Distribution of stresses in the edge zones of a glass ribbon in the debiteuse-free method of glass drawing

1972 ◽  
Vol 29 (6) ◽  
pp. 369-371
Author(s):  
V. A. Pronin ◽  
L. V. Barinova ◽  
V. I. Bogacheva
Keyword(s):  
Glass Ribbon ◽  
Glass Drawing ◽  
Distribution Of Stresses

Experimental accelerated heat-treatment line for a continuous glass ribbon

1973 ◽  
Vol 30 (6) ◽  
pp. 370-372
Author(s):  
N. N. Troshin ◽  
A. S. Makhnavetskii ◽  
V. A. Losev
Keyword(s):  
Heat Treatment ◽  
Glass Ribbon ◽  
Continuous Glass ◽  
Treatment Line

Coupling Loss, Interstrand Contact Resistance, and Magnetization of Nb$_{3}$Sn Rutherford Cables With Cores of MgO Tape and S-Glass Ribbon

2011 ◽  
Vol 21 (3) ◽  
pp. 2367-2371 ◽  
Author(s):  
E. W. Collings ◽  
M. D. Sumption ◽  
M. A. Susner ◽  
D. R. Dietderich ◽  
A. Nijhuis
Keyword(s):  
Contact Resistance ◽  
Glass Ribbon ◽  
Coupling Loss

Distribution of stresses beneath a drive pneumatic tire and prediction of its tractive performance on sand

1985 ◽  
Vol 22 (3) ◽  
pp. 182
Author(s):  
Li Yin ◽  
Wang Zhi-Hao ◽  
Qiu Xi-ding ◽  
Wang Qing-nian
Keyword(s):  
Pneumatic Tire ◽  
Distribution Of Stresses

Clamped Semicircular Plate Under Uniform Bending Load

1955 ◽  
Vol 22 (1) ◽  
pp. 129
Author(s):  
S. Woinowsky-Krieger
Keyword(s):  
Exact Solution ◽  
Approximate Methods ◽  
Bending Load ◽  
Distribution Of Stresses

Abstract The semicircular plate subjected to bending usually is considered as a particular case of a sectorial plate and one introduces polar co-ordinates to discuss the deflection of the plate and the corresponding distribution of stresses. If the semicircular plate is clamped along the boundary the application of approximate methods becomes necessary to this end. It is worthy of note that a rather simple exact solution can be given in this latter case by making use of bipolar instead of polar co-ordinates.

Stress Distribution in a Uniformly Rotating Equilateral Triangular Shaft

1955 ◽  
Vol 22 (2) ◽  
pp. 255-259
Author(s):  
H. T. Johnson
Keyword(s):  
Approximate Solution ◽  
Stress Distribution ◽  
Boundary Conditions ◽  
Plane Strain ◽  
Cross Section ◽  
Plane Stress ◽  
Biharmonic Equation ◽  
Approximate Solutions ◽  
Distribution Of Stresses ◽  
General Method

Abstract An approximate solution for the distribution of stresses in a rotating prismatic shaft, of triangular cross section, is presented in this paper. A general method is employed which may be applied in obtaining approximate solutions for the stress distribution for rotating prismatic shapes, for the cases of either generalized plane stress or plane strain. Polynomials are used which exactly satisfy the biharmonic equation and the symmetry conditions, and which approximately satisfy the boundary conditions.

Sign in / Sign up

Export Citation Format

Share Document