Time-temperature to strength relationship of viscose cord fibres

1971 ◽  
Vol 1 (5) ◽  
pp. 554-556
Author(s):  
V. O. Gorbacheva ◽  
A. K. Ievleva ◽  
V. A. Platonov ◽  
E. V. Churikov
Keyword(s):  
Viscose Cord ◽  
Relationship Of ◽  
Strength Relationship

Time ? Strength relationship of polycrystalline zinc in the presence of mercury

1973 ◽  
Vol 7 (3) ◽  
pp. 327-330
Author(s):  
N. I. Ivanova ◽  
N. V. Pertsov ◽  
Yu. V. Goryunov ◽  
E. D. Shchukin
Keyword(s):  
Polycrystalline Zinc ◽  
Time Strength ◽  
Relationship Of ◽  
Strength Relationship

Study on phase behavior–impact strength relationship of unsaturated polyester/polyurethane hybrid polymer network

1995 ◽  
Vol 38 (2) ◽  
pp. 205-209 ◽  
Author(s):  
Mei Xuan Xu ◽  
Wen Guang Liu ◽  
Yun Lin Guan ◽  
Zuo Peng Bi ◽  
Kang De Yao
Keyword(s):  
Impact Strength ◽  
Phase Behavior ◽  
Unsaturated Polyester ◽  
Polymer Network ◽  
Hybrid Polymer ◽  
Relationship Of ◽  
Strength Relationship

scholarly journals A Study to Establish Correlation Between Rebound Value and Compressive Strength of Concrete Using Materials Available Locally in Nagpur

2021 ◽  
Vol 9 (10) ◽  
pp. 1-6
Author(s):  
Aman Raj ◽  
Pramod Deshmukh ◽  
Pradeepa. S
Keyword(s):  
Compressive Strength ◽  
Standard Deviation ◽  
Mix Design ◽  
Deviation Factor ◽  
Compressive Strength Of Concrete ◽  
Increased Strength ◽  
Relationship Of ◽  
Strength Relationship

This study has been taken to investigate the exact rebound-strength relationship of different grades of concrete, as the curves generated for traditional hammers are outdated. Using the material available in the Nagpur region, cube specimens were cast and tested as per IS:516-1959 [1]. Several sets were cast with varying cement contents, decided by mix design, to give a strength range of 10 to 50 Mpa. However, for this study, the Target Mean Strength Standard Deviation factor is not considered. We tested these sets for compressive strengths; each specimen was checked for rebound value for compressive Strength, each specimen was checked for rebound value on four faces. Thus, for each specimen, data for rebound value and Compressive Strength is available. Using this data, a curve for Compressive Strength and rebound value was plotted. The curve generated indicated that the strengths obtained for the same rebound value are higher than that using the traditional curve. There is an increase of about 47% up to a strength of 21 Mpa. From 21 to 38 Mpa, this increase is almost constant to about 30%. From this point forward, the rate of increased Strength reduces by 25% and 14% at 40 Mpa and 45 Mpa, respectively.

Sign in / Sign up

Export Citation Format

Share Document