The behaviour of poly(2-ethylhexyl acrylate) in dilute solution: viscosity measurements

1993 ◽  
Vol 30 (6) ◽  
pp. 713-718 ◽  
Author(s):  
E. Lathov� ◽  
D. Lath ◽  
J. Pavlinec
Keyword(s):  
Solution Viscosity ◽  
Dilute Solution ◽  
Viscosity Measurements

Structure and Solution Properties of High Molecular Weight Butadiene-Styrene Copolymers

1957 ◽  
Vol 30 (1) ◽  
pp. 315-325
Author(s):  
R. B. MacFarlane ◽  
L. A. McLeod
Keyword(s):  
Molecular Weight ◽  
High Molecular Weight ◽  
Complex Structure ◽  
Mixed Solvents ◽  
Solution Time ◽  
Solution Viscosity ◽  
Solution Properties ◽  
Molecular Weight Range ◽  
Viscosity Measurements ◽  
Commercial Practice

Abstract Production of high molecular weight copolymers of butadiene and styrene for use in oil-extended rubbers has aroused interest in the solution properties of copolymers above the molecular weight range commonly encountered in commercial practice. It has been observed that solubility of such polymers in toluene is a time-dependent phenomenon and the apparent solubility can increase continuously, in the absence of agitation, for as long as 800 hours. Although a standard Harris cage solubility test may show the presence of 50% gel, other properties do not confirm the presence of any appreciable quantities of insoluble material. Mild agitation rapidly promotes almost complete solubility. Dilute solution viscosity measurements are very misleading unless the influence of solution time is recognized and apparent intrinsic viscosities rise progressively with time of contact of the sample with solvent. This time-dependence of solution has been found to occur at conversions higher than 50% and is also a function of the amount of modifier used in the polymerization recipe. It has not been possible to shorten the solution time for viscosity measurements by mild heating or gentle agitation. Mixed solvents cause a change in the amount of increase of the apparent intrinsic viscosity but do not shorten the time to equilibrium. Measurement of the slope constant in the Huggins viscosity equation indicate that these solubility and viscosity effects coincide with the appearance of a marked degree of branching in the polymer molecules. The effect is, therefore, interpreted as being caused by the relatively slow disentanglement of molecules of complex structure.

PROTON MAGNETIC RESONANCE LINE WIDTH AS A FUNCTION OF POLYMER TACTICITY

1966 ◽  
Vol 44 (2) ◽  
pp. 153-156 ◽  
Author(s):  
S. Brownstein ◽  
D. M. Wiles
Keyword(s):  
Magnetic Resonance ◽  
Methyl Methacrylate ◽  
Proton Magnetic Resonance ◽  
Chloroform Solution ◽  
Spin Coupling ◽  
Solution Viscosity ◽  
Dilute Solution ◽  
Poly Methyl Methacrylate ◽  
Resonance Line Width ◽  
Polymer Tacticity

The high resolution proton magnetic resonance spectra of five samples of poly(methyl methacrylate) in chloroform solution have been measured with 100 Mc/s equipment. The widths of the absorption lines arising from the protons of the α-methyl and the methoxyl groups have been compared. The widths are greater when the polymer is predominantly syndiotactic than when it is predominantly isotactic. It is concluded that isotactic samples have the more extended conformation in chloroform solution. An analogy with dilute solution viscosity measurements is outlined in support of this conclusion. Differences between the widths of the lines of the methylene protons in a completely isotactic poly(methyl methacrylate) sample are attributed to long range spin coupling.

Conformational characteristics of p-o-aromatic polyester molecules from flow birefringence, diffusion, and solution viscosity measurements

1988 ◽  
Vol 30 (6) ◽  
pp. 1322-1329 ◽  
Author(s):  
V.N. Tsvetkov ◽  
L.N. Andreyeva ◽  
P.N. Lavrenko ◽  
O.V. Okatova ◽  
Ye.V. Belyayeva ◽  
...  
Keyword(s):  
Flow Birefringence ◽  
Solution Viscosity ◽  
Viscosity Measurements ◽  
Aromatic Polyester

THE VISCOSITY – MOLECULAR WEIGHT RELATION FOR POLY-levo-2,3-BUTANEDIYL o-PHTHALATE

1948 ◽  
Vol 26b (12) ◽  
pp. 783-797
Author(s):  
R. W. Watson ◽  
N. H. Grace
Keyword(s):  
Molecular Weight ◽  
High Purity ◽  
Molecular Orientation ◽  
Degree Of Polymerization ◽  
Solution Viscosity ◽  
Dilute Solution ◽  
Molecular Weights ◽  
Complex Relation ◽  
End Group ◽  
Long Chain

The inherent viscosities of dilute solutions of acidic polyesters of high purity have been compared with number average molecular weights accurately determined by end-group titration. For unfractionated resins with a degree of polymerization from 2 to 11 [Formula: see text] the viscosity – molecular weight relation is linear in chloroform at 25 °C. Where [Formula: see text], K = 1.923 × 10−5 and β = 0.0176. For fractionated polyesters from DP 5 to 8, K = 1.959 × 10−6 and β = 0.0161. For unfractionated resins with a DP > 11, molecular weights increase more rapidly than inherent viscosities. Above [Formula: see text] for fractionated resins linearity is resumed, and the slope increases. Several attempts have been made to explain this complex relation. Apparently the short chains remain linear, and the formation of anisotropic fibers at a DP close to 100 establishes a degree of molecular orientation in the long-chain superpolyesters. Isomerization of levo-diol to the diastereoisomer during polycondensation is without effect on the dilute solution viscosity of the resulting resin. Preferential degradation of the longer chains is assumed to be partially responsible for the decreasing slope from DP 11 to 65. As yet it has not been possible to assess the roles played by changes in size distribution, and variation in solvation with increasing chain length, but the data point to a curved viscosity – molecular weight relation in chloroform at 25 °C.

Sign in / Sign up

Export Citation Format

Share Document