directed to understanding the influence of heterointerfaces between Ruddlesden–Popper (RP) phases and ABO3 perovskites on the kinetics of oxygen electrocatalysis at elevated temperatures. Here, we report the effect of heterointerfaces on the oxygen surface exchange kinetics by employing heteroepitaxial oxide thin films formed by decorating LaNiO3 (LNO) on La1.85Sr0.15CuO4 (LSCO) thin films. Regardless of LNO decoration, tensile in-plane strain on LSCO films does not change. The oxygen surface exchange coefficients (kchem) of LSCO films extracted from electrical conductivity relaxation curves significantly increase with partial decorations of LNO, whereas full LNO coverage leads to the reduction in the kchem of LSCO films. The activation energy for oxygen exchange in LSCO films significantly decreases with partial LNO decorations in contrast with the full coverage of LNO. Optical spectroscopy reveals the increased oxygen vacancies in the partially covered LSCO films relative to the undecorated LSCO film. We attribute the enhanced oxygen surface exchange kinetics of LSCO to the increased oxygen vacancies by creating the heterointerface between LSCO and LNO.

Thermal Breakdown Kinetics of 1-Ethyl-3-Methylimidazolium Ethylsulfate Measured Using Quantitative Infrared Spectroscopy

2017 ◽  
Vol 71 (12) ◽  
pp. 2626-2631 ◽  
Author(s):  
Jeffrey L. Wheeler ◽  
McKinley Pugh ◽  
S. Jake Atkins ◽  
Jason M. Porter
Keyword(s):  
Thermal Stability ◽  
Room Temperature ◽  
Computational Models ◽  
Elevated Temperatures ◽  
Molar Absorptivity ◽  
Ir Absorption ◽  
Optical Cell ◽  
Multiple Samples ◽  
Kinetics Of ◽  
Thermal Stability Of

In this work, the thermal stability of the room temperature ionic liquid (RTIL) 1-ethyl-3-methylimidazolium ethylsulfate ([EMIM][EtSO4]) is investigated using infrared (IR) spectroscopy. Quantitative IR absorption spectral data are measured for heated [EMIM][EtSO4]. Spectra have been collected between 25 ℃ and 100 ℃ using a heated optical cell. Multiple samples and cell pathlengths are used to determine quantitative values for the molar absorptivity of [EMIM][EtSO4]. These results are compared to previous computational models of the ion pair. These quantitative spectra are used to measure the rate of thermal decomposition of [EMIM][EtSO4] at elevated temperatures. The spectroscopic measurements of the rate of decomposition show that thermogravimetric methods overestimate the thermal stability of [EMIM][EtSO4].

Metastable Variations of the Fill Factor in CIGS Thin Film Solar Cells

2009 ◽  
Vol 1165 ◽  
Author(s):  
Aleksander Urbaniak ◽  
Małgorzata Igalson
Keyword(s):  
Fill Factor ◽  
Elevated Temperatures ◽  
Reverse Voltage ◽  
Cell Behaviors ◽  
Cigs Thin Film ◽  
Current Voltage ◽  
Shallow Acceptors ◽  
Current Voltage Characteristics ◽  
Diode Behavior ◽  
Kinetics Of

AbstractWe investigate the origin of fill factor changes induced by reverse bias treatment. Evolution of current-voltage characteristics have been measured during application of reverse voltage bias. Two different cell behaviors have been identified. At elevated temperatures one kind of the devices strongly deteriorates and exhibit so called double diode behavior. On the other hand, in the same conditions another cells keep their fill factor almost constant. We correlate the fill factor changes with the kinetics of capacitance and show that although increased number of shallow acceptors itself cannot induce this severe FF deterioration, it may strongly influence position of the Fermi level at the heterointerface that in a presence of an electron barrier is crucial for the device behavior.

Equilibration kinetics of TiO2 single crystal at elevated temperatures

2005 ◽  
Vol 242 (11) ◽  
pp. R91-R93 ◽  
Author(s):  
J. Nowotny ◽  
T. Bak ◽  
M. K. Nowotny ◽  
C. C. Sorrell
Keyword(s):  
Single Crystal ◽  
Elevated Temperatures ◽  
Kinetics Of

KINETICS OF THE AQUEOUS ALKALINE HOMOGENOUS HYDROLYSIS OF HIGH EXPLOSIVE 1, 3,5,7-TETRAAZA- 1, 3,5,7-TETRANITROCYCLOOCTANE (HMX)

1994 ◽  
Vol 30 (3) ◽  
pp. 53-61 ◽  
Author(s):  
Harro M. Heilmann ◽  
Michael K. Stenstrom ◽  
Rolf P. X. Hesselmann ◽  
Udo Wiesmann
Keyword(s):  
Temperature Dependence ◽  
Alkaline Hydrolysis ◽  
Rate Constants ◽  
Elevated Temperatures ◽  
Second Order ◽  
Order Rate ◽  
Subsequent Calculation ◽  
Kinetics Of ◽  
Hydrolysis Of ◽  
Order Rate Equation

In order to get basic data for the design of a novel treatment scheme for high explosives we investigated the kinetics for the aqueous alkaline hydrolysis of 1,3,5,7-tetraaza-1,3,5,7-tetranitrocyclooctane (HMX) and the temperature dependence of the rate constants. We used an HPLC procedure for the analysis of HMX. All experimental data could be fit accurately to a pseudo first-order rate equation and subsequent calculation of second-order rate constants was also precise. Temperature dependence could be modeled with the Arrhenius equation. An increase of 10°C led to an average increase in the second-order rate constants by the 3.16 fold. The activation energy of the second-order reaction was determined to be 111.9 ±0.76 kJ·moJ‒1. We found the alkaline hydrolysis to be rapid (less than 2.5% of the initial HMX-concentration left after 100 minutes) at base concentrations of 23 mmol oH‒/L and elevated temperatures between 60 and 80°C.

Sign in / Sign up

Export Citation Format

Share Document